Searched full:arbitration (Results 1 – 25 of 40) sorted by relevance
12
| /Documentation/devicetree/bindings/memory-controllers/ |
| D | nvidia,tegra30-mc.yaml | 17 Arbitration Domains, which can handle a single request or response per
18 clock from a group of clients. Typically, a system has a single Arbitration
20 Arbitration Domains to increase the effective system bandwidth.
25 Memory Crossbar, which routes request and responses between Arbitration
27 Memory Crossbar is just a pass through between a single Arbitration Domain
|
| D | nvidia,tegra20-mc.yaml | 18 has a configurable arbitration algorithm to allow the user to fine-tune
|
| /Documentation/i2c/ |
| D | gpio-fault-injection.rst | 86 Lost arbitration
90 bus arbitration against another master in a multi-master setup.
95 This file is write only and you need to write the duration of the arbitration
99 Arbitration lost is achieved by waiting for SCL going down by the master under
103 There doesn't need to be a device at this address because arbitration lost
|
| D | fault-codes.rst | 47 Returned by I2C adapters when they lose arbitration in master
|
| /Documentation/userspace-api/media/cec/ |
| D | cec-pin-error-inj.rst | 49 # any[,<mode>] rx-arb-lost [<poll>] generate a POLL message to trigger an arbitration lost
75 # <poll> CEC poll message used to test arbitration lost (0x00-0xff, default 0x0f)
166 be interpreted as an Arbitration Lost condition by the transmitter.
180 Generate a POLL message to trigger an Arbitration Lost condition.
186 This command can be used to test the Arbitration Lost condition in
187 the remote CEC transmitter. Arbitration happens when two CEC adapters
190 stop transmitting ('Arbitration Lost'). This is very hard to test,
251 because the receiver also looks for an Arbitration Lost condition in
269 because the receiver also looks for an Arbitration Lost condition in
304 positions 0-3 the receiver can interpret this as an Arbitration Lost
|
| D | cec-ioc-receive.rst | 180 Arbitration Lost error. This is only set if the hardware supports
192 Arbitration Lost error. This is only set if the hardware supports
197 - A counter of the number of transmit errors other than Arbitration
271 - CEC line arbitration was lost, i.e. another transmit started at the
|
| /Documentation/gpu/ |
| D | vgaarbiter.rst | 13 the legacy VGA arbitration task (besides other bus management tasks) when more
18 control bus resources. Therefore an arbitration scheme outside of the X server
26 scans all PCI devices and adds the VGA ones inside the arbitration. The
124 instance, if there is only one card, then it can completely escape arbitration.
160 card can be left out of the arbitration process (and can be safe to take
|
| /Documentation/ABI/testing/ |
| D | sysfs-driver-fsi-master-gpio | 6 Controls access arbitration for GPIO-based FSI master. A
|
| D | debugfs-driver-qat | 92 After writing this file, the driver stops arbitration on a
|
| /Documentation/networking/devlink/ |
| D | devlink-port.rst | 403 arbitration scheme attempts to schedule nodes based on their priority
409 Allows for usage of Weighted Fair Queuing arbitration scheme among
410 siblings. This arbitration scheme can be used simultaneously with the
423 and arbitration among them is based on assigned weights.
425 Arbitration flow from the high level:
429 parameter for this arbitration.
431 #. If group of nodes have the same priority perform WFQ arbitration on
432 that subgroup. Use ``tx_weight`` as a parameter for this arbitration.
434 #. Select the winner node, and continue arbitration flow among its children,
|
| D | ice.rst | 411 arbitration scheme attempts to schedule nodes based on their
417 - allows for usage of Weighted Fair Queuing arbitration scheme among
418 siblings. This arbitration scheme can be used simultaneously with
420 arbitration.
424 and arbitration among them is based on assigned weights.
|
| /Documentation/devicetree/bindings/soc/tegra/ |
| D | nvidia,tegra20-ahb.yaml | 39 reg = <0x6000c004 0x10c>; /* AHB Arbitration + Gizmo Controller */
|
| /Documentation/devicetree/bindings/i2c/ |
| D | i2c-gate.yaml | 17 no arbitration happening for gates.
|
| D | nxp,pca9541.yaml | 24 I2C arbitration bus node.
|
| D | i2c-arb-gpio-challenge.yaml | 7 title: GPIO-based I2C Arbitration Using a Challenge & Response Mechanism
90 I2C arbitration bus node.
|
| D | renesas,riic.yaml | 45 - description: Arbitration-Lost Interrupt
|
| D | renesas,rmobile-iic.yaml | 107 - description: Arbitration Lost Interrupt (ALI)
|
| /Documentation/devicetree/bindings/hsi/ |
| D | client-devices.txt | 16 - hsi-arb-mode: Arbitration mode for TX frame ("round-robin", "priority")
|
| /Documentation/driver-api/gpio/ |
| D | using-gpio.rst | 48 and arbitration for multiple simultaneous consumers on the same GPIO chip.
|
| /Documentation/devicetree/bindings/bus/ |
| D | baikal,bt1-axi.yaml | 16 cores. Traffic arbitration is done by means of DW AXI Interconnect (so
|
| /Documentation/devicetree/bindings/spmi/ |
| D | qcom,spmi-pmic-arb.yaml | 14 controller with wrapping arbitration logic to allow for multiple on-chip
|
| D | qcom,x1e80100-spmi-pmic-arb.yaml | 14 controller with wrapping arbitration logic to allow for multiple on-chip
|
| /Documentation/trace/coresight/ |
| D | coresight-tpda.rst | 14 TPDA in short serves as an arbitration and packetization engine for the
|
| /Documentation/driver-api/media/drivers/ |
| D | pvrusb2.rst | 38 tear-down, arbitration, and interaction with high level
127 (Policy, instantiation, and arbitration of pvrusb2 devices fall
|
| /Documentation/scsi/ |
| D | ChangeLog.ncr53c8xx | 134 - Definitely disable overlapped PCI arbitration for all dual
217 Disable overlapped arbitration. This will not make difference
273 after arbitration while the SCSI core is performing SCSI selection).
425 having won arbitration, do some stuff prior to testing any SCSI
|
12