Searched full:automatic (Results 1 – 25 of 190) sorted by relevance
12345678
| /Documentation/sound/designs/ |
| D | powersave.rst | 5 AC97 and HD-audio drivers have the automatic power-saving mode.
9 With the automatic power-saving, the driver turns off the codec power
15 The time-out for automatic power-off can be specified via ``power_save``
17 the time-out value in seconds. 0 means to disable the automatic
27 automatic power-save mode with 10 seconds, write to
|
| /Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-camera.rst | 29 Enables automatic adjustments of the exposure time and/or iris
42 - Automatic exposure time, automatic iris aperture.
65 Determines the automatic exposure compensation, it is effective only
153 Enables continuous automatic focus adjustments. The effect of manual
163 Aborts automatic focusing started with ``V4L2_CID_AUTO_FOCUS_START``
171 The automatic focus status. This is a read-only control.
184 - Automatic focus is not active.
186 - Automatic focusing is in progress.
190 - Automatic focus has failed, the driver will not transition from
212 - Normal distance range, limited for best automatic focus
[all …]
|
| D | ext-ctrls-rf-tuner.rst | 40 automatic mode bandwidth configuration is performed by the driver.
50 Enables/disables LNA automatic gain control (AGC)
53 Enables/disables mixer automatic gain control (AGC)
56 Enables/disables IF automatic gain control (AGC)
|
| D | control.rst | 109 Automatic white balance (cameras).
135 Automatic gain/exposure control.
170 Enables automatic hue control by the device. The effect of setting
171 ``V4L2_CID_HUE`` while automatic hue control is enabled is
190 Chroma automatic gain control.
268 Enable Automatic Brightness.
|
| /Documentation/hwmon/ |
| D | adt7470.rst | 40 automatic fan pwm control to set the fan speed. The driver will not read the
51 determining an optimal configuration for the automatic PWM control.
93 order for the automatic pwm algorithm to run. This was the case for earlier
|
| D | lm63.rst | 81 PWM modes: manual and automatic. Automatic mode is not fully implemented yet
87 but will return 'old' values. Values in the automatic fan control lookup table
|
| D | dell-smm-hwmon.rst | 41 pwm1_enable WO Enable or disable automatic BIOS fan
52 Disabling automatic BIOS fan control
59 There is experimental support for disabling automatic BIOS fan
62 (writing ``2`` enables automatic BIOS control again). Even if you have
64 automatic fan control at the same time and, notwithstanding the name,
65 ``pwm1_enable`` sets automatic control for all fans.
68 enabling and disabling automatic BIOS fan control are not whitelisted
342 disabling (``0x30a3`` or ``0x34a3``) automatic fan speed control.
347 fans supports a 4th "magic" state, which signals the BIOS that automatic
391 the automatic mode settings.
|
| D | it87.rst | 340 The fan speed control features are limited to manual PWM mode. Automatic
352 Automatic fan speed control (old interface)
355 The driver supports the old interface to automatic fan speed control
369 the one of trip point N. The automatic control mode is less flexible
373 Trip points must be set properly before switching to automatic fan speed
375 actually switching to automatic control mode.
|
| D | max31785.rst | 58 2: Automatic PWM (tach-feedback RPM fan-control)
59 3: Automatic closed-loop (temp-feedback fan-control)
|
| D | emc6w201.rst | 22 "The EMC6W201 is an environmental monitoring device with automatic fan
|
| /Documentation/userspace-api/media/drivers/ |
| D | uvcvideo.rst | 297 - Setting this bit causes automatic exposure to track the region of
300 - Setting this bit causes automatic iris to track the region of interest
303 - Setting this bit causes automatic white balance to track the region
306 - Setting this bit causes automatic focus adjustment to track the region
309 - Setting this bit causes automatic face detection to track the region of
312 - Setting this bit enables automatic face detection and tracking. The
316 - Setting this bit enables automatic image stabilization. The
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | apple,aic2.yaml | 20 - Automatic masking on event delivery (auto-ack)
22 - Automatic prioritization (single event/ack register per CPU, lower IRQs =
24 - Automatic masking on ack
|
| D | apple,aic.yaml | 22 - Automatic masking on event delivery (auto-ack)
26 - Automatic prioritization (single event/ack register per CPU, lower IRQs =
28 - Automatic masking on ack
|
| /Documentation/devicetree/bindings/mfd/ |
| D | ams,as3711.yaml | 70 Second step-up converter uses automatic current feedback selection
95 Second step-up converter uses CURR1 input for automatic current
101 Second step-up converter uses CURR2 input for automatic current
107 Second step-up converter uses CURR3 input for automatic current
|
| /Documentation/userspace-api/ |
| D | sysfs-platform_profile.rst | 8 conditions by some automatic mechanism (which may very well live outside
16 API for selecting the platform profile of these automatic mechanisms.
|
| /Documentation/devicetree/bindings/sound/ |
| D | cs35l33.txt | 76 automatic updating is enabled.
84 allowed to increase to a higher voltage when using VPhg automatic
89 - cirrus,vp-hg-va : VA calculation reference for automatic VPhg tracking
|
| /Documentation/ABI/stable/ |
| D | sysfs-bus-fsl-mc | 16 disable the DPRC IRQs on which automatic rescan
|
| /Documentation/driver-api/ |
| D | dpll.rst | 86 In automatic mode (``DPLL_MODE_AUTOMATIC``) the user can request or
90 input for automatic selection algorithm
92 a valid input for automatic selection algorithm
94 In automatic mode (``DPLL_MODE_AUTOMATIC``) the user can only receive
95 pin state ``DPLL_PIN_STATE_CONNECTED`` once automatic selection
152 Some devices might offer a capability of automatic pin selection mode
154 Usually, automatic selection is performed on the hardware level, which
155 means only pins directly connected to the dpll can be used for automatic
157 In automatic selection mode, the user cannot manually select a input
171 Child pin of MUX-type pin is not capable of automatic input pin selection,
|
| /Documentation/devicetree/bindings/serial/ |
| D | socionext,uniphier-uart.yaml | 29 description: enable automatic flow control support.
|
| /Documentation/filesystems/ |
| D | automount-support.rst | 39 Automatic Mountpoint Expiry
42 Automatic expiration of mountpoints is easy, provided you've mounted the
|
| /Documentation/devicetree/bindings/mmc/ |
| D | nvidia,tegra20-sdhci.yaml | 119 automatic calibration times out on a 1.8 V signaling mode.
129 automatic calibration times out on a 3.3 V signaling mode.
147 automatic calibration times out on a 1.8 V signaling mode.
164 automatic calibration times out on a 3.3 V signaling mode.
|
| /Documentation/dev-tools/ |
| D | kmemleak.rst | 51 start the automatic memory scanning thread (default)
53 stop the automatic memory scanning thread
55 set the automatic memory scanning period in seconds
56 (default 600, 0 to stop the automatic scanning)
|
| /Documentation/driver-api/rapidio/ |
| D | rapidio.rst | 133 When automatic start of enumeration/discovery is used a user has to ensure
201 4.2 Automatic Start of Enumeration and Discovery
204 Automatic enumeration/discovery start method is applicable only to built-in
205 enumeration/discovery RapidIO configuration selection. To enable automatic
216 When automatic enumeration/discovery start is selected, basic method's
220 Depending on RapidIO network size and configuration this automatic
|
| /Documentation/tools/rtla/ |
| D | common_osnoise_options.rst | 3 Set the automatic trace mode. This mode sets some commonly used options
|
| /Documentation/devicetree/bindings/watchdog/ |
| D | dlg,da9062-watchdog.yaml | 29 Only use this option if you can't use the watchdog automatic suspend
|
12345678