Searched full:bootloader (Results 1 – 25 of 127) sorted by relevance
123456
| /Documentation/devicetree/bindings/gpu/host1x/ |
| D | nvidia,tegra234-nvdec.yaml | 67 firmware secure carveout. This carveout is configured by the bootloader and
73 Offset to bootloader manifest from beginning of firmware that was configured by
74 the bootloader.
79 Offset to bootloader code section from beginning of firmware that was configured by
80 the bootloader.
85 Offset to bootloader data section from beginning of firmware that was configured by
86 the bootloader.
92 the bootloader.
98 the bootloader.
104 by the bootloader.
|
| /Documentation/devicetree/bindings/power/reset/ |
| D | reboot-mode.yaml | 15 or ram. Then the bootloader can read it and take different
19 the bootloader what to do when the system reboots, and should be named
25 …- bootloader: Android fastboot mode, it's a mode to re-flash partitions on the Android based devic…
26 - loader: A bootloader mode, it's a mode used to download image on Rockchip platform,
46 mode-bootloader = <2>;
|
| D | nvmem-reboot-mode.yaml | 14 and stores it in the NVMEM cell named "reboot-mode". The bootloader can
48 mode-bootloader = <0x02>;
|
| D | syscon-reboot-mode.yaml | 14 and stores it in a SYSCON mapped register. Then the bootloader
50 mode-bootloader = <BOOT_FASTBOOT>;
|
| /Documentation/devicetree/bindings/net/ |
| D | ti,cc1352p7.yaml | 32 bootloader-backdoor-gpios:
35 gpios to enable bootloader backdoor in cc1352p7 bootloader to allow
55 bootloader-backdoor-gpios = <&pio 36 GPIO_ACTIVE_LOW>;
|
| /Documentation/devicetree/bindings/nvmem/ |
| D | rmem.yaml | 19 - raspberrypi,bootloader-config
20 - raspberrypi,bootloader-public-key
45 compatible = "raspberrypi,bootloader-config", "nvmem-rmem";
|
| /Documentation/devicetree/bindings/remoteproc/ |
| D | st-rproc.txt | 6 Co-processors can be controlled from the bootloader or the primary OS. If
7 the bootloader starts a co-processor, the primary OS must detect its state
18 - clock-frequency Clock frequency to set co-processor at if the bootloader
|
| /Documentation/devicetree/bindings/input/touchscreen/ |
| D | cypress,cy8ctma340.yaml | 67 bootloader-key:
68 description: the 8-byte bootloader key that is required to switch
69 the chip from bootloader mode (default mode) to application mode
117 - bootloader-key
139 bootloader-key = /bits/ 8 <0x00 0x01 0x02 0x03 0x04 0x05 0x06 0x07>;
|
| /Documentation/arch/x86/x86_64/ |
| D | uefi.rst | 10 the needed bootloader support and associated tools for x86_64 platforms
15 2. Booting Linux kernel on UEFI x86_64 platform requires bootloader
37 elilo bootloader with x86_64 support, elilo configuration file,
|
| /Documentation/networking/devlink/ |
| D | etas_es58x.rst | 26 * - ``fw.bootloader``
28 - Version of the bootloader running on the device. Also available
|
| D | iosm.rst | 38 the Bootloader images and other modem software images.
52 - External Bootloader
118 - This region contains the current instance of bootloader logs.
120 - This region contains the previous instance of bootloader logs.
|
| /Documentation/devicetree/bindings/net/bluetooth/ |
| D | brcm,bcm4377-bluetooth.yaml | 42 should be filled in by the bootloader from platform configuration
50 should be filled in by the bootloader from platform configuration
78 /* To be filled by the bootloader */
|
| /Documentation/devicetree/bindings/mtd/partitions/ |
| D | brcm,trx.txt | 6 supported by the CFE bootloader.
14 device executable binary (e.g. a kernel) as it's what the CFE bootloader starts
|
| D | u-boot.yaml | 7 title: U-Boot bootloader partition
10 U-Boot is a bootloader commonly used in embedded devices. It's almost always
|
| D | tplink,safeloader-partitions.yaml | 10 TP-Link home routers store various data on flash (e.g. bootloader,
16 devices with a custom SafeLoader bootloader. Later it was adapted to
|
| D | brcm,bcm947xx-cfe-partitions.yaml | 11 home routers. Their BCM947xx boards using CFE bootloader have several
24 1) Bootloader with Broadcom's CFE (Common Firmware Environment)
|
| /Documentation/translations/zh_TW/arch/arm/ |
| D | Booting | 97 bootloader 必須創建和初始化內核標籤列表。一個有效的標籤列表以
106 bootloader 必須傳遞一個系統內存的位置和最小值，以及根文件系統位置。
125 bootloader 必須以 64bit 地址對齊的形式加載一個設備樹映像(dtb)到系統
131 bootloader 必須傳遞一個系統內存的位置和最小值，以及根文件系統位置。
|
| /Documentation/translations/zh_CN/arch/arm/ |
| D | Booting | 97 bootloader 必须创建和初始化内核标签列表。一个有效的标签列表以
106 bootloader 必须传递一个系统内存的位置和最小值，以及根文件系统位置。
125 bootloader 必须以 64bit 地址对齐的形式加载一个设备树映像(dtb)到系统
131 bootloader 必须传递一个系统内存的位置和最小值，以及根文件系统位置。
|
| /Documentation/driver-api/mmc/ |
| D | mmc-dev-parts.rst | 17 a bootloader or bootloader configuration tables crucial to booting the
|
| /Documentation/arch/powerpc/ |
| D | elfnote.rst | 6 capabilities and information which can be used by a bootloader or userland.
33 In an ultravisor-enabled system, a bootloader could warn the user or prevent
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | qcom,pm8941-coincell.yaml | 33 inherit the previous configuration (e.g. from bootloader or hardware
41 the previous configuration (e.g. from bootloader or hardware default
|
| /Documentation/ABI/testing/ |
| D | sysfs-firmware-ofw | 36 the bootloader. This allows userland applications such
39 made to the blob by the bootloader.
|
| D | sysfs-devices-platform-stratix10-rsu | 107 0 the first stage bootloader didn't run or
109 stage bootloader.
110 1 failed in second bootloader or didn't get
113 2 both first and second stage bootloader ran
|
| D | sysfs-platform-intel-wmi-sbl-fw-update | 7 Bootloader (SBL). This attribute normally has a value
|
| /Documentation/arch/arm/samsung/ |
| D | index.rst | 11 bootloader-interface
|
123456