Searched full:data0 (Results 1 – 9 of 9) sorted by relevance
| /Documentation/devicetree/bindings/display/ |
| D | lvds-data-mapping.yaml | 47 DATA0 ><__G0__><__R5__><__R4__><__R3__><__R2__><__R1__><__R0__><
58 DATA0 ><__G2__><__R7__><__R6__><__R5__><__R4__><__R3__><__R2__><
70 DATA0 ><__G0__><__R5__><__R4__><__R3__><__R2__><__R1__><__R0__><
|
| /Documentation/block/ |
| D | cmdline-partition.rst | 48 'blkdevparts=mmcblk0:1G(data0),1G(data1),-;mmcblk0boot0:1m(boot),-(kernel)'
52 mmcblk0: p1(data0) p2(data1) p3()
|
| /Documentation/devicetree/bindings/display/ti/ |
| D | ti,omap3-dss.txt | 86 - lanes: list of pin numbers for the DSI lanes: CLK+, CLK-, DATA0+, DATA0-,
|
| D | ti,omap5-dss.txt | 77 - lanes: list of pin numbers for the DSI lanes: CLK+, CLK-, DATA0+, DATA0-,
|
| D | ti,omap4-dss.txt | 96 - lanes: list of pin numbers for the DSI lanes: CLK+, CLK-, DATA0+, DATA0-,
|
| /Documentation/i2c/busses/ |
| D | i2c-mlxcpld.rst | 55 specified in the four first bytes (DATA0 - DATA3). Data is read
56 starting from DATA0.
|
| /Documentation/arch/x86/x86_64/ |
| D | fsgs.rst | 159 long data0 = 0;
167 /* Set GS base to point to data0 */
168 _writegsbase_u64(&data0);
172 printf("data0 = %ld\n", *ptr);
|
| /Documentation/devicetree/bindings/sound/ |
| D | rockchip,i2s-tdm.yaml | 117 rockchip,i2s-rx-route = <3> would mean sdi3 is receiving from data0.
127 rockchip,i2s-tx-route = <3> would mean sdo3 is sending to data0.
|
| /Documentation/driver-api/usb/ |
| D | usb.rst | 493 DATA0. The ioctl parameter is an integer endpoint number (1 to 15,
|