Searched full:denotes (Results 1 – 25 of 54) sorted by relevance
123
| /Documentation/ABI/testing/ |
| D | sysfs-devices-supplier | 6 links where this device is the consumer. <supplier> denotes the
|
| D | sysfs-devices-consumer | 6 links where this device is the supplier. <consumer> denotes the
|
| D | sysfs-driver-hid-logitech-lg4ff | 19 contains an abstract item "native" which always denotes the
|
| D | sysfs-class-extcon | 10 One extcon device denotes a single external connector
|
| /Documentation/userspace-api/media/v4l/ |
| D | metafmt-generic.rst | 30 Each cell is one byte. "M" denotes a byte of metadata.
72 Each cell is one byte. "M" denotes a byte of metadata and "x" a byte of padding.
116 Each cell is one byte. "M" denotes a byte of metadata and "x" a byte of padding.
157 Each cell is one byte. "M" denotes a byte of metadata and "x" a byte of padding.
204 Each cell is one byte. "M" denotes a byte of metadata and "x" a byte of padding.
253 Each cell is one byte. "M" denotes a byte of metadata and "x" a byte of padding.
306 Each cell is one byte. "M" denotes a byte of metadata and "x" a byte of padding.
|
| D | vidioc-enum-frameintervals.rst | 96 In the structs below, *IN* denotes a value that has to be filled in by
97 the application, *OUT* denotes values that the driver fills in. The
|
| D | vidioc-enum-framesizes.rst | 86 In the structs below, *IN* denotes a value that has to be filled in by
87 the application, *OUT* denotes values that the driver fills in. The
|
| D | pixfmt-yuv-luma.rst | 17 - Y'\ :sub:`x`\ [9:2] denotes bits 9 to 2 of the Y' value for pixel at column
19 - `0` denotes padding bits set to 0.
|
| D | pixfmt-packed-yuv.rst | 18 denotes bits of the alpha component (if supported by the format), and 'X'
19 denotes padding bits.
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | aspeed,ast2400-i2c-ic.txt | 12 - interrupt-controller : denotes that the controller receives and fires
|
| /Documentation/devicetree/bindings/net/ |
| D | fsl-tsec-phy.txt | 70 - rx-stash-len : Denotes the number of bytes of a received buffer to stash
72 - rx-stash-idx : Denotes the index of the first byte from the received
|
| D | ti,dp83867.yaml | 103 This denotes the fact that the board has RX_DV/RX_CTRL pin strapped in
111 This denotes which SGMII configuration is used (4 or 6-wire modes).
|
| /Documentation/devicetree/bindings/phy/ |
| D | brcm,sr-pcie-phy.txt | 8 - #phy-cells: Must be 1, denotes the PHY index
|
| /Documentation/devicetree/bindings/sound/ |
| D | serial-midi.yaml | 14 Generic MIDI interface using a serial device. This denotes that a serial device is
|
| /Documentation/arch/x86/ |
| D | elf_auxvec.rst | 48 AT_MINSIGSTKSZ denotes the minimum stack size required by the kernel to
|
| /Documentation/devicetree/bindings/dma/ |
| D | nvidia,tegra210-adma.yaml | 50 The first cell denotes the receive/transmit request number and
|
| /Documentation/driver-api/media/drivers/ccs/ |
| D | ccs.rst | 35 vvvv or vv denotes MIPI and SMIA manufacturer IDs respectively, mmmm model ID
|
| /Documentation/admin-guide/sysctl/ |
| D | fs.rst | 77 The value in ``file-max`` denotes the maximum number of file-
124 This denotes the maximum number of mounts that may exist
131 This denotes the maximum number of file-handles a process can
|
| /Documentation/devicetree/bindings/leds/ |
| D | leds-lp50xx.yaml | 66 This property denotes the LED module number(s) that is used on the
|
| /Documentation/leds/ |
| D | leds-qcom-lpg.rst | 76 denotes the wait time before the pattern is run in reverse and as such the
|
| /Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,smsm.yaml | 90 Required for local entry. Denotes bit number.
|
| /Documentation/networking/pse-pd/ |
| D | introduction.rst | 21 PoDL PSE, or Power over Data Lines PSE, specifically denotes PSEs operating
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | qcom,pmic-mpp.yaml | 61 second denotes the flags for this gpio
|
| /Documentation/devicetree/bindings/mmc/ |
| D | mmc-controller.yaml | 127 When specified, denotes that 1.8V card voltage is not supported
342 subnode describes. A value of 0 denotes the memory SD
|
| /Documentation/devicetree/bindings/media/xilinx/ |
| D | xlnx,csi2rxss.yaml | 49 This denotes the CSI Data type selected in hw design.
|
123