Home
last modified time | relevance | path

Searched full:gpio_active_high (Results 1 – 25 of 330) sorted by relevance

12345678910>>...14

/Documentation/devicetree/bindings/bus/
Dts-nbus.txt31 ts,data-gpios = <&gpio0 0 GPIO_ACTIVE_HIGH
32 &gpio0 1 GPIO_ACTIVE_HIGH
33 &gpio0 2 GPIO_ACTIVE_HIGH
34 &gpio0 3 GPIO_ACTIVE_HIGH
35 &gpio0 4 GPIO_ACTIVE_HIGH
36 &gpio0 5 GPIO_ACTIVE_HIGH
37 &gpio0 6 GPIO_ACTIVE_HIGH
38 &gpio0 7 GPIO_ACTIVE_HIGH>;
39 ts,csn-gpios = <&gpio0 16 GPIO_ACTIVE_HIGH>;
40 ts,txrx-gpios = <&gpio0 24 GPIO_ACTIVE_HIGH>;
[all …]
/Documentation/devicetree/bindings/phy/
Dphy-mapphone-mdm6600.txt18 power-gpios = <&gpio2 22 GPIO_ACTIVE_HIGH>;
19 reset-gpios = <&gpio2 17 GPIO_ACTIVE_HIGH>;
20 motorola,mode-gpios = <&gpio5 20 GPIO_ACTIVE_HIGH>,
21 <&gpio5 21 GPIO_ACTIVE_HIGH>;
22 motorola,cmd-gpios = <&gpio4 7 GPIO_ACTIVE_HIGH>,
23 <&gpio4 8 GPIO_ACTIVE_HIGH>,
24 <&gpio5 14 GPIO_ACTIVE_HIGH>;
25 motorola,status-gpios = <&gpio2 20 GPIO_ACTIVE_HIGH>,
26 <&gpio2 21 GPIO_ACTIVE_HIGH>,
27 <&gpio2 23 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/gpio/
Dnetxbig-gpio-ext.txt15 addr-gpios = <&gpio1 15 GPIO_ACTIVE_HIGH
16 &gpio1 16 GPIO_ACTIVE_HIGH
17 &gpio1 17 GPIO_ACTIVE_HIGH>;
18 data-gpios = <&gpio1 12 GPIO_ACTIVE_HIGH
19 &gpio1 13 GPIO_ACTIVE_HIGH
20 &gpio1 14 GPIO_ACTIVE_HIGH>;
21 enable-gpio = <&gpio0 29 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/auxdisplay/
Dhit,hd44780.yaml90 data-gpios = <&hc595 0 GPIO_ACTIVE_HIGH>,
91 <&hc595 1 GPIO_ACTIVE_HIGH>,
92 <&hc595 2 GPIO_ACTIVE_HIGH>,
93 <&hc595 3 GPIO_ACTIVE_HIGH>;
94 enable-gpios = <&hc595 4 GPIO_ACTIVE_HIGH>;
95 rs-gpios = <&hc595 5 GPIO_ACTIVE_HIGH>;
119 data-gpios = <&pcf8574 4 GPIO_ACTIVE_HIGH>,
120 <&pcf8574 5 GPIO_ACTIVE_HIGH>,
121 <&pcf8574 6 GPIO_ACTIVE_HIGH>,
122 <&pcf8574 7 GPIO_ACTIVE_HIGH>;
[all …]
/Documentation/devicetree/bindings/input/
Dgpio-decoder.txt17 gpios = <&pca9536 3 GPIO_ACTIVE_HIGH>,
18 <&pca9536 2 GPIO_ACTIVE_HIGH>,
19 <&pca9536 1 GPIO_ACTIVE_HIGH>,
20 <&pca9536 0 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/iio/adc/
Dadi,ad7606.yaml57 is active high, it should be marked GPIO_ACTIVE_HIGH.
65 high, it should be marked GPIO_ACTIVE_HIGH. On the AD7616, as the line is
82 should be marked GPIO_ACTIVE_HIGH.
92 GPIO_ACTIVE_HIGH. On the AD7616, there are 2 pins, and if the 2 pins are
101 line is active high, it should be marked GPIO_ACTIVE_HIGH. On the AD7606X
196 adi,conversion-start-gpios = <&gpio 17 GPIO_ACTIVE_HIGH>;
197 reset-gpios = <&gpio 27 GPIO_ACTIVE_HIGH>;
198 adi,first-data-gpios = <&gpio 22 GPIO_ACTIVE_HIGH>;
199 adi,oversampling-ratio-gpios = <&gpio 18 GPIO_ACTIVE_HIGH>,
200 <&gpio 23 GPIO_ACTIVE_HIGH>,
[all …]
/Documentation/devicetree/bindings/hsi/
Dnokia-modem.txt48 gpios = <&gpio3 6 GPIO_ACTIVE_HIGH>, /* 70 */
49 <&gpio3 9 GPIO_ACTIVE_HIGH>, /* 73 */
50 <&gpio3 10 GPIO_ACTIVE_HIGH>, /* 74 */
51 <&gpio3 11 GPIO_ACTIVE_HIGH>, /* 75 */
52 <&gpio5 29 GPIO_ACTIVE_HIGH>; /* 157 */
/Documentation/devicetree/bindings/display/panel/
Dsharp,ls037v7dw01.yaml55 enable-gpios = <&gpio5 24 GPIO_ACTIVE_HIGH>; /* gpio152, lcd INI */
56 reset-gpios = <&gpio5 27 GPIO_ACTIVE_HIGH>; /* gpio155, lcd RESB */
57 mode-gpios = <&gpio5 26 GPIO_ACTIVE_HIGH /* gpio154, lcd MO */
58 &gpio1 2 GPIO_ACTIVE_HIGH /* gpio2, lcd LR */
59 &gpio1 3 GPIO_ACTIVE_HIGH>; /* gpio3, lcd UD */
Dsamsung,lms397kf04.yaml64 sck-gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
65 miso-gpios = <&gpio 1 GPIO_ACTIVE_HIGH>;
66 mosi-gpios = <&gpio 2 GPIO_ACTIVE_HIGH>;
67 cs-gpios = <&gpio 3 GPIO_ACTIVE_HIGH>;
Dsamsung,s6d27a1.yaml72 sck-gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
73 miso-gpios = <&gpio 1 GPIO_ACTIVE_HIGH>;
74 mosi-gpios = <&gpio 2 GPIO_ACTIVE_HIGH>;
75 cs-gpios = <&gpio 3 GPIO_ACTIVE_HIGH>;
Dsamsung,lms380kf01.yaml71 sck-gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
72 miso-gpios = <&gpio 1 GPIO_ACTIVE_HIGH>;
73 mosi-gpios = <&gpio 2 GPIO_ACTIVE_HIGH>;
74 cs-gpios = <&gpio 3 GPIO_ACTIVE_HIGH>;
Dboe,himax8279d.yaml55 enable-gpios = <&gpio 45 GPIO_ACTIVE_HIGH>;
56 pp33-gpios = <&gpio 35 GPIO_ACTIVE_HIGH>;
57 pp18-gpios = <&gpio 36 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/sound/
Dnokia,rx51.txt23 tvout-selection-gpios = <&gpio2 8 GPIO_ACTIVE_HIGH>; /* 40 */
24 jack-detection-gpios = <&gpio6 17 GPIO_ACTIVE_HIGH>; /* 177 */
25 eci-switch-gpios = <&gpio6 22 GPIO_ACTIVE_HIGH>; /* 182 */
26 speaker-amplifier-gpios = <&twl_gpio 7 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/iio/amplifiers/
Dadi,hmc425a.yaml93 ctrl-gpios = <&gpio 40 GPIO_ACTIVE_HIGH>,
94 <&gpio 39 GPIO_ACTIVE_HIGH>,
95 <&gpio 38 GPIO_ACTIVE_HIGH>,
96 <&gpio 37 GPIO_ACTIVE_HIGH>,
97 <&gpio 36 GPIO_ACTIVE_HIGH>,
98 <&gpio 35 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/serio/
Dps2-gpio.yaml19 active high using open drain with (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)
27 active high using open drain with (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)
61 data-gpios = <&gpio 24 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
62 clk-gpios = <&gpio 23 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
/Documentation/devicetree/bindings/net/nfc/
Dsamsung,s3fwrn5.yaml83 en-gpios = <&gpf1 4 GPIO_ACTIVE_HIGH>;
84 wake-gpios = <&gpj0 2 GPIO_ACTIVE_HIGH>;
95 en-gpios = <&gpio 20 GPIO_ACTIVE_HIGH>;
96 wake-gpios = <&gpio 16 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/display/ti/
Dti,tpd12s015.txt20 gpios = <&gpio2 28 GPIO_ACTIVE_HIGH>, /* 60, CT CP HPD */
21 <&gpio2 9 GPIO_ACTIVE_HIGH>, /* 41, LS OE */
22 <&gpio2 31 GPIO_ACTIVE_HIGH>; /* 63, HPD */
/Documentation/devicetree/bindings/net/
Dsff,sfp.yaml96 los-gpios = <&cpm_gpio2 22 GPIO_ACTIVE_HIGH>;
101 tx-disable-gpios = <&cps_gpio1 24 GPIO_ACTIVE_HIGH>;
102 tx-fault-gpios = <&cpm_gpio2 19 GPIO_ACTIVE_HIGH>;
118 los-gpios = <&cps_gpio1 28 GPIO_ACTIVE_HIGH>;
122 tx-disable-gpios = <&cps_gpio1 29 GPIO_ACTIVE_HIGH>;
123 tx-fault-gpios = <&cps_gpio1 26 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/mfd/
Dti-lmu.txt120 enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>; /* PC2 */
125 enable-gpios = <&pioC 0 GPIO_ACTIVE_HIGH>,
126 <&pioC 1 GPIO_ACTIVE_HIGH>;
165 enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>;
210 enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>;
228 enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>;
234 enable-gpios = <&pioC 0 GPIO_ACTIVE_HIGH>,
235 <&pioC 1 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/media/cec/
Dcec-gpio.yaml71 cec-gpios = <&gpio 7 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
72 hpd-gpios = <&gpio 17 GPIO_ACTIVE_HIGH>;
73 v5-gpios = <&gpio 22 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/net/can/
Dtcan4x5x.txt44 device-state-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>;
45 device-wake-gpios = <&gpio1 15 GPIO_ACTIVE_HIGH>;
46 reset-gpios = <&gpio1 27 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/hwmon/
Dnsa320-mcu.txt17 data-gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>;
18 clk-gpios = <&gpio0 16 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/display/
Dsitronix,st7586.txt20 a0-gpios = <&gpio 43 GPIO_ACTIVE_HIGH>;
21 reset-gpios = <&gpio 80 GPIO_ACTIVE_HIGH>;
Dilitek,ili9225.txt22 rs-gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
23 reset-gpios = <&gpio0 8 GPIO_ACTIVE_HIGH>;
/Documentation/devicetree/bindings/leds/
Dleds-gpio.yaml64 gpios = <&mcu_pio 1 GPIO_ACTIVE_HIGH>;
74 gpios = <&mpc8572 6 GPIO_ACTIVE_HIGH>;
79 gpios = <&mpc8572 7 GPIO_ACTIVE_HIGH>;

12345678910>>...14