Searched full:int2 (Results 1 – 20 of 20) sorted by relevance
| /Documentation/devicetree/bindings/iio/imu/ |
| D | bosch,bmi160.yaml | 34 - INT2
37 to "INT2" if INT2 pin should be used instead
96 interrupt-names = "INT2";
|
| D | nxp,fxos8700.yaml | 34 - INT2
79 interrupt-names = "INT2";
|
| D | bosch,bmi323.yaml | 38 - INT2
|
| D | st,lsm6dsx.yaml | 62 Supports up to 2 interrupt lines via the INT1 and INT2 pins.
|
| /Documentation/devicetree/bindings/iio/accel/ |
| D | bosch,bma255.yaml | 51 the one connected to the INT2 pin (if available). The type should be
55 always treated as INT2.
63 - INT2
106 interrupt-names = "INT2";
|
| D | fsl,mma7455.yaml | 34 to INT1 and second (where present) to INT2.
40 - INT2
64 interrupt-names = "INT2", "INT1";
|
| D | fsl,mma8452.yaml | 38 - INT2
62 interrupt-names = "INT2";
|
| D | bosch,bmi088.yaml | 43 - INT2
68 interrupt-names = "INT2";
|
| D | kionix,kx022a.yaml | 35 - enum: [INT1, INT2]
36 - const: INT2
|
| D | nxp,fxls8962af.yaml | 36 - INT2
|
| D | adi,adxl355.yaml | 39 - INT2
|
| D | adi,adxl313.yaml | 47 - INT2
|
| /Documentation/devicetree/bindings/iio/gyroscope/ |
| D | nxp,fxas21002c.yaml | 44 - INT2
96 interrupt-names = "INT2";
|
| D | bosch,bmg160.yaml | 33 If two interrupts are provided, expected order is INT1 and INT2.
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | loongson,liointc.yaml | 120 <0x00000000>, /* int2 */
|
| /Documentation/devicetree/bindings/net/ |
| D | fsl,fec.yaml | 89 - const: int2
93 - const: int2
|
| /Documentation/ |
| D | dontdiff | 147 int2.c
|
| /Documentation/arch/m68k/ |
| D | buddha-driver.rst | 103 The IDE ports issue an INT2. You can read the level of the
107 determine what driver has to serve the INT2. Buddha and
|
| /Documentation/devicetree/bindings/iio/ |
| D | st,st-sensors.yaml | 101 Inertial interrupt lines INT1 and INT2 if these exist. This means up to
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | marvell,armada-xp-pinctrl.txt | 52 mpp31 31 gpio, tdm(int2), sd0(cmd)
|