Searched full:ipv6 (Results 1 – 25 of 82) sorted by relevance
1234
| /Documentation/networking/ |
| D | ipv6.rst | 4 IPv6 title
8 Options for the ipv6 module are supplied as parameters at load time.
15 The available ipv6 module parameters are listed below. If a parameter
22 Specifies whether to load the IPv6 module, but disable all
24 has a dependency on the IPv6 module being loaded, but no
25 IPv6 addresses or operations are desired.
30 IPv6 is enabled.
35 IPv6 is disabled.
37 No IPv6 addresses will be added to interfaces, and
38 it will not be possible to open an IPv6 socket.
[all …]
|
| D | seg6-sysctl.rst | 12 Accept or drop SR-enabled IPv6 packets on this interface.
30 IPv6 header in case of SR T.encaps
34 0 copy flowlabel from Inner packet in case of Inner IPv6
|
| D | mpls-sysctl.rst | 31 Control whether TTL is propagated from the IPv4/IPv6 header to
33 MPLS header to the IPv4/IPv6 header on popping the last label.
|
| D | ieee802154.rst | 12 - 6LoWPAN - IPv6 networking over low rate personal area networks
44 [RFC4944] was specified to carry IPv6 datagrams over such constrained links,
48 to support the IPv6 minimum MTU requirement [RFC2460], and stateless header
49 compression for IPv6 datagrams (LOWPAN_HC1 and LOWPAN_HC2) to reduce the
50 relatively large IPv6 and UDP headers down to (in the best case) several bytes.
|
| D | ip-sysctl.rst | 136 to both IPv4 and IPv6 datapath. Only present for kernels built with
173 From linux kernel 6.3 onwards, this is deprecated for ipv6
665 This options affects both IPv4 and IPv6.
1131 flow label field for outgoing IPv6 packets. A change in flow label
1135 PLB changes socket txhash which results in a change in IPv6 Flow Label
1980 /proc/sys/net/ipv6/* Variables
1983 IPv6 has no global variables such as tcp_*. tcp_* settings under ipv4/ also
1984 apply to IPv6 [XXX?].
1988 which restricts use of the IPv6 socket to IPv6 communication
2027 reserved for the IPv6 flow manager facility, 0x80000-0xFFFFF
[all …]
|
| D | checksum-offloads.rst | 109 IPv6 equivalents, in udp6_set_csum().
113 constructing an IPv6 GRE header; the GRE checksum is computed over the whole
114 packet in net/ipv6/ip6_gre.c:ip6gre_xmit2(), but it should be possible to use
115 LCO here as IPv6 GRE still uses an IP-style checksum.
|
| D | pktgen.rst | 151 pgset "dst6 fec0::1" IPV6 destination address
152 pgset "src6 fec0::2" IPV6 source address
172 TXSIZE_RND, IPV6,
226 …pgset "traffic_class XX" set former IPv6 TRAFFIC CLASS (e.g. "traffic_class B8" for EF no ECN, def…
262 -6 : ($IP6) IPv6
340 traffic_class (ipv6)
360 IPV6
|
| D | ila.rst | 11 Identifier-locator addressing (ILA) is a technique used with IPv6 that
22 other IPv6 packet. For instance, if the transport protocol is TCP then an
23 ILA translated packet looks like just another TCP/IPv6 packet. The
49 An IPv6 address composed of a SIR prefix (upper sixty-
56 An IPv6 address composed of a locator (upper sixty-four
103 packet +---+--+ . IPv6 . +---+--+ packet
158 3: virtual networking identifier for IPv6 unicast address
160 4: virtual networking identifier for IPv6 multicast address
|
| D | ioam6-sysctl.rst | 12 Accept (= enabled) or ignore (= disabled) IPv6 IOAM options on ingress
|
| D | index.rst | 68 ipv6
|
| D | sctp.rst | 32 - There is tentative support for IPv6, but most work has gone towards
|
| D | gtp.rst | 118 IPv6 chapter
121 The 3GPP specifications indicate either IPv4 or IPv6 can be used both
124 Unfortunately, the Kernel module currently supports IPv6 neither for
231 IPv6 prefixes, is unique.
|
| D | dns_resolver.rst | 50 basic dname to IPv4/IPv6 address resolution, the following line should be
97 IPv6 addresses. The caller must free the result.
|
| D | nf_conntrack-sysctl.rst | 52 Maximum memory used to reassemble IPv6 fragments. When
65 Time to keep an IPv6 fragment in memory.
|
| D | vrf.rst | 47 in the IPv4 and IPv6 processing stacks giving the impression that packets
74 l3mdev rule for IPv4 and IPv6 when the first device is created with a
101 The IPv6 sysctl option keep_addr_on_down can be enabled to keep IPv6 global
104 sysctl -w net.ipv6.conf.all.keep_addr_on_down=1
175 covers all VRFs. The l3mdev rule is created for IPv4 and IPv6 on first
|
| /Documentation/netlink/specs/ |
| D | tcp_metrics.yaml | 32 name: addr-ipv6
37 display-hint: ipv6
73 name: saddr-ipv6
78 display-hint: ipv6
142 - addr-ipv6
144 - saddr-ipv6
148 - addr-ipv6
150 - saddr-ipv6
|
| D | ovs_flow.yaml | 86 name: ovs-key-ipv6
90 name: ipv6-src
94 display-hint: ipv6
96 name: ipv6-dst
100 display-hint: ipv6
102 name: ipv6-label
106 name: ipv6-proto
109 name: ipv6-tclass
112 name: ipv6-hlimit
115 name: ipv6-frag
[all …]
|
| D | nfsd.yaml | 48 display-hint: ipv6
52 display-hint: ipv6
|
| D | tc.yaml | 1600 name: nat-ipv6-min
1603 name: nat-ipv6-max
1929 name: enc-ipv6-src
1932 name: enc-ipv6-dst
2412 name: key-ipv6-src
2414 display-hint: ipv6
2416 name: key-ipv6-src-mask
2418 display-hint: ipv6
2420 name: key-ipv6-dst
2422 display-hint: ipv6
[all …]
|
| /Documentation/networking/devlink/ |
| D | devlink-trap.rst | 206 - Traps IPv6 packets that the device decided to drop because they need to
207 be routed and their IPv6 multicast destination IP has a reserved scope
211 - Traps IPv6 packets that the device decided to drop because they need to
212 be routed and their IPv6 multicast destination IP has an interface-local scope
233 - Traps unicast IPv6 packets that did not match any route
296 - Traps IPv6 DHCP packets
310 - Traps IPv6 Neighbour Solicitation packets
313 - Traps IPv6 Neighbour Advertisement packets
319 - Traps IPv6 BFD packets
325 - Traps IPv6 OSPF packets
[all …]
|
| D | netdevsim.rst | 55 $ devlink resource set netdevsim/netdevsim0 path /IPv6/fib size 64
56 $ devlink resource set netdevsim/netdevsim0 path /IPv6/fib-rules size 16
|
| /Documentation/security/ |
| D | SCTP.rst | 36 Passes one or more ipv4/ipv6 addresses to the security module for validation
44 @address - One or more ipv4 / ipv6 addresses.
46 ipv4 or ipv6 address using sizeof(struct sockaddr_in) or
53 | SCTP_SOCKOPT_BINDX_ADD | One or more ipv4 / ipv6 addresses |
54 | SCTP_PRIMARY_ADDR | Single ipv4 or ipv6 address |
55 | SCTP_SET_PEER_PRIMARY_ADDR | Single ipv4 or ipv6 address |
62 | SCTP_SOCKOPT_CONNECTX | One or more ipv4 / ipv6 addresses |
63 | SCTP_PARAM_ADD_IP | One or more ipv4 / ipv6 addresses |
64 | SCTP_SENDMSG_CONNECT | Single ipv4 or ipv6 address |
65 | SCTP_PARAM_SET_PRIMARY | Single ipv4 or ipv6 address |
[all …]
|
| /Documentation/core-api/ |
| D | printk-formats.rst | 341 IPv6 addresses
350 For printing IPv6 network-order 16-bit hex addresses. The ``I6`` and ``i6``
355 print a compressed IPv6 address as described by
360 IPv4/IPv6 addresses (generic, with port, flowinfo, scope)
376 (IPv4, IPv6), flowinfo (IPv6) and scope (IPv6). Ports have a ``:`` prefix,
379 In case of an IPv6 address the compressed IPv6 address as described by
381 specifier ``c`` is given. The IPv6 address is surrounded by ``[``, ``]`` in
386 specifiers can be used as well and are ignored in case of an IPv6
|
| /Documentation/devicetree/bindings/net/ |
| D | microchip,sparx5-switch.yaml | 20 IPv4/IPv6 Layer 3 (L3) unicast and multicast routing is supported
21 with up to 18K IPv4/9K IPv6 unicast LPM entries and up to 9K IPv4/3K
22 IPv6 (S,G) multicast groups.
|
| /Documentation/networking/device_drivers/ethernet/aquantia/ |
| D | atlantic.rst | 281 - Locations 32 - 39 for L3/L4 5-tuple filters (locations 32, 36 for IPv6)
285 8 source and destination addresses can be matched. For IPv6, up to 2 pairs of
300 for traffic IPv4 or you can set 2 rules for traffic IPv6. Loc number traffic
301 IPv6 is 32 and 36.
302 At the moment you can not use IPv4 and IPv6 filters at the same time.
304 Example filter for IPv6 filter traffic::
|
1234