Searched full:ignored (Results 1 – 25 of 321) sorted by relevance
12345678910>>...13
| /Documentation/arch/s390/ |
| D | common_io.rst | 19 The given devices will be ignored by the common I/O-layer; no detection
24 An ignored device can be un-ignored later; see the "/proc entries"-section for
51 By default, no devices are ignored.
59 Lists the ranges of devices (by bus id) which are ignored by common I/O.
62 "free all" will un-ignore all ignored devices,
66 For example, if devices 0.0.0023 to 0.0.0042 and 0.0.4711 are ignored,
70 to 0.0.002f, 0.0.0033 to 0.0.0042 and 0.0.4711 ignored;
73 - echo free all > /proc/cio_ignore will un-ignore all remaining ignored
76 When a device is un-ignored, device recognition and sensing is performed and
80 You can also add ranges of devices to be ignored by piping to
[all …]
|
| /Documentation/userspace-api/ |
| D | ELF.rst | 20 interpreter. Other PT_INTERP headers are ignored (since Linux 2.4.11).
26 (since Linux 2.6.6). Other PT_GNU_STACK headers are ignored.
34 are ignored.
|
| /Documentation/ABI/testing/ |
| D | debugfs-cec-error-inj | 12 Leading spaces/tabs are ignored. If the next character is a '#' or the
13 end of the line was reached, then the whole line is ignored. Otherwise
|
| D | sysfs-devices-platform-sh_mobile_lcdc_fb | 9 from 0 (transparent) to 255 (opaque). The value is ignored if
43 range from 0 to 255. The value is ignored if the mode is not
|
| D | sysfs-driver-hid-ntrig | 6 (RW) Number of contact frames ignored before acknowledging the
15 (RW) Number of empty (no contact) frames ignored before
|
| D | sysfs-class-rc | 53 the filter will be ignored. Otherwise the write will fail with
70 the filter will be ignored. Otherwise the write will fail with
|
| D | dev-kmsg | 80 gracefully ignored.
95 7,160,424069,-;pci_root PNP0A03:00: host bridge window [io 0x0000-0x0cf7] (ignored)
|
| D | sysfs-class-net-cdc_ncm | 96 - Bits 2 – 15: reserved (reset to zero; must be ignored by host)
150 as zero by function, and ignored by host. (Payload
|
| /Documentation/fb/ |
| D | intel810.rst | 66 ignored if 'mode_option' is specified. See 'o' below).
73 is enabled, this will be ignored and computed as 3*xres/4. (This
74 parameter will be ignored if 'mode_option' is specified. See 'o'
103 ignored and values will be taken from the EDID block.
111 rate. If EDID probing is successful, these will be ignored and values
175 is specified, the options 'xres' and 'yres' will be ignored. See
|
| /Documentation/networking/device_drivers/cellular/qualcomm/ |
| D | rmnet.rst | 46 Reserved bits must be zero when sent and ignored when received.
72 Reserved bits must be zero when sent and ignored when received.
93 Reserved bits must be zero when sent and ignored when received.
155 Reserved bits must be zero when sent and ignored when received.
|
| /Documentation/networking/ |
| D | ax25.rst | 15 of the message, the subject field is ignored. You don't need to be
|
| /Documentation/input/ |
| D | userio.rst | 46 argument, this field can be left untouched and will be ignored by the kernel.
51 written to the character device after the initial command will be ignored.
|
| /Documentation/userspace-api/media/cec/ |
| D | cec-pin-error-inj.rst | 88 Leading spaces/tabs are ignored. If the next character is a ``#`` or the end
89 of the line was reached, then the whole line is ignored. Otherwise a command
172 the high-level protocol since spurious bytes should be ignored.
177 protocol since messages that are too short should be ignored.
222 same reason the whole message is typically ignored. The receiver should be
250 This command is ignored for 0 bits in bit positions 0 to 3. This is
268 This command is ignored for 0 bits in bit positions 0 to 3. This is
|
| /Documentation/devicetree/bindings/sound/ |
| D | cirrus,madera.yaml | 102 description of this value. The second cell is ignored for
112 of this value. The second cell is ignored for codecs that
|
| D | wlf,arizona.yaml | 95 the datasheet for values. The second cell is ignored for codecs that
104 the datasheet for values. The second cell is ignored for codecs that
|
| /Documentation/devicetree/bindings/power/reset/ |
| D | ltc2952-poweroff.txt | 18 trigger function is ignored and the chip is kept alive
|
| /Documentation/driver-api/firmware/ |
| D | fw_search_path.rst | 8 * fw_path_para - module parameter - default is empty so this is ignored
|
| /Documentation/userspace-api/media/mediactl/ |
| D | media-ioc-enum-links.rst | 70 - Pointer to a pads array allocated by the application. Ignored if
75 - Pointer to a links array allocated by the application. Ignored if
|
| /Documentation/filesystems/ |
| D | affs.rst | 117 - D is ignored.
119 - H, S and P are always retained and ignored under Linux.
141 - All other flags (suid, sgid, ...) are ignored and will
215 Case is ignored by the affs in filename matching, but Linux shells
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | ti,da850-pupd.txt | 13 The names of these groups are ignored.
|
| /Documentation/w1/slaves/ |
| D | w1_ds2406.rst | 24 respectively. Bits 2-7 are ignored, so it's safe to write ASCII data.
|
| /Documentation/virt/kvm/s390/ |
| D | s390-diag.rst | 31 the function code, and bits 0-47 are ignored.
71 identifier, it is ignored.
|
| /Documentation/gpu/amdgpu/display/ |
| D | display-manager.rst | 112 the alpha channel value of each pixel in a plane is ignored and only the plane
155 be ignored and, therefore, pixel values are not pre-multiplied
159 In short, *fg.alpha* is ignored by selecting
|
| /Documentation/admin-guide/ |
| D | perf-security.rst | 232 locking limit is ignored when allocating memory buffers for storing
243 imposed but ignored for unprivileged processes with CAP_IPC_LOCK
251 perf_event_mlock_kb locking limit is imposed but ignored for
258 perf_event_mlock_kb locking limit is imposed but ignored for
301 RLIMIT_MEMLOCK and perf_event_mlock_kb resource constraints are ignored
|
| /Documentation/leds/ |
| D | ledtrig-oneshot.rst | 40 echo 1 > shot # led starts blinking, ignored if already blinking
|
12345678910>>...13