Searched full:infrared (Results 1 – 25 of 27) sorted by relevance
12
| /Documentation/ABI/testing/ |
| D | sysfs-bus-iio-light-si1133 | 5 Unit-less infrared intensity. The intensity is measured from 1
7 infrared.
13 Unit-less infrared intensity. The intensity is measured from 4
15 infrared.
|
| D | sysfs-bus-iio-light-isl29018 | 7 infrared suppression:
|
| D | sysfs-class-rc | 7 core and provides a sysfs interface for configuring infrared
|
| /Documentation/userspace-api/media/v4l/ |
| D | pixfmt-inzi.rst | 9 Infrared 10-bit linked with Depth 16-bit images
16 Infrared image followed by Depth data. The pixel definition is 32-bpp,
17 with the Depth and Infrared Data split into separate continuous planes of
22 The first plane - Infrared data - is stored according to
56 * - :cspan:`5` Infrared Data
|
| /Documentation/devicetree/bindings/media/ |
| D | st-rc.txt | 10 - rx-mode: can be "infrared" or "uhf". This property specifies the L1
13 - tx-mode: should be "infrared". This property specifies the L1
28 rx-mode = "infrared";
|
| D | img-ir-rev1.txt | 1 * ImgTec Infrared (IR) decoder version 1
3 This binding is for Imagination Technologies' Infrared decoder block,
|
| D | mediatek,mt7622-cir.yaml | 7 title: MediaTek Consumer Infrared Receiver on-SoC Controller
|
| D | allwinner,sun4i-a10-ir.yaml | 7 title: Allwinner A10 Infrared Controller
|
| D | rc.yaml | 7 title: Generic Infrared Remote Controller
|
| /Documentation/driver-api/media/ |
| D | rc-core.rst | 23 infrared-based remote controllers, there's no key release event. Instead,
26 However, most of the remote controllers use infrared (IR) to transmit signals.
27 As there are several protocols used to modulate infrared signals, one
29 system to support the infrared protocol used by the emitter.
31 The infrared transmission is done by blinking a infrared emitter using a
|
| D | maintainer-entry-profile.rst | 74 - Remote Controllers (infrared):
|
| /Documentation/devicetree/bindings/iio/temperature/ |
| D | melexis,mlx90614.yaml | 14 http://melexis.com/Infrared-Thermometer-Sensors/Infrared-Thermometer-Sensors/MLX90614-615.aspx
|
| D | ti,tmp006.yaml | 13 TI TMP006 - Infrared Thermopile Sensor in Chip-Scale Package.
|
| /Documentation/devicetree/bindings/iio/light/ |
| D | isl29018.yaml | 8 Intersil 29018/29023/29035 Ambient Light, Infrared Light, and Proximity Sensor
14 Ambient and infrared light sensing with proximity detection over an i2c
|
| /Documentation/devicetree/bindings/iio/proximity/ |
| D | vishay,vcnl3020.yaml | 7 title: Integrated Proximity Sensor With Infrared Emitter
14 that the infrared emitter is included in the package. It has 16-bit
|
| /Documentation/userspace-api/media/rc/ |
| D | rc-intro.rst | 9 Currently, most analog and digital devices have a Infrared input for
|
| D | rc-sysfs-nodes.rst | 19 Controller core and provides a sysfs interface for configuring infrared
|
| D | lirc-dev-intro.rst | 9 LIRC stands for Linux Infrared Remote Control. The LIRC device interface is
|
| /Documentation/driver-api/iio/ |
| D | core.rst | 76 and infrared spectrum.
110 sensor can have two channels, one for infrared light and one for both
111 infrared and visible light.
|
| /Documentation/devicetree/bindings/input/touchscreen/ |
| D | neonode,zforce.yaml | 7 title: Neonode infrared touchscreen controller
|
| /Documentation/misc-devices/ |
| D | apds990x.rst | 24 (infrared + visible light) and IR only. However, threshold comparisons happen
|
| /Documentation/driver-api/media/drivers/ |
| D | contributors.rst | 50 - for his LIRC infrared handler
|
| /Documentation/admin-guide/media/ |
| D | remote-controller.rst | 4 Infrared remote control support in video4linux drivers
|
| /Documentation/networking/ |
| D | phonet.rst | 20 - infrared,
|
| /Documentation/hwmon/ |
| D | it87.rst | 235 These chips are 'Super I/O chips', supporting floppy disks, infrared ports,
|
12