Searched full:manual (Results 1 – 25 of 332) sorted by relevance
12345678910>>...14
| /Documentation/arch/arm/ |
| D | sunxi.rst | 26 * User Manual
28 …http://dl.linux-sunxi.org/A10/A10%20User%20Manual%20-%20v1.20%20%282012-04-09%2c%20DECRYPTED%29.pdf
41 * User Manual
43 http://dl.linux-sunxi.org/A13/A13%20User%20Manual%20-%20v1.2%20%282013-01-08%29.pdf
57 * User Manual
59 http://dl.linux-sunxi.org/A20/A20%20User%20Manual%202013-03-22.pdf
67 * User Manual
69 http://dl.linux-sunxi.org/A23/A23%20User%20Manual%20V1.0%2020130830.pdf
78 * User Manual
80 …http://dl.linux-sunxi.org/A31/A3x_release_document/A31/IC/A31%20user%20manual%20V1.1%2020130630.pdf
[all …]
|
| /Documentation/arch/riscv/ |
| D | hwprobe.rst | 76 minimumNumber/maximumNumber, not minNum/maxNum") of the RISC-V ISA manual.
79 by version 2.2 of the RISC-V ISA manual.
82 version 1.0 of the RISC-V Vector extension manual.
158 as defined in the RISC-V ISA manual.
161 supported as defined in the RISC-V ISA manual.
164 is supported as defined in the RISC-V ISA manual.
167 defined in the RISC-V Vector manual starting from commit e2ccd0548d6c
171 defined in the RISC-V Vector manual starting from commit e2ccd0548d6c
175 defined in the RISC-V ISA manual starting from commit 056b6ff467c7
179 defined in the RISC-V ISA manual starting from commit 5618fb5a216b
[all …]
|
| /Documentation/devicetree/bindings/fpga/ |
| D | xlnx,fpga-selectmap.yaml | 39 config pin (referred to as PROGRAM_B in the manual)
44 config status pin (referred to as DONE in the manual)
50 (referred to as INIT_B in the manual)
55 chip select pin (referred to as CSI_B in the manual)
61 read/write select pin (referred to as RDWR_B in the manual)
|
| D | altera-passive-serial.txt | 15 - nconfig-gpios: config pin (referred to as nCONFIG in the manual)
16 - nstat-gpios: status pin (referred to as nSTATUS in the manual)
19 - confd-gpios: confd pin (referred to as CONF_DONE in the manual)
|
| D | xlnx,fpga-slave-serial.yaml | 41 config pin (referred to as PROGRAM_B in the manual)
46 config status pin (referred to as DONE in the manual)
52 (referred to as INIT_B in the manual)
|
| /Documentation/hwmon/ |
| D | oxp-sensors.rst | 19 and do not have manual control capabilities.
76 Read Write. Enable manual fan control. Write "1" to set to manual, write "0"
81 When pwm1_enable is set to "1" (manual) write any value in the range [0-255]
|
| D | nct7904.rst | 44 pwm[1-4]_enable R/W, 1/2 for manual or SmartFan mode
48 pwm[1-4] R/O in SmartFan mode, R/W in manual control mode
|
| D | nzxt-kraken3.rst | 30 for the manual control mode and 2 is for the liquid temp to PWM curve mode.
73 pwm1_enable Pump duty control mode (0: disabled, 1: manual, 2: curve)
75 pwm2_enable Fan duty control mode (0: disabled, 1: manual, 2: curve)
|
| /Documentation/gpu/ |
| D | vga-switcheroo.rst | 13 Manual switching and manual power control
17 :doc: Manual switching and manual power control
|
| /Documentation/driver-api/thermal/ |
| D | nouveau_thermal.rst | 62 Current fan management mode (NONE, MANUAL or AUTO);
78 * 1: The fan can be driven in manual (use pwm1 to change the speed);
82 Be sure to use the manual mode if you want to drive the fan speed manually
85 When operating in manual mode outside the vbios-defined
|
| /Documentation/maintainer/ |
| D | index.rst | 5 This document is the humble beginning of a manual for kernel maintainers.
7 additions to this manual.
|
| /Documentation/devicetree/bindings/arm/ |
| D | arm,scu.yaml | 18 - Cortex-A9: see DDI0407E Cortex-A9 MPCore Technical Reference Manual
20 - Cortex-A5: see DDI0434B Cortex-A5 MPCore Technical Reference Manual
|
| /Documentation/devicetree/bindings/reset/ |
| D | ti,tps380x-reset.yaml | 15 RESET signal if the voltage drops below a preset threshold or upon a manual
18 manual reset input is released.
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | samsung,pinctrl-pins-cfg.yaml | 21 manual and these values are programmed as-is into the pin pull up/down and
33 The pins should use lowercase names matching hardware manual, e.g. for
42 "samsung,pins" property should be picked from the hardware manual of the SoC
|
| /Documentation/devicetree/bindings/riscv/ |
| D | extensions.yaml | 192 riscv/zawrs") of riscv-isa-manual.
242 merged in the riscv-isa-manual by commit dbc79cf28a2 ("Initial seed
250 merged in the riscv-isa-manual by commit dbc79cf28a2 ("Initial seed
258 merged in the riscv-isa-manual by commit dbc79cf28a2 ("Initial seed
266 merged in the riscv-isa-manual by commit dbc79cf28a2 ("Initial seed
272 c732a4f39a4 ("Zcmop is ratified/1.0") of the riscv-isa-manual.
278 riscv-isa-manual.
284 version numbers for Zfh/Zfinx") of riscv-isa-manual.
291 riscv-isa-manual.
403 commit d8ab5c7 ("Zihintpause is ratified") of the riscv-isa-manual.
[all …]
|
| /Documentation/devicetree/bindings/clock/ |
| D | thead,th1520-clk-ap.yaml | 13 SoC reference manual
14 …s://openbeagle.org/beaglev-ahead/beaglev-ahead/-/blob/main/docs/TH1520%20System%20User%20Manual.pdf
|
| D | renesas,emev2-smu.yaml | 14 The System Management Unit is described in user's manual R19UH0037EJ1000_SMU.
42 "Serial clock generator" in fig. "Clock System Overview" of the manual,
76 fig. "Clock System Overview" of the manual.
|
| D | lpc1850-ccu.txt | 7 - Above text taken from NXP LPC1850 User Manual.
36 specific LPC part. Check the user manual for your specific part.
|
| /Documentation/sound/cards/ |
| D | joystick.rst | 44 manual: any address (e.g. 0x200)
49 manual: 0x200, 0x208, 0x210, 0x218
51 manual: any address (e.g. 0x200)
60 manual: 0x201, 0x202, 0x204, 0x205 [#f2]_
|
| /Documentation/ABI/testing/ |
| D | debugfs-driver-dcc | 13 This is the debugfs interface for manual software
32 can be read in case of a hardware crash or manual
125 on manual or crash induced triggers. Lists must
|
| /Documentation/arch/loongarch/ |
| D | irq-chip-model.rst | 182 in Section 7.4 of "LoongArch Reference Manual, Vol 1";
184 "Loongson 3A5000 Processor Reference Manual";
186 "Loongson 3A5000 Processor Reference Manual";
188 "Loongson 3A5000 Processor Reference Manual";
190 "Loongson 7A1000 Bridge User Manual";
192 "Loongson 7A1000 Bridge User Manual".
|
| /Documentation/gpu/amdgpu/display/ |
| D | index.rst | 47 #. Manual test
62 In terms of test setup for CI and manual tests, we usually use:
68 #. Most of the manual tests are conducted in the GNome but we also use KDE.
|
| /Documentation/devicetree/bindings/net/ |
| D | hisilicon-hns-dsaf.txt | 31 user manual.
44 depends on the hardware user manual.
46 value depends on the hardware user manual.
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | riscv,cpu-intc.yaml | 16 The RISC-V supervisor ISA manual specifies three interrupt sources that are
50 The interrupt sources are defined by the RISC-V supervisor ISA manual,
|
| /Documentation/devicetree/bindings/display/bridge/ |
| D | analogix,anx7625.yaml | 56 post cursor manual, increase the [Boost control] to increase
59 swing manual, increase [Swing control] setting to add Vp-p value
66 compensation manual, increase it can enhance IO driven strength
|
12345678910>>...14