Home
last modified time | relevance | path

Searched full:normally (Results 1 – 25 of 364) sorted by relevance

12345678910>>...15

/Documentation/devicetree/bindings/sound/
Dqcom,pm8916-wcd-analog-codec.yaml72 qcom,hphl-jack-type-normally-open:
75 True if the HPHL pin on the jack is NO (Normally Open), false if it's
76 NC (Normally Closed).
78 qcom,gnd-jack-type-normally-open:
81 True if the GND pin on the jack is NO (Normally Open), false if it's
82 NC (Normally Closed).
Dqcom,wcd93xx-common.yaml57 qcom,hphl-jack-type-normally-closed:
58 description: Indicates that HPHL jack switch type is normally closed
61 qcom,ground-jack-type-normally-closed:
62 description: Indicates that Headset Ground switch type is normally closed
Dqcom,wcd934x.yaml82 qcom,hphl-jack-type-normally-closed:
83 description: Indicates that HPHL jack switch type is normally closed
86 qcom,ground-jack-type-normally-closed:
87 description: Indicates that Headset Ground switch type is normally closed
220 qcom,hphl-jack-type-normally-closed;
221 qcom,ground-jack-type-normally-closed;
Dqcom,wcd938x.yaml48 qcom,hphl-jack-type-normally-closed;
49 qcom,ground-jack-type-normally-closed;
Dqcom,wcd939x.yaml66 qcom,hphl-jack-type-normally-closed;
67 qcom,ground-jack-type-normally-closed;
Dcirrus,lochnagar.yaml42 Master clock source for the sound card, should normally be set to
/Documentation/arch/arm/
Dporting.rst12 virtual address to a physical address. Normally, it is simply:
23 the time when you call the decompressor code. You normally call
87 Virtual start address of kernel, normally PAGE_OFFSET + 0x8000.
100 Normally, the vmalloc() area starts VMALLOC_OFFSET bytes above the
104 Offset normally incorporated into VMALLOC_START to provide a hole
107 of the mapped memory map) to be caught. Normally set to 8MB.
/Documentation/ABI/testing/
Dsysfs-class-led-trigger-oneshot26 normally off. If set to 1, blink off for delay_off ms, then
27 blink on for delay_on ms, leaving the LED normally on.
Dsysfs-memory-page-offline14 Normally it's the base page size of the kernel, but
39 Normally it's the base page size of the kernel, but
Dsysfs-class-power48 a fixed period. Normally devices will provide a fixed interval
55 Normally devices will provide a fixed interval in which they
115 normally be the internal temperature of the device itself
136 This is normally used for the charging scenario where
161 This is normally used for the charging scenario where user-space
278 notify user-space of the event. This is normally used for the
293 notify user-space of the event. This is normally used for the
472 Represents the charging status of the battery. Normally this
492 auto: Charge normally, respect thresholds
515 fixed period. Normally devices will provide a fixed interval in
[all …]
Dsysfs-platform-intel-wmi-sbl-fw-update7 Bootloader (SBL). This attribute normally has a value
Dsysfs-class-power-rt947127 datasheet for details. Normally controlled when TypeC/USBPD port integrated.
/Documentation/admin-guide/nfs/
Dnfsd-admin-interfaces.rst5 Note that normally these interfaces are used only by the utilities in
9 which is normally mounted at /proc/fs/nfsd/.
/Documentation/arch/x86/x86_64/
Dmachinecheck.rst11 Machine checks are organized in banks (normally associated with
19 from /dev/mcelog. Normally mcelog should be run regularly from a cronjob.
/Documentation/leds/
Dledtrig-oneshot.rst36 echo 1 > invert # set led as normally-on, turn the led on
44 echo 0 > invert # set led as normally-off, turn the led off
/Documentation/admin-guide/media/
Dcafe_ccic.rst36 - alloc_bufs_at_load: Normally, the driver will not allocate any DMA
48 buffers. Normally, the driver tries to use three buffers; on faster
/Documentation/hid/
Dhid-transport.rst59 I/O drivers normally provide hotplug detection or device enumeration APIs to the
103 send their input events on this channel. Outgoing events are normally
107 channel and are normally ignored. Instead, devices only send management
137 this is rarely done as OUTPUT reports are normally quite scarce. But devices are
156 Normally, HID core caches any device state so this request is not necessary
189 Transport drivers normally use the following procedure to register a new device
239 drivers can choose to setup their device in this callback. However, normally
/Documentation/userspace-api/media/cec/
Dcec-pin-error-inj.rst200 This setting changes the behavior of transmitting CEC messages. Normally
211 Don't set the EOM bit. Normally the last byte of the message has the EOM
214 handles this case. Normally receivers have a time-out after which
244 Normally the period of a data bit is between 2.05 and 2.75 milliseconds.
259 Normally the period of a data bit is between 2.05 and 2.75 milliseconds.
274 Make this start bit period shorter than allowed. Normally the period of
281 Make this start bit period longer than is valid. Normally the period of
/Documentation/timers/
Dno_hz.rst16 CONFIG_NO_HZ=n for older kernels). You normally will -not-
26 workloads, you will normally -not- want this option.
43 clock interrupts will normally be delivered any way because there
139 Normally, a CPU remains in adaptive-ticks mode as long as possible.
161 accommodate, they are normally round-robined so as to collect
287 and processes. This configuration normally involves binding
/Documentation/devicetree/bindings/fpga/
Daltr,freeze-bridge-controller.yaml14 normally.
/Documentation/i2c/
Di2c-protocol.rst61 Normally message is interrupted immediately if there is [NA] from the
95 like SCCB require that. Normally, you really don't want to get interrupted
Di2c-address-translators.rst23 - there is normally no need to select the child port; the alias used on the
76 address 0x10 and replies normally
/Documentation/i2c/busses/
Di2c-ismt.rst18 Allows changing of the bus speed. Normally, the bus speed is set by the BIOS
/Documentation/trace/
Dfunction-graph-fold.vim7 " as would normally appear on the line with the closing brace. Folded
/Documentation/hwmon/
Dtmp108.rst35 the TMP108 has a one-shot mode where the device is normally shut-down. When a

12345678910>>...15