Searched full:obtained (Results 1 – 25 of 189) sorted by relevance
12345678
37 Revision 1 value of SDRAM chip. Obtained from device datasheet.45 Revision 2 value of SDRAM chip. Obtained from device datasheet.54 Obtained from device datasheet.61 Obtained from device datasheet.68 cycles. Obtained from device datasheet.75 cycles. Obtained from device datasheet.82 of clock cycles. Obtained from device datasheet.89 Obtained from device datasheet.95 RAS-to-CAS delay in terms of number of clock cycles. Obtained from102 WRITE recovery time in terms of number of clock cycles. Obtained from[all …]
19 /sys/fs/cgroup/cpuacct.usage gives the CPU time (in nanoseconds) obtained20 by this group which is essentially the CPU time obtained by all the tasks31 can be obtained from g1/cpuacct.usage and the same is accumulated in35 CPU time obtained by the cgroup into user and system times. Currently
109 always be reported as active instead of being obtained from the modem116 always be reported as active instead of being obtained from the modem123 always be reported as active instead of being obtained from the modem130 be reported as inactive instead of being obtained from the modem status
41 always be reported as active instead of being obtained
42 Voltage readings provided by this driver are reported as obtained from the ADIN45 Current reading provided by this driver is reported as obtained from the Current
43 Voltage readings provided by this driver are reported as obtained from the ADC49 Current reading provided by this driver is reported as obtained from the ADC
5 Description: The file holds the serial number of the client device obtained17 obtained using a BHI (Boot Host Interface) register read after
32 be obtained from the buffer by:69 Those statistics are obtained from the :ref:`rkisp1_stats <rkisp1_stats>`73 ``rkisp1-config.h``. So the structure can be obtained from the buffer by:
50 coordinates are obtained using ``V4L2_SEL_TGT_COMPOSE_BOUNDS``. All90 cropping coordinates are obtained using ``V4L2_SEL_TGT_CROP_BOUNDS``.134 and the height of rectangles obtained using ``V4L2_SEL_TGT_CROP`` and
30 after another application obtained higher priority.
66 The luminance (Y') and color difference (Cb and Cr) are obtained with142 The luminance (Y') and color difference (Cb and Cr) are obtained with265 The luminance (Y') and color difference (Cb and Cr) are obtained with334 The luminance (Y') and color difference (Cb and Cr) are obtained with405 The luminance (Y') and color difference (Cb and Cr) are obtained with553 The luminance (Y') and color difference (Cb and Cr) are obtained with627 The luminance (Y') and color difference (Cb and Cr) are obtained with698 The luminance (Y') and color difference (Cb and Cr) are obtained with
25 CPU capacities are obtained by running a suitable benchmark. This binding makes36 CPU capacities are obtained by running the Dhrystone benchmark on each CPU at37 max frequency (with caches enabled). The obtained DMIPS score is then divided39 DMIPS/MHz are obtained. Such values are then normalized w.r.t. the highest40 score obtained in the system.
16 obtained during initial handshake with firmware.
21 The complete DMI information can be obtained using these two
80 (RO) The high frequency impedance value that can be obtained from battery88 (RO) The no-load voltage that can be obtained from battery fuel gauge in96 (RO) The battery discharge current capability obtained from battery fuel gauge in
43 Internally when this file is read, the additional CRC byte is also obtained51 Internally when this file is read, the additional CRC byte is also obtained
274 the autofs mount. The device number can be obtained from the mount options276 autofs_dev_ioct with the ioctlfd field set to the descriptor obtained288 with the ioctlfd field set to the descriptor obtained from the open306 ioctlfd field set to the descriptor obtained from the open call and321 ioctlfd field set to the descriptor obtained from the open call.330 ioctlfd field set to the descriptor obtained from the open call.358 ioctlfd field set to the descriptor obtained from the open call. In376 ioctlfd field set to the descriptor obtained from the open call and
10 Change the sensor HDR mode. A HDR picture is obtained by merging two
26 entity. The size of the pixel matrix can be obtained by getting the78 obtained from the following controls:
28 space obtained in one of the following ways:59 ``UFFDIO_*`` ``ioctl()``s used on a file descriptor obtained from60 ``userfaultfd()``, as fault addresses subsequently obtained by reading
26 a specific video mode. This can be obtained using the FBIOGET_FSCREENINFO32 specific video mode. This can be obtained using the FBIOGET_VSCREENINFO
24 The Binary MOF can be obtained by doing a WMI data block query. The result is
46 non-forgeable handler that must be obtained through a call to one of the111 For a function using multiple GPIOs all of those can be obtained with one call::378 * array_info - optional information obtained from gpiod_get_array()382 The descriptor array can be obtained using the gpiod_get_array() function392 descriptors may be obtained using any combination of gpiod_get() and402 array function matches the one obtained from gpiod_get_array() and array_info469 Freeing a GPIO obtained by one API with the other API is forbidden and an