Searched full:optionally (Results 1 – 25 of 207) sorted by relevance
123456789
| /Documentation/admin-guide/device-mapper/ |
| D | delay.rst | 6 and/or flushs and optionally maps them to different devices.
18 to write and flush operations on optionally different write_device with
19 optionally different sector offset
22 on/with optionally different flush_device/flush_offset.
|
| /Documentation/networking/devlink/ |
| D | devlink-region.rst | 15 Regions may optionally support triggering snapshots on demand.
27 Regions may optionally support capturing a snapshot on demand via the
34 Regions may optionally allow directly reading from their contents without a
|
| /Documentation/w1/slaves/ |
| D | w1_ds28e04.rst | 21 during memory accesses can optionally be enabled/disabled via the device
22 attribute "crccheck". The strong pull-up can optionally be enabled/disabled
|
| /Documentation/devicetree/bindings/mailbox/ |
| D | arm,mhuv3.yaml | 17 The controller can optionally support a varying number of extensions that, in
29 - Optionally receive acknowledgment of a Transfer from the Receiver
34 - Optionally acknowledge Transfers sent by the Sender
58 Optionally, data may be transmitted through an out-of-band shared memory
78 Optionally, data may be transmitted through an out-of-band shared memory
97 Optionally, additional data may be transmitted through an out-of-band shared
|
| /Documentation/devicetree/bindings/serial/ |
| D | brcm,bcm7271-uart.yaml | 32 description: The UART register block and optionally the DMA register blocks.
54 description: The UART interrupt and optionally the DMA interrupt.
|
| /Documentation/firmware-guide/acpi/ |
| D | extcon-intel-int3496.rst | 10 USB-otg port, as well as how it optionally can enable Vbus output on the
11 otg port and how it can optionally control the muxing of the data pins
|
| /Documentation/devicetree/bindings/mtd/ |
| D | atmel-dataflash.txt | 6 The device tree may optionally contain sub-nodes describing partitions of the
|
| D | orion-nand.txt | 15 The device tree may optionally contain sub-nodes describing partitions of the
|
| D | flctl-nand.txt | 17 The device tree may optionally contain sub-nodes describing partitions of the
|
| D | samsung-s3c2410.txt | 20 Each child device node may optionally contain a 'partitions' sub-node,
|
| D | hisi504-nand.txt | 24 Flash chip may optionally contain additional sub-nodes describing partitions of
|
| /Documentation/devicetree/bindings/timer/ |
| D | snps,arc-timer.txt | 3 - Can be optionally programmed to interrupt on Limit
|
| D | faraday,fttmr010.txt | 20 Optionally required properties:
|
| /Documentation/devicetree/bindings/arm/keystone/ |
| D | ti,sci.yaml | 26 This parent node may optionally have additional children nodes which describe
46 Specifies the debug messages memory mapped region that is optionally
|
| /Documentation/devicetree/bindings/gpio/ |
| D | gpio-adnp.txt | 13 The GPIO expander can optionally be used as an interrupt controller, in
|
| /Documentation/devicetree/bindings/pwm/ |
| D | pwm.yaml | 22 optionally a number of flags (defined in <dt-bindings/pwm/pwm.h>).
|
| /Documentation/devicetree/bindings/spi/ |
| D | spi-orion.txt | 12 This property can optionally have additional entries to configure
43 Example with SPI direct mode support (optionally):
|
| /Documentation/devicetree/bindings/rtc/ |
| D | brcm,brcmstb-waketimer.yaml | 15 optionally generate RTC alarm interrupts.
|
| /Documentation/devicetree/bindings/crypto/ |
| D | fsl-dcp.yaml | 29 must be supplied, optionally Secure IRQ can be present, but is currently
|
| /Documentation/devicetree/bindings/iommu/ |
| D | pkvm,pviommu.yaml | 36 iommu groups, it is optionally passed in the second field of "iommus", where
|
| /Documentation/devicetree/bindings/clock/ti/ |
| D | divider.txt | 43 unless the divider array is provided, min and max dividers. Optionally
47 This binding can also optionally provide support to the hardware autoidle
|
| /Documentation/filesystems/ext4/ |
| D | verity.rst | 27 with optionally appended signature blob.
|
| /Documentation/devicetree/bindings/mfd/ |
| D | brcm,twd.yaml | 15 registers layout). This block consists of: timers, watchdog and optionally a
|
| /Documentation/userspace-api/media/v4l/ |
| D | vidioc-prepare-buf.rst | 34 Applications can optionally call the :ref:`VIDIOC_PREPARE_BUF` ioctl to
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | adc-battery.yaml | 14 via ADC channels and optionally indicate that the battery is full by
|
123456789