Searched full:percentage (Results 1 – 25 of 77) sorted by relevance
1234
| /Documentation/devicetree/bindings/power/supply/ |
| D | richtek,rt9455.yaml | 29 richtek,end-of-charge-percentage:
33 below output_charge_current x end-of-charge-percentage, charge is terminated.
62 - richtek,end-of-charge-percentage
83 richtek,end-of-charge-percentage = <10>;
|
| D | cpcap-battery.yaml | 29 - description: low battery percentage interrupt
30 - description: critical battery percentage interrupt
|
| D | ti,lp8727.yaml | 44 End of Charge Percentage with the following mapping:
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-led | 14 LEDs within the group to a calculated percentage of what
17 The percentage is calculated for each grouped LED via
|
| D | sysfs-class-bdi | 42 percentage of the write-back cache to a particular device.
67 given percentage of the write-back cache. This is useful in
97 percentage of the write-back cache to a particular device
|
| D | sysfs-class-power-wilco | 18 A low and high threshold percentage is specified.
|
| D | sysfs-platform-ideapad-laptop | 36 This feature limits the maximum battery charge percentage to
|
| D | sysfs-block-bcache | 41 For backing devices: cache hits as a percentage.
92 backing device only takes place when more than this percentage
|
| /Documentation/devicetree/bindings/serial/ |
| D | nvidia,tegra20-hsuart.yaml | 61 List of entries providing percentage of baud rate adjustment within a range. Each entry
64 percentage mentioned here.
|
| /Documentation/devicetree/bindings/leds/irled/ |
| D | ir-spi-led.yaml | 30 Percentage of one period in which the signal is active.
|
| /Documentation/devicetree/bindings/clock/ |
| D | mediatek,mt8186-fhctl.yaml | 35 description: The percentage of spread spectrum clocking for one PLL.
|
| /Documentation/hwmon/ |
| D | hs3001.rst | 25 humidity is expressed as a percentage. In the sysfs interface, all values are
|
| D | shtc1.rst | 45 celsius, relative humidity is expressed as a percentage.
|
| D | sht4x.rst | 26 humidity is expressed as a percentage. In sysfs interface, all values are
|
| /Documentation/devicetree/bindings/cpufreq/ |
| D | cpufreq-dt.txt | 19 - voltage-tolerance: Specify the CPU voltage tolerance in percentage.
|
| /Documentation/leds/ |
| D | leds-lp3944.rst | 32 percentage of the period the led is on, from 0 to 100
|
| /Documentation/ABI/stable/ |
| D | sysfs-bus-usb | 52 compute the percentage of time that a device has been active.
57 will give an integer percentage. Note that this does not
|
| /Documentation/admin-guide/sysctl/ |
| D | vm.rst | 165 Contains, as a percentage of total available memory that contains free pages
200 Contains, as a percentage of total available memory that contains free pages
541 A percentage of the total pages in each zone. On Zone reclaim
543 than this percentage of pages in a zone are reclaimable slab pages.
559 This is a percentage of the total pages in each zone. Zone reclaim will
560 only occur if more than this percentage of pages are in a state that
563 If zone_reclaim_mode has the value 4 OR'd, then the percentage is compared
823 space is not permitted to exceed swap plus this percentage
1008 This percentage value controls the tendency of the kernel to reclaim
1029 It defines the percentage of the high watermark of a zone that will be
|
| /Documentation/mm/ |
| D | overcommit-accounting.rst | 33 The overcommit amount can be set via ``vm.overcommit_ratio`` (percentage)
|
| /Documentation/devicetree/bindings/sound/ |
| D | rockchip,rk3308-codec.yaml | 67 Voltage setting for the MICBIAS pins expressed as a percentage of
|
| /Documentation/driver-api/thermal/ |
| D | nouveau_thermal.rst | 64 Current PWM value (power percentage);
|
| /Documentation/gpu/ |
| D | drm-usage-stats.rst | 133 percentage utilization of the engine, whereas drm-engine-<keystr> only reflects
135 percentage of its maximum frequency.
|
| /Documentation/admin-guide/thermal/ |
| D | intel_powerclamp.rst | 278 cur_state allows user to set the desired idle percentage. Writing 0 to
281 actual and current idle percentage. This may not be the same value
282 set by the user in that current idle percentage depends on workload
|
| /Documentation/devicetree/bindings/phy/ |
| D | fsl,mxs-usbphy.yaml | 83 Current trimming value (as a percentage) of the 17.78 mA TX
|
| /Documentation/arch/x86/ |
| D | resctrl.rst | 142 The minimum memory bandwidth percentage which
147 percentage is allocated. The allocated
148 b/w percentage is rounded off to the next
164 the smallest percentage is applied
518 by indicating the percentage of total memory bandwidth.
520 The minimum bandwidth percentage value for each cpu model is predefined
538 1. User may *not* see increase in actual bandwidth when percentage
546 bandwidth of 100GBps although the percentage value specified is only 50%
547 << 100%. Hence increasing the bandwidth percentage will not yield any
552 2. Same bandwidth percentage may mean different actual bandwidth
[all …]
|
1234