Searched full:sdi (Results 1 – 21 of 21) sorted by relevance
| /Documentation/devicetree/bindings/iio/adc/ |
| D | adi,ad4000.yaml | 72 adi,sdi-pin: 74 enum: [ high, low, cs, sdi ] 75 default: sdi 77 Describes how the ADC SDI pin is wired. A value of "sdi" indicates that 78 the ADC SDI is connected to host SDO. "high" indicates that the ADC SDI 80 hard-wired low (GND). "cs" indicates that the ADC SDI pin is connected to 123 while the SDI line is high and the CNV line is low ("3-wire" mode) or the 124 SDI line is low and the CNV line is high ("4-wire" mode); or when the SDO 125 line goes high while the SDI and CNV lines are high (chain mode), 136 # The configuration register can only be accessed if SDI is connected to MOSI [all …]
|
| D | adi,ad7944.yaml | 48 line is used to initiate the conversion and the SDI line is connected to 57 device on the bus. In this mode, SDI is tied to VIO, and the CNV line 61 on wiring when multiple ADCs are used. In this mode, the SDI line of 62 one chip is tied to the SDO of the next chip in the chain and the SDI of 127 while the SDI line is high and the CNV line is low ('single' mode) or the 128 SDI line is low and the CNV line is high ('multi' mode); or when the SDO 129 line goes high while the SDI and CNV lines are high (chain mode),
|
| /Documentation/iio/ |
| D | ad4000.rst | 47 Omit the ``adi,sdi-pin`` property in device tree to select this mode. 58 +--->| SDI AD4000 SDO |-------->| SDI | 68 Another wiring configuration supported as "3-wire" mode has the SDI pin 74 Set the ``adi,sdi-pin`` device tree property to ``"high"`` to select this mode. 83 +--->| SDI AD4000 SDO |-------->| SDI | 100 +--->| SDI AD4000 SDO |-------->| SDI | 110 In datasheet "4-wire" mode, the controller CS line is connected to the ADC SDI 114 Set ``adi,sdi-pin`` to ``"cs"`` to select this mode. 126 +--->| SDI AD4000 SDO |-------->| SDI |
|
| D | ad7944.rst | 39 +--->| SDI AD7944 SDO |-------->| SDI | 61 +--->| SDI AD7944 SDO |-------->| SDI | 81 +--->| SDI AD7944 SDO |--->| SDI AD7944 SDO |-------->| SDI |
|
| D | ad4695.rst | 42 | SDI |<--------| SDO | 43 | SDO |-------->| SDI |
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | samsung,battery.yaml | 7 title: Samsung SDI Batteries 13 Samsung SDI (Samsung Digital Interface) batteries are all different versions
|
| /Documentation/devicetree/bindings/display/ti/ |
| D | ti,omap3-dss.txt | 20 - Port 1: SDI output 25 SDI Endpoint required properties:
|
| /Documentation/devicetree/bindings/display/panel/ |
| D | sony,acx565akm.yaml | 7 title: Sony ACX565AKM SDI Panel
|
| /Documentation/devicetree/bindings/firmware/ |
| D | qcom,scm.yaml | 101 qcom,sdi-enabled: 103 Indicates that the SDI (Secure Debug Image) has been enabled by TZ
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | marvell,kirkwood-pinctrl.txt | 55 mpp43 43 gpio, audio(sdi) 141 mpp27 27 gpio, ge1(rxd3), ts(mp7), tdm(spi-mosi), audio(sdi) 190 mpp27 27 gpio, ge1(rxd3), ts(mp7), tdm(spi-mosi), audio(sdi) 206 mpp43 43 gpio, ts(mp7), tdm(int), audio(sdi) 235 audio(spdifi), audio-1(sdi) 257 mpp27 27 gpio, ge1(rxd3), ts(mp7), tdm(spi-mosi), audio(sdi), 276 mpp43 43 gpio, ts(mp7), tdm(int), audio(sdi), lcd(d23)
|
| D | marvell,dove-pinctrl.txt | 67 pmic(sdi) Pin is used for PMIC SDI
|
| D | marvell,armada-370-pinctrl.txt | 26 mpp10 10 gpio, ge0(txctl), uart0(cts), tdm(fsync), audio(sdi) 90 audio(sdi)
|
| D | marvell,armada-375-pinctrl.txt | 18 mpp2 2 gpio, dev(ad4), ptp(evreq), led(c0), audio(sdi)
|
| D | marvell,armada-39x-pinctrl.txt | 74 mpp52 52 gpio, pcie0(rstout), tdm(int) [2], audio(sdi) [2], sd0(d6), i2c3(sck)
|
| D | marvell,armada-38x-pinctrl.txt | 70 mpp52 52 gpio, pcie0(rstout), tdm(int), audio(sdi), sd0(d6), ptp(clk)
|
| /Documentation/devicetree/bindings/net/dsa/ |
| D | microchip,ksz.yaml | 77 COL, CRS, LEDs, PME_N, NTRP_N, SDO and SDI/SDA/MDIO lines.
|
| /Documentation/devicetree/bindings/mmc/ |
| D | arm,pl18x.yaml | 205 clock-names = "sdi", "apb_pclk";
|
| /Documentation/userspace-api/media/v4l/ |
| D | vidioc-g-dv-timings.rst | 239 - The timings follow the SDI Timings standard.
|
| /Documentation/arch/arm/omap/ |
| D | dss.rst | 22 - SDI output
|
| /Documentation/sound/hd-audio/ |
| D | intel-multi-link.rst | 95 - mapping of SoundWire codecs to SDI ID bits
|
| /Documentation/admin-guide/media/ |
| D | bttv.rst | 1584 - SDI Silk 100 1585 - SDI Silk 200 SDI Input Card
|