Home
last modified time | relevance | path

Searched full:signaling (Results 1 – 25 of 58) sorted by relevance

123

/Documentation/driver-api/gpio/
Dintro.rst39 other value (notably, "open drain" signaling).
43 cases (to support bidirectional signaling). GPIO controllers may have
84 driven) signaling. That term applies to CMOS transistors; "open collector" is
93 don't. When you need open drain signaling but your hardware doesn't directly
103 The same logic can be applied to emulate open source signaling, by driving the
111 delays the rising edge of SCK, and the I2C master adjusts its signaling rate
/Documentation/devicetree/bindings/mmc/
Dnvidia,tegra20-sdhci.yaml114 signaling modes.
119 automatic calibration times out on a 1.8 V signaling mode.
124 signaling modes.
129 automatic calibration times out on a 3.3 V signaling mode.
142 signaling modes.
147 automatic calibration times out on a 1.8 V signaling mode.
152 signaling modes.
164 automatic calibration times out on a 3.3 V signaling mode.
/Documentation/devicetree/bindings/arm/tegra/
Dnvidia,tegra186-pmc.yaml91 state and signaling voltage. A pad can be either in active or
92 power down mode. The support for power state and signaling voltage
94 1.8 V signaling voltages are supported on pins where software
95 controllable signaling voltage switching is available.
149 signaling voltages: sdmmc2-hv, dmic-hv, sdmmc1-hv, sdmmc3-hv,
/Documentation/devicetree/bindings/mailbox/
Dst,stm32-ipcc.yaml10 The IPCC block provides a non blocking signaling mechanism to post and
12 It provides the signaling for N bidirectionnal channels. The number of
/Documentation/gpu/amdgpu/display/
Ddc-glossary.rst117 Display Power Management (Signaling)
225 Transition-Minimized Differential Signaling
/Documentation/devicetree/bindings/soc/tegra/
Dnvidia,tegra20-pmc.yaml255 signaling voltage. A pad can be either in active or power down mode.
256 The support for power state and signaling voltage configuration varies
257 depending on the pad in question. 3.3V and 1.8V signaling voltages are
258 supported on pins where software controllable signaling voltage
301 TEGRA_IO_PAD_VOLTAGE_3V3 to select between signaling voltages. The
307 None of the Tegra124 or Tegra132 pads support signaling voltage
309 power state configuration. Signaling voltage switching is supported
/Documentation/ABI/testing/
Dsysfs-devices-power_resources_wakeup7 require ACPI power resources for wakeup signaling.
Dsysfs-bus-wmi69 This file contains a boolean flag signaling if interacting with
78 This file contains a boolean flags signaling the data block
Devm73 be possible to enable metadata modification. Signaling that an
86 INTEGRITY_UNKNOWN. Loading keys and signaling EVM
Dsysfs-platform-chipidea-usb-otg10 be set to 1 by kernel in response to remote wakeup signaling
/Documentation/scheduler/
Dcompletion.rst40 - the signaling side through a call to complete() or complete_all().
43 Note that while initialization must happen first, the waiting and signaling
243 Signaling completions:
256 The signaling will work as expected even if completions are signaled before
271 Signaling completion from IRQ context is fine as it will appropriately
/Documentation/devicetree/bindings/net/
Dsff,sfp.yaml60 GPIO phandle and a specifier of the Rx Signaling Rate Select (AKA RS0)
67 GPIO phandle and a specifier of the Tx Signaling Rate Select (AKA RS1)
/Documentation/devicetree/bindings/i2c/
Di2c-arb-gpio-challenge.yaml32 * OUR_CLAIM: output from us signaling to other hosts that we want the bus
33 * THEIR_CLAIMS: output from others signaling that they want the bus
/Documentation/devicetree/bindings/display/bridge/
Dmicrochip,sam9x75-lvds.yaml13 The Low Voltage Differential Signaling Controller (LVDSC) manages data
/Documentation/devicetree/bindings/misc/
Dti,j721e-esm.yaml14 The ESM (Error Signaling Module) is an IP block on TI K3 devices
Difm-csi.txt7 of the interrupt line signaling frame valid events
/Documentation/leds/
Dledtrig-oneshot.rst5 This is a LED trigger useful for signaling the user of an event where there are
/Documentation/power/
Dpci.rst200 1.4. Wakeup Signaling
217 capable of signaling wakeup. The information on the connections between GPEs
239 a PCI device signaling wakeup). The GPEs used for notifying the kernel of
261 In principle the native PCI Express PME signaling may also be used on ACPI-based
266 the native PCI Express PME signaling cannot be used by the kernel in that case.
351 device from signaling wakeup.
372 PCI Express PME signaling and the ACPI GPE-based wakeup signaling described in
385 state from which it can signal wakeup. The exact method of signaling wakeup is
388 device for signaling wakeup and put it into the selected low-power state, the
393 not attempt to prepare the device for signaling wakeup or to put it into a
[all …]
/Documentation/devicetree/bindings/phy/
Dqcom,snps-eusb2-repeater.yaml13 eUSB2 repeater converts between eUSB2 and USB 2.0 signaling levels and
/Documentation/devicetree/bindings/sound/
Dinfineon,peb2466.yaml22 The PEB2466 codec also supports 28 gpios (signaling pins).
/Documentation/driver-api/
Di2c.rst12 I2C is a multi-master bus; open drain signaling is used to arbitrate
/Documentation/devicetree/bindings/soc/qcom/
Dqcom,rpm.yaml47 Three entries specifying the outgoing ipc bit used for signaling the RPM.
/Documentation/devicetree/bindings/usb/
Dmicrochip,usb5744.yaml13 (LS) USB signaling, offering complete coverage of all defined USB operating
/Documentation/devicetree/bindings/remoteproc/
Dqcom,smd-edge.yaml62 Three entries specifying the outgoing ipc bit used for signaling the
/Documentation/virt/geniezone/
Dintroduction.rst53 Ioeventfd is implemented using eventfd for signaling host VM that some IO

123