Searched full:third (Results 1 – 25 of 232) sorted by relevance
12345678910
| /Documentation/devicetree/bindings/net/ |
| D | broadcom-bcm87xx.txt | 11 address within the MMD, the third cell contains a mask to be ANDed
13 he result to yield the new register value. If the third cell has a
|
| D | cavium-mix.txt | 11 AGL registers. The third bank are the AGL registers shared by all
|
| D | aspeed,ast2600-mdio.yaml | 13 The ASPEED AST2600 MDIO controller is the third iteration of ASPEED's MDIO
|
| /Documentation/admin-guide/cgroup-v1/ |
| D | blkio-controller.rst | 141 third field specifies the disk time allocated to group in
147 third field specifies the number of sectors transferred by the
154 device, third field specifies the operation type and the fourth field
161 device, third field specifies the operation type and the fourth field
174 specify the major and minor number of the device, third field
190 minor number of the device, third field specifies the operation type
242 and minor number of the device and third field specifies the number
287 device, third field specifies the operation type and the fourth field
294 device, third field specifies the operation type and the fourth field
|
| /Documentation/admin-guide/gpio/ |
| D | gpio-mockup.rst | 36 the second 16 and the third 4. The base GPIO for the third chip is set
|
| /Documentation/devicetree/bindings/pwm/ |
| D | vt8500-pwm.txt | 7 the cells format. The only third cell flag supported by this binding is
|
| D | pwm-tiehrpwm.yaml | 35 The only third cell flag supported by this binding is PWM_POLARITY_INVERTED.
|
| D | pwm-tiecap.yaml | 36 The only third cell flag supported by this binding is PWM_POLARITY_INVERTED.
|
| /Documentation/trace/ |
| D | events-power.rst | 83 The third parameter is the current QoS value to update.
95 The third parameter is value to be added/updated/removed.
|
| /Documentation/devicetree/bindings/mailbox/ |
| D | arm,mhuv3.yaml | 165 extension type, the second is for the channel number while the third
170 Extension type for DBE is DBE_EXT and the third parameter represents the
172 Extension type for FCE is FCE_EXT, third parameter unused.
173 Extension type for FE is FE_EXT, third parameter unused.
|
| /Documentation/devicetree/bindings/dma/ |
| D | nxp,lpc3220-dmamux.yaml | 31 Third cell represents mux value for the request.
|
| /Documentation/devicetree/bindings/clock/ |
| D | allwinner,sun4i-a10-pll6-clk.yaml | 20 regular PLL output, the third is a PLL output at twice the rate.
|
| /Documentation/hwmon/ |
| D | emc2103.rst | 33 The 2103-2 and 2103-4 variants have a third temperature sensor, which can
|
| D | ltc2992.rst | 22 Two ADCs simultaneously measure each supply's current. A third ADC monitors
|
| /Documentation/devicetree/bindings/watchdog/ |
| D | marvel.txt | 17 - reg : A third entry is mandatory and should contain the
|
| /Documentation/input/devices/ |
| D | alps.rst | 54 with 88-07 followed by a third byte. This third byte can be used to determine
67 address of the register being read, and the third contains the value of the
158 associated with touchpad events, and the third is associated with trackstick
240 MT position can only be updated for every third ST position update, and
241 the count of contact points can only be updated every third packet as
|
| /Documentation/devicetree/bindings/nvmem/ |
| D | brcm,nvram.yaml | 56 description: Third Ethernet interface's MAC address
|
| /Documentation/networking/dsa/ |
| D | lan9303.rst | 6 the two external ethernet ports. The third port is an RMII/MII interface to a
|
| /Documentation/devicetree/bindings/gpio/ |
| D | airoha,en7523-gpio.yaml | 27 The second and third tuple point to the direction registers
|
| /Documentation/cpu-freq/ |
| D | core.rst | 58 The third argument, a ``void *pointer``, points to a struct cpufreq_policy
73 The third argument is a struct cpufreq_freqs with the following
|
| /Documentation/sound/designs/ |
| D | oss-emulation.rst | 89 For example, to map the third PCM device (``hw:0,2``) to /dev/adsp0,
96 two entries separated by comma. For example, to map the third PCM
112 For example, to assign the third MIDI device on the first card to
282 the base-string of the corresponding ALSA control, and the third the
|
| /Documentation/admin-guide/ |
| D | devices.txt | 203 32 = /dev/sdc Third SCSI disk whole disk
350 214 = /dev/watchdogs/2 Third watchdog device
445 34 = /dev/midi02 Third MIDI port
599 27 block Third Matsushita (Panasonic/SoundBlaster) CD-ROM
608 2 = /dev/staliomem2 Third Stallion card I/O memory
624 32 = /dev/adc Third ACSI disk whole disk
712 33 block Third IDE hard disk/CD-ROM interface
740 2 = /dev/midi2 Third MIDI port, kernel timed
744 66 = /dev/rmidi2 Third MIDI port, untimed
748 130 = /dev/smpte2 Third MIDI port, SMPTE timed
[all …]
|
| /Documentation/devicetree/bindings/reset/ |
| D | intel,rcu-gw.yaml | 37 Third cell is bit offset in reset status register.
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | allwinner,sun6i-a31-r-intc.yaml | 21 the third cell is the trigger type as defined in interrupt.txt in this
|
| /Documentation/scheduler/ |
| D | sched-nice-design.rst | 82 A third complaint against Linux's nice level support was that negative
108 The third complaint (of negative nice levels not being "punchy" enough
|
12345678910