Searched full:units (Results 1 – 25 of 255) sorted by relevance
1234567891011
| /Documentation/devicetree/bindings/powerpc/fsl/ |
| D | srio-rmu.txt | 22 length of the SRIO configuration registers for message units
23 and doorbell units.
53 length of the SRIO configuration registers for message units
54 and doorbell units.
83 length of the SRIO configuration registers for message units
84 and doorbell units.
113 length of the SRIO configuration registers for message units
114 and doorbell units.
|
| /Documentation/userspace-api/media/v4l/ |
| D | vidioc-s-hw-freq-seek.rst | 97 units of 62.5 kHz, or if the struct
99 ``V4L2_TUNER_CAP_LOW`` flag set, in units of 62.5 Hz or if the
101 the ``V4L2_TUNER_CAP_1HZ`` flag set, in units of 1 Hz. If
106 in units of 62.5 kHz, or if the struct
108 ``V4L2_TUNER_CAP_LOW`` flag set, in units of 62.5 Hz or if the
110 the ``V4L2_TUNER_CAP_1HZ`` flag set, in units of 1 Hz. If
|
| D | vidioc-g-modulator.rst | 89 - The lowest tunable frequency in units of 62.5 KHz, or if the
90 ``capability`` flag ``V4L2_TUNER_CAP_LOW`` is set, in units of
92 set, in units of 1 Hz.
95 - The highest tunable frequency in units of 62.5 KHz, or if the
96 ``capability`` flag ``V4L2_TUNER_CAP_LOW`` is set, in units of
98 set, in units of 1 Hz.
|
| D | vidioc-enum-freq-bands.rst | 81 - :cspan:`2` The lowest tunable frequency in units of 62.5 kHz, or
82 if the ``capability`` flag ``V4L2_TUNER_CAP_LOW`` is set, in units
87 - :cspan:`2` The highest tunable frequency in units of 62.5 kHz,
89 units of 62.5 Hz, for this frequency band. A 1 Hz unit is used
|
| D | vidioc-g-tuner.rst | 102 - :cspan:`1` The lowest tunable frequency in units of 62.5 kHz, or
103 if the ``capability`` flag ``V4L2_TUNER_CAP_LOW`` is set, in units
105 is set, in units of 1 Hz. If multiple frequency bands are
110 - :cspan:`1` The highest tunable frequency in units of 62.5 kHz,
112 units of 62.5 Hz, or if the ``capability`` flag
113 ``V4L2_TUNER_CAP_1HZ`` is set, in units of 1 Hz. If multiple
221 - When set, tuning frequencies are expressed in units of 62.5 Hz
295 - When set, tuning frequencies are expressed in units of 1 Hz
|
| D | ext-ctrls-colorimetry.rst | 89 display in units of 0.0001 cd/m\ :sup:`2`.
93 display in units of 0.0001 cd/m\ :sup:`2`.
|
| /Documentation/devicetree/bindings/powerpc/4xx/ |
| D | cpm.txt | 16 - unused-units : specifier consist of one cell. For each
34 standby only class 2 and 3 units are set.
48 unused-units = <0x00000100>;
|
| /Documentation/driver-api/ |
| D | pwrseq.rst | 29 enable a set of regulators, another may enable a specific GPIO. Units can
30 define dependencies in the form of other units that must be enabled before
35 A target is a set of units (composed of the "final" unit and its
66 (units) and define their dependencies. They can then expose named targets that
|
| /Documentation/devicetree/bindings/rng/ |
| D | sparc_sun_oracle_rng.txt | 18 rng-#units: 00000002
25 rng-#units: 00000003
|
| /Documentation/ABI/testing/ |
| D | sysfs-firmware-opal-powercap | 22 possible powercap in Watt units
25 possible powercap in Watt units
|
| D | sysfs-block-bcache | 49 units (i.e. echo 10M > sequntial_cutoff).
57 readable units.
120 For a cache, bucket size in human readable units, as set at
149 For a cache, total amount of data in human readable units
156 For a cache, sum of all btree writes in human readable units.
|
| D | sysfs-bus-iio-dac-ltc2688 | 37 Sets the dither signal frequency. Units are in Hz.
49 Sets the dither signal phase. Units are in Radians.
|
| D | sysfs-bus-iio | 152 unique to allow association with event codes. Units after
168 is required is a consistent labeling. Units after application
180 unique to allow association with event codes. Units after
189 unique to allow association with event codes. Units after
196 Raw capacitance measurement from channel Y. Units after
207 is required is a consistent labeling. Units after application
225 _raw units, this is the value that the zero point on the
243 less measurements. Units after application of scale and offset
261 Has all of the equivalent parameters as per voltageY. Units
281 Units after application of scale and offset are m/s^2.
[all …]
|
| D | sysfs-class-rtc-rtc0-device-rtc_calibration | 11 The range of the attribute is -127 to +127 in units of
|
| /Documentation/devicetree/bindings/crypto/ |
| D | fsl-sec2.txt | 15 - fsl,exec-units-mask : The bitmask representing what execution units
63 fsl,exec-units-mask = <0xfe>;
|
| /Documentation/usb/ |
| D | mass-storage.rst | 10 multiple logical units (LUNs). Backing storage for each LUN is
102 The default value for non-CD-ROM logical units is false; for
103 logical units simulating CD-ROM it is forced to true.
108 Write10 and Write12 commands sent to given logical units.
125 This parameter specifies number of logical units the gadget will
133 If this parameter is not present, the number of logical units will
230 for all logical units whereas in MSG they accept a list of y/n
|
| /Documentation/filesystems/ext4/ |
| D | bigalloc.rst | 10 it is desirable to be able to allocate disk blocks in units of multiple
31 units of clusters instead of blocks” to the extent tree, though it is
|
| /Documentation/networking/devlink/ |
| D | sfc.rst | 24 control units, this is the SUC control unit's firmware version.
28 control units, this is the CMC control unit's firmware version.
|
| /Documentation/devicetree/bindings/i2c/ |
| D | st,sti-i2c.yaml | 40 deglitch circuit. In units of us.
45 deglitch circuit. In units of us.
|
| /Documentation/ABI/stable/ |
| D | sysfs-bus-firewire | 20 What: /sys/bus/firewire/devices/fw[0-9]+/units
29 units
30 Summary of all units present in an IEEE 1394 node.
|
| /Documentation/input/ |
| D | multi-touch-protocol.rst | 236 surface units. If the surface has an X times Y resolution, the largest
240 The length, in surface units, of the minor axis of the contact. If the
244 The length, in surface units, of the major axis of the approaching
250 The length, in surface units, of the minor axis of the approaching
259 The pressure, in arbitrary units, on the contact area. May be used instead
263 If the resolution is zero, the pressure data is in arbitrary units.
264 If the resolution is non-zero, the pressure data is in units/gram. See
268 The distance, in surface units, between the contact and the surface. Zero
|
| /Documentation/i2c/busses/ |
| D | i2c-mlxcpld.rst | 36 units).
39 (in LPC_CLK units)
|
| /Documentation/hid/ |
| D | hid-sensor.rst | 183 │ │ │ ├── feature-0-200316-units
191 │ │ │ ├── feature-1-200201-units
199 │ │ │ ├── input-0-200201-units
207 │ │ │ ├── input-1-200202-units
222 feature-0-200316-units:25
|
| /Documentation/power/ |
| D | swsusp-and-swap-files.rst | 23 units.
35 offset, in <PAGE_SIZE> units, from the beginning of the partition which
|
| /Documentation/admin-guide/media/ |
| D | si476x.rst | 56 0x08 hicut HiCut cutoff frequency in units of
58 0x09 hiblend HiBlend cutoff frequency in units
137 0x14 freqoff Signed frequency offset in units of
150 0x26 pilotdev Pilot deviation in units of 100 Hz
|
1234567891011