Searched full:activated (Results 1 – 25 of 119) sorted by relevance
12345
| /Documentation/ABI/testing/ |
| D | sysfs-driver-ccp | 73 whether the HSP TPM has been activated.
75 0: Not activated or present
76 1: Activated
|
| D | sysfs-class-wakeup | 19 activated.
|
| /Documentation/devicetree/bindings/usb/ |
| D | atmel-usb.txt | 17 activated for the bus to be powered.
19 activated for the overcurrent detection.
71 activated for the bus to be powered.
|
| D | pxa-usb.txt | 43 - gpio activated to control the USB D+ pullup (see gpio.txt)
|
| /Documentation/devicetree/bindings/net/can/ |
| D | grcan.txt | 25 a bug workaround is activated.
|
| /Documentation/ABI/obsolete/ |
| D | sysfs-driver-hid-roccat-arvo | 40 When written, the given buttons are activated/deactivated
52 When written, the key is activated/deactivated immediately.
|
| /Documentation/leds/ |
| D | leds-lm3556.rst | 23 CONTROL REGISTER(0x09).Flash mode is activated by the ENABLE REGISTER(0x0A),
51 REGISTER(0x09).Torch Mode is activated by the ENABLE REGISTER(0x0A) or by the
|
| D | ledtrig-oneshot.rst | 20 The trigger can be activated from user space on led class devices as shown
|
| D | ledtrig-usbport.rst | 32 This trigger can be activated from user space on led class devices as shown
|
| D | ledtrig-transient.rst | 69 transient trigger is activated these properties are set to default values.
80 1 when activated, 0 when deactivated.
|
| /Documentation/devicetree/bindings/spi/ |
| D | cdns,qspi-nor-peripheral-props.yaml | 29 Delay in nanoseconds between one chip select being de-activated
|
| /Documentation/devicetree/bindings/sound/ |
| D | ti,tlv320adc3xxx.yaml | 91 In this mode, when the pin is activated, it will be set to the voltage
101 In this mode, when the pin is activated, it will be set to the voltage
|
| /Documentation/admin-guide/device-mapper/ |
| D | dm-queue-length.rst | 16 the default value, see the activated table.
|
| /Documentation/devicetree/bindings/display/ |
| D | st,stm32-ltdc.yaml | 43 Note: These 2 endpoints cannot be activated simultaneously.
|
| /Documentation/networking/ |
| D | tcp-thin.rst | 40 they must be specifically activated by the application using the
|
| /Documentation/arch/s390/ |
| D | driver-model.rst | 161 activated via the 'online' attribute. The driver should finally
170 - the device to be activated. The common layer has
175 de-activated via the 'online' attribute. The driver should shut
|
| /Documentation/devicetree/bindings/net/ |
| D | cdns,macb.yaml | 120 When the receive partial store and forward mode is activated,
124 that need to be filled, before the forwarding process is activated.
|
| /Documentation/fb/ |
| D | arkfb.rst | 24 * text mode (activated by bpp = 0)
|
| D | vt8623fb.rst | 22 * text mode (activated by bpp = 0)
|
| /Documentation/devicetree/bindings/iommu/ |
| D | arm,smmu-v3.yaml | 44 - gerror # Global Error activated
|
| /Documentation/networking/device_drivers/ethernet/intel/ |
| D | ixgbevf.rst | 18 that can only be activated on kernels that support SR-IOV.
|
| D | igbvf.rst | 17 function devices that can only be activated on kernels that support SR-IOV.
|
| /Documentation/features/sched/membarrier-sync-core/ |
| D | arch-support.txt | 27 # The serialization in switch_mm() is activated by prepare_sync_core_cmd().
|
| /Documentation/core-api/irq/ |
| D | irq-affinity.rst | 17 to all non-active IRQs. Once IRQ is allocated/activated its affinity bitmask
|
| /Documentation/devicetree/bindings/reset/ |
| D | reset.txt | 23 the DT node of each affected HW block, since if activated, an unrelated block
|
12345