Searched full:around (Results 1 – 25 of 337) sorted by relevance
12345678910>>...14
| /Documentation/devicetree/bindings/display/panel/ |
| D | samsung,lms397kf04.yaml | 9 description: The datasheet claims this is based around a display controller
30 usually around 3.0 V
34 around 1.8 V
44 maximum 300 ns minimum cycle which gives around 3 MHz max frequency
|
| D | samsung,s6d27a1.yaml | 37 usually around 3.0 V
41 around 1.8 V
|
| D | samsung,lms380kf01.yaml | 38 usually around 3.0 V
42 around 1.8 V
|
| D | sony,acx424akp.yaml | 9 description: The Sony ACX424AKP and ACX424AKM are panels built around
|
| D | samsung,s6d7aa0.yaml | 42 panels, and is usually somewhere around 3.3-5v.
|
| /Documentation/sphinx/ |
| D | kernellog.py | 4 # only goes back to 1.6. So here's a wrapper layer to keep around for
7 # We don't support 1.4 anymore, but we'll keep the wrappers around until
|
| /Documentation/mm/ |
| D | z3fold.rst | 20 compression ratio goes to around 2.7x while zbud's one is around 1.7x.
|
| /Documentation/hwmon/ |
| D | bpa-rs600.rst | 69 temp1_input Measured temperature around input connector
72 temp2_input Measured temperature around output connector
|
| /Documentation/devicetree/bindings/phy/ |
| D | mediatek,mt7988-xfi-tphy.yaml | 43 problem in 10GBase-R mode which needs a work-around in the driver.
44 This flag enables a work-around adjusting an analog phy setting and
|
| /Documentation/process/ |
| D | 6.Followthrough.rst | 37 still be around and under development a decade from now.
58 to get around a problem actually needs to become a generalized
83 around.
92 around. So it is always a good idea to remind reviewers of previously
188 it with the assumption that you will not be around to maintain it
208 eventually flow around you and get into the mainline anyway. In the Linux
|
| /Documentation/devicetree/bindings/net/ |
| D | mdio.yaml | 72 broken-turn-around:
76 the turn around line low at end of the control phase of the
|
| /Documentation/driver-api/usb/ |
| D | error-codes.rst | 71 some problem that could not be worked around.
111 prescribed bus turn-around time
116 prescribed bus turn-around time
127 prescribed bus turn-around time. This error
173 be worked around, such as a physical
|
| /Documentation/ABI/testing/ |
| D | sysfs-bus-iio-ad9739a | 11 increasing the power of the images centered around
|
| D | sysfs-bus-iio-adc-envelope-detector | 25 input signal is centered around the maximum value of the
|
| /Documentation/filesystems/ |
| D | splice.rst | 8 splice is a method for moving blocks of data around inside the kernel,
|
| /Documentation/arch/arm/ |
| D | netwinder.rst | 6 to run Linux. It is based around the StrongARM RISC processor,
7 DC21285 PCI bridge, with PC-type hardware glued around it.
|
| /Documentation/driver-api/driver-model/ |
| D | design-patterns.rst | 43 state around to all functions that need access to the state and its members.
46 pass around a pointer to struct foo like this::
|
| /Documentation/timers/ |
| D | timekeeping.rst | 31 n bits which count from 0 to (2^n)-1 and then wraps around to 0 and start over.
76 Since a 32-bit counter at say 100 MHz will wrap around to zero after some 43
80 code knows when the counter will wrap around and can insert the necessary
155 drift between the CPUs on the system. The kernel can work around this by
|
| /Documentation/accounting/ |
| D | taskstats-struct.rst | 108 * xxx_delay_total wraps around to zero on overflow
134 * and wraps around to zero silently on overflow
142 * and wraps around to zero silently on overflow
|
| /Documentation/admin-guide/media/ |
| D | avermedia.rst | 32 The DVB-T card is based around the BT878 chip which is a very
50 I get around to this, I'll update the document with whatever I
|
| /Documentation/usb/ |
| D | ohci.rst | 32 work on while the OS is getting around to the relevant IRQ processing.
|
| /Documentation/devicetree/bindings/clock/ |
| D | fsl,plldig.yaml | 34 the requested frequency. To work around this restriction the user may specify
|
| /Documentation/scsi/ |
| D | scsi-changer.rst | 25 changer device this is a "don't care", he *only* shuffles around the
34 media transport this one shuffles around the media, i.e. the
165 I wrote this driver using the famous mailing-patches-around-the-world
|
| /Documentation/devicetree/bindings/iio/ |
| D | mount-matrix.txt | 131 device on a flat surface and spin it around the z axis (such as rotating a
190 compensate by performing a -30 degrees rotation around the X axis:
196 The sensor is flipped 180 degrees (Pi radians) around the Z axis, i.e. mounted
|
| /Documentation/devicetree/bindings/spi/ |
| D | brcm,bcm63xx-spi.yaml | 18 transaction to some SPI devices prematurely. The issue can be worked around by
|
12345678910>>...14