Searched full:blinking (Results 1 – 20 of 20) sorted by relevance
| /Documentation/admin-guide/ |
| D | vga-softcursor.rst | 9 tricks: you can make your cursor look like a non-blinking red block,
40 on highlight (or sometimes blinking -- it depends on the configuration
52 To get normal blinking underline, use::
56 To get blinking block, use::
60 To get red non-blinking block, use::
|
| /Documentation/leds/ |
| D | leds-cht-wcove.rst | 35 This is just like how blinking works in the LED subsystem,
36 for both sw and hw blinking the brightness can also be changed
37 while blinking. Breathing on this hw really is just a variant
38 mode of blinking.
|
| D | ledtrig-oneshot.rst | 13 event, while in the latter it keeps blinking at constant rate, as to signal
40 echo 1 > shot # led starts blinking, ignored if already blinking
|
| D | leds-class.rst | 126 blinking,
132 blinking, returns -EBUSY if software blink fallback is enabled.
155 blink_set() function (see <linux/leds.h>). To set an LED to blinking,
159 To turn off blinking, use the API function led_brightness_set()
161 timers that may have been required for blinking.
163 The blink_set() function should choose a user friendly blinking value
170 hardware blinking function, if any.
229 device for the trigger as the source for blinking
|
| D | leds-lp55xx.rst | 90 For example, run blinking pattern in engine #1 of LP5521::
98 For example, run blinking pattern in engine #3 of LP55231
109 To start blinking patterns in engine #2 and #3 simultaneously::
192 /* mode_1: blinking data */
219 echo 1 > /sys/bus/i2c/devices/xxxx/led_pattern # red blinking LED pattern
|
| D | leds-lp5562.rst | 49 For example, run blinking green channel pattern::
58 To run a blinking white pattern::
|
| D | leds-blinkm.rst | 13 Also you can store blinking sequences as "scripts" in
|
| D | leds-mlxcpld.rst | 117 Driver supports HW blinking at 3Hz and 6Hz frequency (50% duty cycle).
|
| /Documentation/devicetree/bindings/leds/ |
| D | leds-el15203000.txt | 6 The board manages 3 LEDs and supports predefined blinking patterns
10 Doesn't have any hardware blinking pattern.
13 encoded with symbol 'S' (hex code 0x53). Supports blinking breathing pattern.
|
| D | nxp,pca963x.yaml | 44 Use hardware blinking instead of software blinking
|
| D | leds-ns2.txt | 11 - modes-map: A mapping between LED modes (off, on or SATA activity blinking) and
|
| D | leds-spi-byte.txt | 13 accelerated blinking) might can be supported too.
|
| D | leds-bcm63138.yaml | 17 also includes limited support for hardware blinking.
|
| D | common.yaml | 16 blinking patterns, flash timeout, flash faults and external flash strobe mode.
|
| /Documentation/driver-api/media/ |
| D | rc-core.rst | 31 The infrared transmission is done by blinking a infrared emitter using a
|
| /Documentation/driver-api/80211/ |
| D | mac80211-advanced.rst | 12 Mac80211 supports various ways of blinking LEDs. Wherever possible,
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-led-trigger-netdev | 75 If 1, the LED blinking in requested mode is offloaded to
|
| D | sysfs-bus-pci | 572 different colors or blinking patterns for the indications,
574 indication is usually presented as one or two LEDs blinking at
|
| /Documentation/fb/ |
| D | matroxfb.rst | 211 noblink disables cursor blinking. Cursor in text mode always blinks (hw
213 blink enables cursor blinking. It is default.
|
| /Documentation/networking/ |
| D | arcnet-hardware.rst | 1240 blinking. I don't know what 0x3D0 is for though. I recommend using
|