Home
last modified time | relevance | path

Searched full:burst (Results 1 – 25 of 77) sorted by relevance

1234

/Documentation/devicetree/bindings/ata/
Dceva,ahci-1v84.yaml49 - description: CIBGN - COMINIT Burst Gap Nominal.
50 - description: CIBGMX - COMINIT Burst Gap Maximum.
51 - description: CIBGMN - COMINIT Burst Gap Minimum.
60 - description: CWBGMN - COMWAKE Burst Gap Minimum.
61 - description: CWBGMX - COMWAKE Burst Gap Maximum.
62 - description: CWBGN - COMWAKE Burst Gap Nominal.
65 ceva,p0-burst-params:
68 Burst timing value for COM parameter for port 0.
70 ceva,p0-burst-params = /bits/ 8 <BMX BNM SFD PTST>;
72 - description: BMX - COM Burst Maximum.
[all …]
/Documentation/devicetree/bindings/net/
Dlantiq,etop-xway.yaml32 lantiq,tx-burst-length:
35 TX programmable burst length.
38 lantiq,rx-burst-length:
41 RX programmable burst length.
51 - lantiq,tx-burst-length
52 - lantiq,rx-burst-length
65 lantiq,tx-burst-length = <8>;
66 lantiq,rx-burst-length = <8>;
Dsamsung-sxgbe.txt15 - samsung,pbl: Integer, Programmable Burst Length.
17 - samsung,burst-map: Integer, Program the possible bursts supported by sxgbe
18 This is an integer and represents allowable DMA bursts when fixed burst.
19 Allowable range is 0x01-0x3F. When this field is set fixed burst is enabled.
20 When fixed length is needed for burst mode, it can be set within allowable
48 samsung,burst-map = <0x20>
Dsnps,dwmac.yaml180 * snps,blen, this is a vector of supported burst length.
181 * snps,fb, fixed-burst
182 * snps,mb, mixed-burst
183 * snps,rb, rebuild INCRx Burst
442 Programmable Burst Length (tx and rx)
448 Tx Programmable Burst Length. If set, DMA tx will use this
455 Rx Programmable Burst Length. If set, DMA rx will use this
466 snps,fixed-burst:
469 Program the DMA to use the fixed burst mode
471 snps,mixed-burst:
[all …]
Dsnps,dwc-qos-ethernet.txt113 - snps,burst-map: Bitmap of allowed AXI burst lengths, with the LSB
115 - snps,txpbl: DMA Programmable burst length for the TX DMA
116 - snps,rxpbl: DMA Programmable burst length for the RX DMA
153 snps,burst-map = <0x7>;
/Documentation/devicetree/bindings/dma/
Drenesas,nbpfaxi.txt26 - max-burst-mem-read: limit burst size for memory reads
28 than using the maximum burst size allowed by the hardware's buffer size.
29 - max-burst-mem-write: limit burst size for memory writes
31 than using the maximum burst size allowed by the hardware's buffer size.
32 If both max-burst-mem-read and max-burst-mem-write are set, DMA_MEM_TO_MEM
Dintel,ldma.yaml36 The third cell is the burst length of the channel.
69 instead of the whole burst.
79 Enable RX dynamic burst write. When it is enabled, the DMA does RX dynamic burst;
80 if it is disabled, the DMA RX will still support programmable fixed burst size of 2,4,8,16.
Dimg-mdc-dma.txt13 - img,max-burst-multiplier: Must be the maximum supported burst size multiplier.
14 The maximum burst size is this value multiplied by the hardware-reported bus
46 img,max-burst-multiplier = <16>;
Dsnps,dma-spear1340.yaml132 snps,max-burst-len:
135 Maximum length of the burst transactions supported by the controller.
136 This property defines the upper limit of the run-time burst setting
137 (CTLx.SRC_MSIZE/CTLx.DST_MSIZE fields) so the allowed burst length
138 will be from 1 to max-burst-len words. It's an array property with one
183 snps,max-burst-len = <16 16 4 4 4 4 4 4>;
Dsnps,dw-axi-dmac.yaml93 snps,axi-max-burst-len:
95 Restrict master AXI burst length by value specified in this property.
96 If this property is missing the maximum AXI burst length supported by
154 snps,axi-max-burst-len = <16>;
Darm-pl08x.yaml71 memcpy-burst-size:
117 memcpy-burst-size = <256>;
137 memcpy-burst-size = <256>;
Darm,pl330.yaml52 arm,pl330-periph-burst:
54 description: quirk for performing burst transfer only
/Documentation/devicetree/bindings/usb/
Dsnps,dwc3.yaml318 start the corresponding USB RX transaction (burst).
328 snps,rx-max-burst:
330 Max USB RX burst size. In host mode, this field specifies the
331 Maximum Bulk IN burst the DWC_usb3 core can perform. When the system
332 bus is slower than the USB, RX FIFO can overrun during a long burst.
333 You can program a smaller value to this field to limit the RX burst
348 transmission for the corresponding USB transaction (burst).
357 snps,tx-max-burst:
359 Max USB TX burst size. When the system bus is slower than the USB,
360 TX FIFO can underrun during a long burst. Program a smaller value
[all …]
Dchipidea,usb2-common.yaml51 ahb-burst-config:
55 used to change AHB burst configuration, check the chipidea spec for
62 tx-burst-size-dword:
64 it is vendor dependent, the tx burst size in dword (4 bytes), This
65 register represents the maximum length of a the burst in 32-bit
67 of this property will only take effect if property "ahb-burst-config"
74 rx-burst-size-dword:
76 it is vendor dependent, the rx burst size in dword (4 bytes), This
77 register represents the maximum length of a the burst in 32-bit words
79 this property will only take effect if property "ahb-burst-config"
Dci-hdrc-usb2.yaml106 /* Incremental burst of unspecified length */
107 ahb-burst-config = <0x0>;
108 tx-burst-size-dword = <0x10>; /* 64 bytes */
109 rx-burst-size-dword = <0x10>;
/Documentation/devicetree/bindings/dma/stm32/
Dst,stm32-dma3.yaml73 -bit 0: The source incrementing burst
74 0x0: fixed burst
75 0x1: contiguously incremented burst
79 -bit 4: The destination incrementing burst
80 0x0: fixed burst
81 0x1: contiguously incremented burst
86 0x0: burst
/Documentation/devicetree/bindings/memory-controllers/fsl/
Dfsl,imx-weim.yaml77 fsl,burst-clk-enable:
81 in Burst Clock Mode.
83 fsl,continuous-burst-clk:
86 Make Burst Clock to output continuous clock. Without this option Burst
118 fsl,burst-clk-enable: false
122 - fsl,burst-clk-enable
125 fsl,continuous-burst-clk: false
/Documentation/devicetree/bindings/memory-controllers/
Dti,gpmc-child.yaml94 gpmc,page-burst-access-ns:
164 burst accesses, defines the number of
178 gpmc,burst-length:
179 description: Page/burst length.
184 gpmc,burst-wrap:
188 gpmc,burst-read:
189 description: Enables read page/burst mode
192 gpmc,burst-write:
193 description: Enables write page/burst mode
/Documentation/scheduler/
Dsched-bwc.rst25 Burst feature
40 The burst feature observes that a workload doesn't always executes the full
62 The interferenece when using burst is valued by the possibilities for
70 Quota, period and burst are managed within the cpu subsystem via cgroupfs.
135 - nr_bursts: Number of periods burst occurs.
179 allows applications to briefly burst past their quota limits by the amount of
181 1ms per cpu or as defined by min_cfs_rq_runtime). This slight burst only
183 in previous periods. This burst amount will not be transferred between cores.
186 also limits the burst ability to no more than 1ms per cpu. This provides
224 The larger period here allows for increased burst capacity.
[all …]
/Documentation/devicetree/bindings/arm/
Darm,coresight-tmc.yaml77 arm,max-burst-size:
79 The maximum burst size initiated by TMC on the AXI master interface. The
80 burst size can be in the range [0..15], the setting supports one data
81 transfer per burst up to a maximum of 16 data transfers per burst.
/Documentation/devicetree/bindings/display/panel/
Draydium,rm67191.yaml40 0 - burst-mode
41 1 - non-burst with sync event
42 2 - non-burst with sync pulse
/Documentation/devicetree/bindings/display/tilcdc/
Dpanel.txt8 - dma-burst-sz: DMA burst size
42 dma-burst-sz = <16>;
/Documentation/devicetree/bindings/iio/proximity/
Ddevantech-srf04.yaml15 burst
16 - echo-gpio is held high by the sensor after sending ultrasonic burst
46 This GPIO is set by the device as soon as an ultrasonic burst is sent
/Documentation/userspace-api/media/dvb/
Dfe-diseqc-send-burst.rst13 FE_DISEQC_SEND_BURST - Sends a 22KHz tone burst for 2x1 mini DiSEqC satellite selection.
34 This ioctl is used to set the generation of a 22kHz tone burst for mini
/Documentation/devicetree/bindings/spi/
Dfsl-imx-cspi.yaml81 Valid values are: 0 (disabled), 1 (edge-triggered burst) and 2 (level-triggered burst).

1234