Searched full:can0 (Results 1 – 25 of 25) sorted by relevance
| /Documentation/networking/device_drivers/can/freescale/ |
| D | flexcan.rst | 52 ip link set dev can0 down
53 ethtool --set-priv-flags can0 rx-rtr {off|on}
54 ip link set dev can0 up
|
| /Documentation/ABI/testing/ |
| D | sysfs-platform-at91 | 23 echo 0x7ff > /sys/class/net/can0/mb0_id
27 echo 0x9fffffff > /sys/class/net/can0/mb0_id
|
| /Documentation/devicetree/bindings/reset/ |
| D | zynq-reset.txt | 45 256: can0 reset
47 258: can0 ref reset
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | nxp,s32g2-siul2-pinctrl.yaml | 109 llce-can0-pins {
110 llce-can0-grp0 {
116 llce-can0-grp1 {
|
| D | loongson,ls2k-pinctrl.yaml | 42 enum: [gpio, sdio, can1, can0, pwm3, pwm2, pwm1, pwm0, i2c1, i2c0,
47 enum: [gpio, sdio, can1, can0, pwm3, pwm2, pwm1, pwm0, i2c1, i2c0,
|
| D | pinctrl_spear.txt | 140 "can0", "can1", "pwm0_1", "pwm2", "pwm3", "ssp1", "ssp2", "mii2",
149 "i2c_4_5", "i2c_6_7", "can0", "can1", "pci", "sata", "ssp1", "gpt64"
|
| D | brcm,cygnus-pinmux.txt | 118 "can0": "can0_grp"
|
| D | nvidia,tegra234-pinmux-common.yaml | 17 enum: [ gp, uartc, i2c8, spi2, i2c2, can1, can0, rsvd0, eth0, eth2,
|
| D | xlnx,pinctrl-zynq.yaml | 115 smc0_nor, smc0_nor_cs1, smc0_nor_addr25, smc0_nand, can0,
|
| D | nvidia,tegra194-pinmux.yaml | 33 enum: [ aud, can0, can1, ccla, dca, dcb, dgpu, directdc, directdc1,
|
| D | xlnx,zynqmp-pinctrl.yaml | 235 sdio1_cd, nand0, nand0_ce, nand0_rb, nand0_dqs, can0, can1, uart0, uart1,
|
| /Documentation/devicetree/bindings/net/can/ |
| D | atmel-can.txt | 11 can0: can@f000c000 {
|
| D | renesas,rcar-canfd.yaml | 123 - description: CAN0 error interrupt
124 - description: CAN0 transmit interrupt
125 - description: CAN0 transmit/receive FIFO receive completion interrupt
|
| D | holt_hi311x.txt | 15 can0: can@1 {
|
| D | allwinner,sun4i-a10-can.yaml | 62 can0: can@1c2bc00 {
|
| D | renesas,rcar-can.yaml | 130 can0: can@e6e80000 {
|
| /Documentation/devicetree/bindings/clock/ |
| D | zynq-7000.txt | 60 19: can0
99 "fclk0", "fclk1", "fclk2", "fclk3", "can0", "can1",
|
| D | imx28-clock.yaml | 77 can0 58
|
| /Documentation/networking/device_drivers/can/ |
| D | can327.rst | 84 sudo ip link set can0 down
85 sudo ip link set can0 type can bitrate 500000
86 sudo ip link set can0 up
|
| /Documentation/devicetree/bindings/soc/mobileye/ |
| D | mobileye,eyeq5-olb.yaml | 67 timer0, timer1, timer2, timer5, uart0, uart1, can0, can1, spi0,
145 const: can0
|
| /Documentation/networking/ |
| D | can.rst | 311 strcpy(ifr.ifr_name, "can0" );
378 strcpy(ifr.ifr_name, "can0");
763 strcpy(ifr.ifr_name, "can0");
1163 $ ip -details link show can0
1169 $ ip link set dev can0 type can termination 120
1173 $ ip link set dev can0 type can termination 0
1193 - the CAN bus this CAN ID is transmitted on (e.g. can0)
1241 $ ip link set can0 type can help
1275 $ ip -details -statistics link show can0
1276 2: can0: <NOARP,UP,LOWER_UP,ECHO> mtu 16 qdisc pfifo_fast state UP qlen 10
[all …]
|
| D | j1939.rst | 365 .can_ifindex = if_nametoindex("can0"),
439 .can_ifindex = if_nametoindex("can0"),
|
| D | iso15765-2.rst | 371 addr.can_ifindex = if_nametoindex("can0");
|
| /Documentation/networking/device_drivers/can/ctu/ |
| D | ctucanfd-driver.rst | 186 When the device is brought up, e.g., by calling ``ip link set can0 up``,
|
| /Documentation/admin-guide/ |
| D | devices.txt | 1564 0 = /dev/can0 First CAN-Bus controller
|