Home
last modified time | relevance | path

Searched +full:cmd +full:- +full:gpios (Results 1 – 7 of 7) sorted by relevance

/Documentation/devicetree/bindings/misc/
Dolpc,xo1.75-ec.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
4 ---
5 $id: http://devicetree.org/schemas/misc/olpc,xo1.75-ec.yaml#
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
8 title: OLPC XO-1.75 Embedded Controller
12 on a OLPC XO-1.75 laptop computer.
17 "ready-gpios" property of the SSP binding as documented in:
18 <Documentation/devicetree/bindings/spi/marvell,mmp2-ssp.yaml>.
21 - Lubomir Rintel <lkundrak@v3.sk>
25 const: olpc,xo1.75-ec
[all …]
/Documentation/devicetree/bindings/phy/
Dphy-mapphone-mdm6600.txt4 - compatible Must be "motorola,mapphone-mdm6600"
5 - enable-gpios GPIO to enable the USB PHY
6 - power-gpios GPIO to power on the device
7 - reset-gpios GPIO to reset the device
8 - motorola,mode-gpios Two GPIOs to configure MDM6600 USB start-up mode for
10 - motorola,cmd-gpios Three GPIOs to control the power state of the MDM6600
11 - motorola,status-gpios Three GPIOs to read the power state of the MDM6600
15 usb-phy {
16 compatible = "motorola,mapphone-mdm6600";
17 enable-gpios = <&gpio3 31 GPIO_ACTIVE_LOW>;
[all …]
/Documentation/devicetree/bindings/mmc/
Darm,pl18x.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Linus Walleij <linus.walleij@linaro.org>
11 - Ulf Hansson <ulf.hansson@linaro.org>
20 - $ref: /schemas/arm/primecell.yaml#
21 - $ref: mmc-controller.yaml#
29 - arm,pl180
30 - arm,pl181
31 - arm,pl18x
[all …]
Dcavium-mmc.txt10 - compatible : should be one of:
11 cavium,octeon-6130-mmc
12 cavium,octeon-7890-mmc
13 cavium,thunder-8190-mmc
14 cavium,thunder-8390-mmc
15 mmc-slot
16 - reg : mmc controller base registers
17 - clocks : phandle
20 - for cd, bus-width and additional generic mmc parameters
22 - cavium,cmd-clk-skew : number of coprocessor clocks before sampling command
[all …]
/Documentation/devicetree/bindings/mtd/
Dfsl-upm-nand.txt4 - compatible : "fsl,upm-nand".
5 - reg : should specify localbus chip select and size used for the chip.
6 - fsl,upm-addr-offset : UPM pattern offset for the address latch.
7 - fsl,upm-cmd-offset : UPM pattern offset for the command latch.
10 - fsl,upm-addr-line-cs-offsets : address offsets for multi-chip support.
12 - gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
13 (R/B#). For multi-chip devices, "n" GPIO definitions are required
17 - fsl,upm-wait-flags : add chip-dependent short delays after running the
20 - chip-delay : chip dependent delay for transferring data from array to
21 read registers (tR). Required if property "gpios" is not used
[all …]
Datmel-nand.txt4 Documentation/devicetree/bindings/memory-controllers/atmel,ebi.txt).
11 - compatible: should be one of the following
12 "atmel,at91rm9200-nand-controller"
13 "atmel,at91sam9260-nand-controller"
14 "atmel,at91sam9261-nand-controller"
15 "atmel,at91sam9g45-nand-controller"
16 "atmel,sama5d3-nand-controller"
17 "microchip,sam9x60-nand-controller"
18 - ranges: empty ranges property to forward EBI ranges definitions.
19 - #address-cells: should be set to 2.
[all …]
/Documentation/i2c/
Dslave-testunit-backend.rst1 .. SPDX-License-Identifier: GPL-2.0
7 by Wolfram Sang <wsa@sang-engineering.com> in 2020
11 easy to obtain). Examples include multi-master testing, and SMBus Host Notify
21 # echo "slave-testunit 0x1030" > /sys/bus/i2c/devices/i2c-0/new_device
30 compatible = "slave-testunit";
39 When writing, the device consists of 4 8-bit registers and, except for some
43 .. csv-table::
46 0x00, CMD, which test to trigger
51 Using 'i2cset' from the i2c-tools package, the generic command looks like::
53 # i2cset -y <bus_num> <testunit_address> <CMD> <DATAL> <DATAH> <DELAY> i
[all …]