Searched full:collected (Results 1 – 25 of 55) sorted by relevance
123
74 "disabled" means no dump will be collected.77 collected it will be copied to a separate buffer and that81 collected userspace will directly read from the remote
44 collected from the network before being99 collected from the network before being154 collected from the network before being220 collected from the network before being
29 Phase data has to be collected when temperature and
10 - interrupts: the main IRQ line to signal the collected IRQs
11 the common fields and basic accounting fields are collected for22 Their values are collected if CONFIG_TASK_DELAY_ACCT is set.32 Their values are collected if CONFIG_TASK_XACCT is set.
29 ``offset`` field set to indicate the line to be collected.
33 ``offset`` field set to indicate the line to be collected.
97 /* Read number of PCs collected. */153 * The format for the types of collected comparisons.187 /* Read number of comparisons collected. */230 should be collected with ``kcov_remote_start`` and ``kcov_remote_stop``.282 is only collected from a single userspace process on the system. However, if
16 then commits that need to be updated will be collected and reported.
48 TDX reference material is collected here:
7 collected so there isn't any performance impact. Only bio-based DM11 Individual statistics will be collected for each step-sized area within
21 The statistics collected are AWB (Auto-white balance) RGBS (Red, Green, Blue and
79 The statistics collected are Exposure, AWB (Auto-white balance), Histogram and
43 The test data will be collected in the coresight sink which is enabled.
121 that the amount of data collected can vary a lot per run of perf test.
209 is accumulated based on clean data collected at runtime. Data210 collected during a period without extra interrupts is considered231 This section describes the general performance data collected on
30 The test data will be collected in the coresight sink which is enabled.
13 Region snapshots are collected by the driver, and can be accessed via read
25 So how is this information collected? Whenever timer interrupt is
59 panic. This is to allow for a crash dump to be collected. It is incumbent
16 collected by the `*MONITOR` System Service of z/VM.94 which data should be collected. This can be done by the CP command MONITOR
275 collected from the hardware.341 if the driver have a bit that indicates when a collected data is ready411 /* Next stat should be collected in 1000 ms */
73 - bit [18] IR_SMP_INT Set when 32 input samples have been collected over
63 In userspace, the tests are collected and run via ``rustdoc``. Using the tool
100 can be collected from ``/sys/kernel/debug/kunit/<test suite>/results``, and