Searched full:decrease (Results 1 – 25 of 62) sorted by relevance
123
| /Documentation/userspace-api/media/rc/ |
| D | rc-tables.rst | 276 - Decrease Brightness
278 - BRIGHTNESS DECREASE
337 - Decrease volume
381 - Decrease channel sequentially
|
| /Documentation/devicetree/bindings/net/wireless/ |
| D | ieee80211.yaml | 30 decrease performance noticeably
|
| /Documentation/devicetree/bindings/input/ |
| D | iqs626a.yaml | 189 azoteq,meas-cap-decrease:
455 channel in response to a decrease in counts. Node names suffixed with
459 that only events corresponding to a decrease in counts are reported
463 the counts increase or decrease such that events of either direction
527 azoteq,meas-cap-decrease:
766 azoteq,meas-cap-decrease;
861 azoteq,meas-cap-decrease;
869 azoteq,meas-cap-decrease;
|
| D | iqs269a.yaml | 333 azoteq,meas-cap-decrease:
449 a decrease in counts. Node names suffixed with '-alt' instead corre-
453 that only events corresponding to a decrease in counts are reported
457 the counts increase or decrease such that events of either direction
|
| /Documentation/scheduler/ |
| D | schedutil.rst | 39 will decrease to reflect the fraction of time each task spends on the CPU
102 highest. UTIL_EST filters to instantly increase and only decay on decrease.
|
| /Documentation/sound/soc/ |
| D | pops-clicks.rst | 52 is heard when the gain increase or decrease changes the mean audio signal
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | richtek,rt9455.yaml | 47 input voltage level in uV, used to decrease voltage level when the over current of the
|
| /Documentation/hwmon/ |
| D | sht15.rst | 51 measurement and decrease power consumption, while losing on precision.
|
| D | w83793.rst | 91 if tempX_input < thermal_cruiseX - toleranceX, the chip will decrease
|
| D | w83792d.rst | 159 (3) If the temperature goes below the low limit, PWM duty cycle will decrease
|
| /Documentation/devicetree/bindings/thermal/ |
| D | qcom-spmi-adc-tm5.yaml | 49 description: This parameter is used to decrease ADC sampling rate.
114 description: This parameter is used to decrease ADC sampling rate.
|
| D | qcom-spmi-adc-tm-hc.yaml | 45 description: This parameter is used to decrease ADC sampling rate.
|
| /Documentation/leds/ |
| D | leds-mt6370-rgb.rst | 16 can increase or decrease the brightness of the RGB LED via an I2C interface.
|
| /Documentation/livepatch/ |
| D | cumulative-patches.rst | 58 - Decrease user confusion about dependencies between livepatches.
|
| /Documentation/networking/ |
| D | net_dim.rst | 52 compared in a similar fashion - increase == "better" and decrease == "worse".
55 increase in the interrupt rate is considered "worse" and a decrease is
|
| D | xfrm_device.rst | 19 can radically increase throughput and decrease CPU utilization. The XFRM
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | qcom,pm8018-adc.yaml | 84 This parameter is used to decrease the ADC sampling rate.
|
| /Documentation/driver-api/media/ |
| D | v4l2-device.rst | 128 decrease the refcount manually as well by calling:
|
| /Documentation/RCU/ |
| D | UP.rst | 27 element B. This situation can greatly decrease the life expectancy of
|
| /Documentation/process/ |
| D | code-of-conduct-interpretation.rst | 22 quality of submission and eventual result to ever decrease.
|
| /Documentation/PCI/ |
| D | sysfs-pci.rst | 79 echoed into it, it will then return '5'. Echoing a '0' into it will decrease
|
| /Documentation/driver-api/thermal/ |
| D | cpu-idle-cooling.rst | 37 decrease. Acting on the idle state duration or the idle cycle
|
| /Documentation/devicetree/bindings/phy/ |
| D | phy-stm32-usbphyc.yaml | 102 st,decrease-hs-slew-rate:
|
| /Documentation/userspace-api/ |
| D | iommufd.rst | 222 - Runtime Increase/Decrease of IOPTE size
|
| /Documentation/timers/ |
| D | hrtimers.rst | 75 hrtimers. E.g. we could decrease the frequency of the timeout subsystem
|
123