Searched full:disconnected (Results 1 – 25 of 64) sorted by relevance
123
| /Documentation/ABI/testing/ |
| D | sysfs-bus-surface_aggregator-tabletsw | 10 - "disconnected": The type-cover has been disconnected.
|
| D | sysfs-class-stm_source | 11 stm_source, it will first be disconnected.
|
| D | sysfs-class-rtrs-client | 53 functional. Otherwise the file contains "disconnected"
67 Operation blocks until RTRS path is disconnected.
73 Description: Write "1" to the file in order to disconnected and remove the path
74 from the session. Operation blocks until the path is disconnected
|
| D | sysfs-class-android_usb | 16 Valid values: CONNECTED, DISCONNECTED, CONFIGURED
|
| D | sysfs-block-rnbd | 23 disconnected in case of an error (e.g. link failure), the state file
58 Description: Remap the disconnected device if the session is not destroyed yet.
|
| D | sysfs-bus-fcoe | 122 - "Disconnected" - No link to the FCF/fabric
132 "Disconnected" state until either the timer expires and the
|
| D | sysfs-firmware-sgi_uv | 106 cable plugged into the port. If the port is disconnected,
111 plugged into the port. If the port is disconnected, the value
|
| D | sysfs-bus-iio-adc-ad7192 | 19 the bridge can be disconnected (when it is not being used
|
| D | sysfs-driver-hid-picolcd | 14 disconnected and reconnects after above delay (see attribute
|
| D | sysfs-class-rtrs-server | 20 Description: When "1" is written to the file, the RTRS session is being disconnected.
|
| /Documentation/arch/s390/ |
| D | driver-model.rst | 29 system; it is a pseudo subchannel where disconnected ccw devices are moved to
47 disconnected devices.
51 In the special case of the device being disconnected (see the
198 device, it is moved into disconnected state.
199 * In disconnected state, device operational again (CIO_OPER). The
|
| /Documentation/devicetree/bindings/sound/ |
| D | wlf,wm8782.yaml | 26 description: FSAMPEN pin value, 0 for low, 1 for high, 2 for disconnected.
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | lltc,ltc294x.yaml | 45 The setting is lost when the battery is disconnected.
|
| /Documentation/devicetree/bindings/dma/ |
| D | apple,admac.yaml | 50 in an interrupts-extended list the disconnected positions will contain
|
| /Documentation/devicetree/bindings/mux/ |
| D | adi,adg792a.txt | 28 * Mux 0 is disconnected when idle, mux 1 idles in the previously
|
| D | mux-controller.yaml | 45 multiplexer. Using this disconnected high-impedance state as the idle state
104 multiplexer. Using this disconnected high-impedance state as the idle state
|
| /Documentation/devicetree/bindings/usb/ |
| D | gpio-sbu-mux.yaml | 13 In USB Type-C applications the SBU lines needs to be connected, disconnected
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | realtek,rtl-intc.yaml | 12 disconnected.
|
| /Documentation/networking/ |
| D | mac80211-auth-assoc-deauth.txt | 95 mac80211->userspace: disconnected
|
| D | x25-iface.rst | 41 Terminate the LAPB link. If it is already disconnected then the disconnect
|
| D | multi-pf-netdev.rst | 50 (secondaries) are disconnected from the network at the chip level (set to silent mode). In silent
122 Secondary PFs are set to "silent" mode, meaning they are disconnected from the network.
|
| /Documentation/devicetree/bindings/net/ |
| D | qca,ar803x.yaml | 47 cable is disconnected. And the RX_CLK always keeps outputting a
|
| /Documentation/devicetree/bindings/iio/dac/ |
| D | adi,ltc2672.yaml | 72 automatically disconnected.
|
| /Documentation/devicetree/bindings/spi/ |
| D | samsung,spi.yaml | 54 The CS line is disconnected, therefore the device should not operate
|
| /Documentation/netlink/specs/ |
| D | dpll.yaml | 179 name: disconnected
180 doc: pin disconnected, not considered as a valid input
|
123