Searched full:doesn (Results 1 – 25 of 659) sorted by relevance
12345678910>>...27
| /Documentation/userspace-api/media/dvb/ |
| D | frontend_legacy_dvbv3_api.rst | 9 The usage of this API is deprecated, as it doesn't support all digital
10 TV standards, doesn't provide good statistics measurements and provides
|
| D | examples.rst | 10 examples got out of date and doesn't even compile nowadays.
|
| /Documentation/userspace-api/media/drivers/ |
| D | thp7312.rst | 28 connected to the THP7312. If the module doesn't have a focus lens actuator,
30 controllable focus lens but the sensor doesn't support PDAF, only the
|
| /Documentation/mm/ |
| D | z3fold.rst | 14 * z3fold doesn't export any API itself and is thus intended to be used
26 Keeping effective compression ratio close to zsmalloc's, z3fold doesn't
|
| D | active_mm.rst | 31 difference is that an anonymous address space doesn't care about the
37 doesn't need any user mappings - all kernel threads basically fall into
46 really doesn't _have_ a real address space at all.
|
| /Documentation/userspace-api/ |
| D | mfd_noexec.rst | 14 execute bit set, and the memfd_create() syscall doesn't allow setting
51 an app doesn't want sealing, it can add F_SEAL_SEAL after creation.
72 doesn't set the executable bit; for example, a container with
|
| /Documentation/i2c/ |
| D | fault-codes.rst | 18 result for an operation ... it doesn't indicate that anything is wrong
36 cases (unless the hardware doesn't provide unique fault reports).
103 that it doesn't, or can't, support.
106 doesn't support SMBus block transfers is asked to execute
|
| D | ten-bit-addresses.rst | 21 hardware doesn't support them (SMBus doesn't require 10-bit address
|
| /Documentation/w1/masters/ |
| D | ds2490.rst | 29 the core w1 code doesn't make use of the information. Connecting
48 driver doesn't query those values.
49 - The ds2490 specification doesn't cover short bulk in reads in
|
| /Documentation/power/ |
| D | s2ram.rst | 25 driver that doesn't resume and recompile and reboot).
28 machine that doesn't boot) is:
41 - if it doesn't come back up (which is usually the problem), reboot by
|
| /Documentation/devicetree/bindings/opp/ |
| D | opp-v2-base.yaml | 54 array of frequencies. The OPP binding doesn't provide any provisions
70 by angular brackets <>. The OPP binding doesn't provide any provisions to
97 required. The OPP binding doesn't provide any provisions to relate the
112 required. The OPP binding doesn't provide any provisions to relate the
213 OPPs. If the platform doesn't pick a specific <name> or the <name>
214 doesn't match with any opp-microvolt-<name> properties, then
|
| /Documentation/arch/x86/ |
| D | usb-legacy-support.rst | 29 BIOS manufacturers only test with Windows, and Windows doesn't do 64-bit
48 Legacy support in the BIOS. If this alone doesn't help, try also adding
|
| /Documentation/i2c/busses/ |
| D | i2c-ali15x3.rst | 61 - Gigabyte GA-5AX (Generally doesn't work because the BIOS doesn't
113 registers. It doesn't use the ACPI region.
|
| /Documentation/devicetree/bindings/phy/ |
| D | mediatek,mt8365-csi-rx.yaml | 34 If the PHY doesn't support mode selection then #phy-cells must be 0 and
44 If the PHY doesn't support mode selection then this set the operating mode.
|
| /Documentation/features/ |
| D | arch-support.txt | 11 | N/A| # feature doesn't apply to the architecture
|
| /Documentation/watchdog/ |
| D | pcwd-watchdog.rst | 13 the WDT card does, only it doesn't require an IRQ to run. Furthermore,
19 signals to it so it doesn't reset your computer ... at least during
|
| /Documentation/sound/cards/ |
| D | bt87x.rst | 34 The driver is now stable. However, it doesn't know about many TV cards,
35 and it refuses to load for cards it doesn't know.
|
| D | cmipci.rst | 26 Please note that the CM8x38 DAC doesn't support continuous playback
174 On some cards this doesn't work and you need to change the
182 [FIXME: this doesn't work on all chips..]
206 subframes, pass the "soft_ac3=0" module option. This doesn't matter
233 0x330. Choose a value that doesn't conflict with other cards.
|
| /Documentation/security/keys/ |
| D | request-key.rst | 60 doesn't check for keys that are under construction and doesn't attempt to
86 3) request_key() sees that A doesn't have the desired key yet, so it creates
156 if this denies permission, it doesn't search further.
|
| /Documentation/filesystems/ |
| D | affs.rst | 26 but slows down file creation/deletion. Doesn't make much
88 The filesystem is really a muFS, also it doesn't
127 filesystem (the root directory doesn't have uid/gid fields).
188 area of the RDB, so only the checksum doesn't match anymore.
228 in an ugly way (but the real AFFS doesn't do much better). This
|
| /Documentation/devicetree/bindings/timer/ |
| D | jcore,pit.txt | 14 required in order to reserve an interrupt number that doesn't
|
| /Documentation/virt/kvm/arm/ |
| D | hyp-abi.rst | 9 KVM). It doesn't cover the interaction of the kernel with the
19 On arm and arm64 (without VHE), the kernel doesn't run in hypervisor
|
| /Documentation/admin-guide/media/ |
| D | faq.rst | 167 If that doesn't work, check at the linux-media ML archives, to
177 5. The dvb_net device doesn't give me any packets at all
185 If ``tcpdump`` doesn't give you any output, check the statistics
194 6. The ``dvb_net`` device doesn't give me any multicast packets
|
| /Documentation/driver-api/usb/ |
| D | persist.rst | 32 For many sorts of devices this behavior doesn't matter in the least.
53 entirely the BIOS's fault, but that doesn't do _you_ any good unless
80 "persist" attribute is set. It doesn't try to resume the device; that
113 doesn't even exist, so you only have to worry about setting it for
|
| /Documentation/devicetree/bindings/clock/ti/ |
| D | clockdomain.txt | 7 enabled/disabled. This binding doesn't define a new clock
|
12345678910>>...27