Searched full:driven (Results 1 – 25 of 140) sorted by relevance
123456
| /Documentation/sound/ |
| D | utimers.rst | 4 Userspace-driven timers
12 This document describes the userspace-driven timers: virtual ALSA timers
21 Enabling userspace-driven timers
24 The userspace-driven timers could be enabled in the kernel using the
28 Userspace-driven timers API
31 Userspace application can create a userspace-driven ALSA timer by
51 applications. There could be up to 128 userspace-driven timers in the
96 Userspace-driven timers and snd-aloop
99 Userspace-driven timers could be easily used with ``snd-aloop`` module
106 not when the certain amount of jiffies elapses. Userspace-driven ALSA
[all …]
|
| /Documentation/devicetree/bindings/power/reset/ |
| D | gpio-restart.yaml | 17 'open-source' is not found, the GPIO line will be driven in the inactive state. Otherwise its
18 not driven until the restart is initiated.
21 is configured as an output, and driven active, triggering a level triggered reset condition.
25 inactive-delay, the GPIO is driven active again. After a delay specified by wait-delay, the
|
| /Documentation/devicetree/bindings/display/ |
| D | truly,nt35597.txt | 20 - ports: This device has two video ports driven by two DSIs. Their connections
23 - port@0: DSI input port driven by master DSI
24 - port@1: DSI input port driven by secondary DSI
|
| D | solomon,ssd-common.yaml | 30 Height in pixel of the screen driven by the controller.
36 Width in pixel of the screen driven by the controller.
|
| /Documentation/hwmon/ |
| D | tc654.rst | 32 Setting pwm1_mode to 1 will cause the pwm output to be driven based on
34 driven based on the Vin input.
|
| /Documentation/driver-api/thermal/ |
| D | nouveau_thermal.rst | 75 Your fan can be driven in different modes:
78 * 1: The fan can be driven in manual (use pwm1 to change the speed);
79 * 2; The fan is driven automatically depending on the temperature.
|
| /Documentation/devicetree/bindings/input/ |
| D | gpio-matrix-keypad.txt | 1 * GPIO driven matrix keypad device tree bindings
3 GPIO driven matrix keypad is used to interface a SoC with a matrix keypad.
|
| /Documentation/driver-api/gpio/ |
| D | intro.rst | 37 options about how that value is driven, so that for example only one
38 value might be driven, supporting "wire-OR" and similar schemes for the
83 level is actually driven), or "open source" (where only the high signal level is
84 driven) signaling. That term applies to CMOS transistors; "open collector" is
|
| /Documentation/sound/soc/ |
| D | clocking.rst | 12 Every audio subsystem is driven by a master clock (sometimes referred to as MCLK
24 The Digital Audio Interface is usually driven by a Bit Clock (often referred to
|
| D | dai.rst | 15 The bit clock (BCLK) is always driven by the CODEC (usually 12.288MHz) and the
16 frame (FRAME) (usually 48kHz) is always driven by the controller. Each AC97
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | microchip,pac1921.yaml | 43 the INTEGRATE state when driven high, or in the READ state when driven low.
|
| /Documentation/peci/ |
| D | peci.rst | 30 bit with a driven, rising edge from an idle near zero volts. The
31 duration of the signal driven high allows to determine whether the bit
|
| /Documentation/devicetree/bindings/mfd/ |
| D | st,stm32-timers.yaml | 11 - advanced-control timers consist of a 16-bit auto-reload counter driven
15 driven by a programmable prescaler and PWM outputs.
16 - basic timers consist of a 16-bit auto-reload counter driven by a
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | renesas,rza1-ports.yaml | 83 "software IO driven" mode to be specified. To do so use the generic
90 controller driver internally, while software driven IO direction has to
171 * Configure TIOC0A as software driven input
181 * Configure TIOC0B as software driven output
|
| D | marvell,dove-pinctrl.txt | 64 pmu-nc Pin not driven by any PM function
65 pmu-low Pin driven low (0)
66 pmu-high Pin driven high (1)
|
| /Documentation/networking/ |
| D | team.rst | 7 Team devices are driven from userspace via libteam library which is here:
|
| /Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe/ |
| D | pincfg.txt | 18 0 = The pin is actively driven as an output
20 driven active-low, otherwise it is three-stated.
|
| /Documentation/devicetree/bindings/display/panel/ |
| D | panel-dsi-cm.yaml | 15 are usually driven in command mode. If no backlight is
45 because all its power rails can be driven by the same supply. In that case
|
| D | sharp,lq101r1sx01.yaml | 18 driven by the first link (DSI-LINK1), left or even, is considered the primary
20 to the peripheral driven by the second link (DSI-LINK2, right or odd).
|
| D | jdi,lpm102a188a.yaml | 18 driven by the first link (DSI-LINK1) is considered the primary peripheral
20 peripheral driven by the second link (DSI-LINK2).
|
| /Documentation/devicetree/bindings/nvmem/ |
| D | nvmem.yaml | 37 The write-protect GPIO is asserted, when it's driven high
39 when it's driven low (logical '0') to allow writing.
|
| /Documentation/ABI/testing/ |
| D | sysfs-driver-fsi-master-gpio | 9 where the FSI bus is driven externally (for example, by
|
| /Documentation/devicetree/bindings/gpio/ |
| D | nxp,pcf8575.yaml | 14 driven high by a pull-up current source or driven low to ground. This
|
| /Documentation/devicetree/bindings/interconnect/ |
| D | qcom,rpm-common.yaml | 16 driven by a dedicated clock source.
|
| /Documentation/devicetree/bindings/clock/ |
| D | pwm-clock.yaml | 7 title: An external clock signal driven by a PWM pin.
|
123456