Searched full:ethertype (Results 1 – 8 of 8) sorted by relevance
| /Documentation/networking/ |
| D | bareudp.rst | 28 a) ip link add dev bareudp0 type bareudp dstport 6635 ethertype mpls_uc
30 This creates a bareudp tunnel device which tunnels L3 traffic with ethertype
42 a) ip link add dev bareudp0 type bareudp dstport 6635 ethertype ipv4 multiproto
47 b) ip link add dev bareudp0 type bareudp dstport 6635 ethertype mpls_uc multiproto
|
| D | nf_flowtable.rst | 125 parses the VLAN and PPPoE layer 2 headers to extract the ethertype and the
|
| D | openvswitch.rst | 168 the 802.1Q TPID (0x8100) as the Ethertype then stopped parsing the
|
| D | cdc_mbim.rst | 259 /* verify ethertype */
|
| /Documentation/netlink/specs/ |
| D | ovs_flow.yaml | 313 name: mpls-ethertype
317 Ethertype to set in the encapsulating ethernet frame. The only values
318 ethertype should ever be given are ETH_P_MPLS_UC and ETH_P_MPLS_MC,
331 name: mpls-ethertype
335 Ethertype to set in the encapsulating ethernet frame. The only values
336 ethertype should ever be given are ETH_P_MPLS_UC and ETH_P_MPLS_MC,
489 name: ethertype
648 label stack. Set the ethertype of the encapsulating frame to either
654 doc: ethertype
|
| /Documentation/networking/device_drivers/ethernet/aquantia/ |
| D | atlantic.rst | 262 2. 16 L2 EtherType rules
280 - Locations 16 - 31 for L2 EtherType filters
322 from L2 Ethertype filter with UserPriority since both User Priority and VLAN ID
330 L2 EtherType filters allows filter packet by EtherType field or both EtherType
333 distinguish VLAN filter from L2 Ethertype filter with UserPriority since both
|
| /Documentation/networking/dsa/ |
| D | dsa.rst | 88 parser) the MAC DA, MAC SA, EtherType and the entire L2 payload.
89 2. The switch-specific frame header is located before the EtherType, keeping
91 shifting the 'real' EtherType and L2 payload to the right.
134 CPU port can be configured to use either the DSA or the Ethertype DSA (EDSA)
135 format, but the DSA links are configured to use the shorter (without Ethertype)
142 adding or removing the ``ETH_P_EDSA`` EtherType and some padding octets).
183 the EtherType would have been, were this frame not tagged. The role of this
185 the first octet after the EtherType, and to change ``skb->dev`` to point to the
1068 address range of 01:15:4e:00:00:0x and with an EtherType of 0x88e3.
1100 uses a header with an EtherType of 0x892f) and are physically connected in a
|
| D | sja1105.rst | 115 ``vlan_filtering``, the EtherType recognized by the switch as being VLAN can
119 EtherType. In these modes, injecting into a particular TX queue can only be
|