Searched full:ext (Results 1 – 25 of 112) sorted by relevance
12345
| /Documentation/userspace-api/media/v4l/ |
| D | common.rst | 42 ext-ctrls-camera
43 ext-ctrls-flash
44 ext-ctrls-image-source
45 ext-ctrls-image-process
46 ext-ctrls-codec
47 ext-ctrls-codec-stateless
48 ext-ctrls-jpeg
49 ext-ctrls-dv
50 ext-ctrls-rf-tuner
51 ext-ctrls-fm-tx
[all …]
|
| /Documentation/devicetree/bindings/watchdog/ |
| D | aspeed,ast2400-wdt.yaml | 67 aspeed,ext-pulse-duration:
73 aspeed,ext-push-pull:
77 signal pin's drive type to push-pull. If aspeed,ext-push-pull is not
80 aspeed,ext-active-high:
83 If both aspeed,external-signal and aspeed,ext-push-pull are specified in
84 the node, set the pulse polarity to active-high. If aspeed,ext-active-high
106 - aspeed,ext-push-pull
108 - aspeed,ext-active-high
119 - aspeed,ext-active-high
122 - aspeed,ext-push-pull
|
| /Documentation/devicetree/bindings/leds/ |
| D | leds-netxbig.txt | 6 - gpio-ext: Phandle for the gpio-ext bus.
10 Mode (gpio-ext bus), delay_on and delay_off.
15 - mode-addr: Mode register address on gpio-ext bus.
17 A mode and the corresponding value on the gpio-ext bus.
18 - bright-addr: Brightness register address on gpio-ext bus.
30 gpio-ext = &gpio_ext;
|
| /Documentation/devicetree/bindings/mfd/ |
| D | tps65910.txt | 70 - ti,regulator-ext-sleep-control: enable external sleep
115 ti,regulator-ext-sleep-control = <0>;
124 ti,regulator-ext-sleep-control = <4>;
133 ti,regulator-ext-sleep-control = <0>;
142 ti,regulator-ext-sleep-control = <1>;
149 ti,regulator-ext-sleep-control = <0>;
156 ti,regulator-ext-sleep-control = <0>;
163 ti,regulator-ext-sleep-control = <0>;
171 ti,regulator-ext-sleep-control = <0>;
178 ti,regulator-ext-sleep-control = <0>;
[all …]
|
| /Documentation/devicetree/bindings/gpio/ |
| D | netxbig-gpio-ext.txt | 5 - compatible: "lacie,netxbig-gpio-ext".
12 netxbig_gpio_ext: netxbig-gpio-ext {
13 compatible = "lacie,netxbig-gpio-ext";
|
| /Documentation/devicetree/bindings/clock/ |
| D | sprd,sc9863a-clk.yaml | 44 - const: ext-26m
45 - const: ext-32k
46 - const: ext-4m
83 clock-names = "ext-26m", "ext-32k";
|
| D | sprd,ums512-clk.yaml | 47 - const: ext-26m
48 - const: ext-32k
49 - const: ext-4m
68 clock-names = "ext-26m";
|
| D | amlogic,gxbb-aoclkc.yaml | 35 - const: ext-32k-0
36 - const: ext-32k-1
37 - const: ext-32k-2
|
| D | ingenic,cgu.yaml | 75 - const: ext
117 clocks = <&ext>, <&osc32k>;
118 clock-names = "ext", "osc32k";
|
| /Documentation/devicetree/bindings/sound/ |
| D | imx-audio-sgtl5000.txt | 33 * Ext Spk
37 - mux-ext-port : The external port of the i.MX audio muxer
55 mux-ext-port = <3>;
|
| D | eukrea-tlv320.txt | 13 - fsl,mux-ext-port : The external port of the i.MX audio muxer.
25 fsl,mux-ext-port = <3>;
|
| D | omap-abe-twl6040.txt | 23 * Ext Spk
75 "Ext Spk", "HFL",
76 "Ext Spk", "HFR",
|
| D | sirf-audio.txt | 20 * Ext Spk
28 * Ext Mic
|
| D | fsl,imx-audio-es8328.yaml | 72 mux-ext-port:
87 - mux-ext-port
110 mux-ext-port = <3>;
|
| /Documentation/devicetree/bindings/mips/img/ |
| D | xilfpga.txt | 43 - clocks: phandle to ext clock for fixed-clock received by MIPS core.
56 clocks = <&ext>;
60 ext: ext {
|
| /Documentation/devicetree/bindings/media/i2c/ |
| D | alliedvision,alvium-csi2.yaml | 23 vcc-ext-in-supply:
55 - vcc-ext-in-supply
69 vcc-ext-in-supply = <®_vcc_ext_in>;
|
| /Documentation/devicetree/bindings/iio/dac/ |
| D | adi,ad5755.yaml | 28 adi,ext-dc-dc-compenstation-resistor:
90 adi,ext-current-sense-resistor:
146 adi,ext-current-sense-resistor;
152 adi,ext-current-sense-resistor;
158 adi,ext-current-sense-resistor;
164 adi,ext-current-sense-resistor;
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | mediatek,mtk-cirq.yaml | 40 mediatek,ext-irq-range:
53 - mediatek,ext-irq-range
67 mediatek,ext-irq-range = <32 200>;
|
| /Documentation/devicetree/bindings/regulator/ |
| D | tps65090.txt | 17 - ti,enable-ext-control: This is applicable for DCDC1, DCDC2 and DCDC3.
19 - dcdc-ext-control-gpios: This is applicable for DCDC1, DCDC2 and DCDC3.
56 ti,enable-ext-control;
57 dcdc-ext-control-gpios = <&gpio 10 0>;
|
| /Documentation/devicetree/bindings/serial/ |
| D | mvebu-uart.txt | 9 - "marvell,armada-3700-uart-ext" for the extended variant of the
28 (marvell,armada-3700-uart-ext): "uart-tx" and "uart-rx",
49 compatible = "marvell,armada-3700-uart-ext";
|
| /Documentation/devicetree/bindings/net/ |
| D | cpsw-phy-sel.txt | 13 -rmii-clock-ext : If present, the driver will configure the RMII
29 rmii-clock-ext;
|
| /Documentation/devicetree/bindings/pwm/ |
| D | adi,axi-pwmgen.yaml | 40 - const: ext
55 clock-names = "axi", "ext";
|
| /Documentation/devicetree/bindings/iio/frequency/ |
| D | adi,admv4420.yaml | 32 adi,ref-ext-single-ended-en:
56 adi,ref-ext-single-ended-en;
|
| /Documentation/devicetree/bindings/thermal/ |
| D | samsung,exynos-thermal.yaml | 27 - samsung,exynos5420-tmu-ext-triminfo
56 channels 2, 3 and 4 Use "samsung,exynos5420-tmu-ext-triminfo" in
83 const: samsung,exynos5420-tmu-ext-triminfo
164 compatible = "samsung,exynos5420-tmu-ext-triminfo";
|
| /Documentation/devicetree/bindings/rtc/ |
| D | rtc-omap.txt | 43 clock-names = "ext-clk", "int-clk";
48 ext_wakeup: ext-wakeup {
|
12345