Home
last modified time | relevance | path

Searched +full:fast +full:- +full:clk (Results 1 – 5 of 5) sorted by relevance

/Documentation/devicetree/bindings/soc/tegra/
Dnvidia,nvec.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Thierry Reding <thierry.reding@gmail.com>
11 - Jon Hunter <jonathanh@nvidia.com>
26 - description: divider clock
27 - description: fast clock
29 clock-names:
32 - const: div-clk
33 - const: fast-clk
[all …]
/Documentation/devicetree/bindings/i2c/
Dnvidia,tegra20-i2c.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/i2c/nvidia,tegra20-i2c.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
8 - Thierry Reding <thierry.reding@gmail.com>
9 - Jon Hunter <jonathanh@nvidia.com>
16 - description: Tegra20 has 4 generic I2C controller. This can support
17 master and slave mode of I2C communication. The i2c-tegra driver
19 controller is only compatible with "nvidia,tegra20-i2c".
20 const: nvidia,tegra20-i2c
[all …]
/Documentation/devicetree/bindings/iio/frequency/
Dadi,adf4350.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Michael Hennerich <michael.hennerich@analog.com>
15 - adi,adf4350
16 - adi,adf4351
21 spi-max-frequency:
28 clock-names:
31 '#clock-cells':
34 clock-output-names:
[all …]
/Documentation/driver-api/
Dpin-control.rst9 - Enumerating and naming controllable pins
11 - Multiplexing of pins, pads, fingers (etc) see below for details
13 - Configuration of pins, pads, fingers (etc), such as software-controlled
14 biasing and driving mode specific pins, such as pull-up, pull-down, open drain,
17 Top-level interface
22 - A PIN CONTROLLER is a piece of hardware, usually a set of registers, that
26 - PINS are equal to pads, fingers, balls or whatever packaging input or
30 be sparse - i.e. there may be gaps in the space with numbers where no
60 .. code-block:: c
97 See ``arch/arm/mach-ux500/Kconfig`` for an example.
[all …]
/Documentation/admin-guide/
Dkernel-parameters.txt16 force -- enable ACPI if default was off
17 on -- enable ACPI but allow fallback to DT [arm64,riscv64]
18 off -- disable ACPI if default was on
19 noirq -- do not use ACPI for IRQ routing
20 strict -- Be less tolerant of platforms that are not
22 rsdt -- prefer RSDT over (default) XSDT
23 copy_dsdt -- copy DSDT to memory
24 nospcr -- disable console in ACPI SPCR table as
41 If set to vendor, prefer vendor-specific driver
73 Documentation/firmware-guide/acpi/debug.rst for more information about
[all …]