Searched full:fed (Results 1 – 25 of 44) sorted by relevance
12
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | arm,versatile-fpga-irq.txt | 5 controllers are OR:ed together and fed to the CPU tile's IRQ input. Each
|
| D | ti,pruss-intc.yaml | 18 interrupts (0, 1) are fed exclusively to the internal PRU cores, with the
|
| /Documentation/networking/ |
| D | phy-link-topology.rst | 32 interface, that can directly be fed to an SFP cage, such as SGMII, 1000BaseX,
53 serialized MII interface fed to the SFP ::
|
| D | strparser.rst | 24 In general mode, a sequence of skbs are fed to strparser from an
|
| /Documentation/devicetree/bindings/iio/multiplexer/ |
| D | io-channel-mux.yaml | 13 If a multiplexer is used to select which hardware signal is fed to
|
| /Documentation/devicetree/bindings/iio/afe/ |
| D | voltage-divider.yaml | 75 * voltage divider (R = 200 Ohms, Rout = 22 Ohms) and fed to an ADC.
|
| D | temperature-sense-rtd.yaml | 60 description: The current fed through the RTD sensor.
|
| /Documentation/devicetree/bindings/clock/ |
| D | arm,syscon-icst.yaml | 30 In the core modules and logic tiles, the ICST is a configurable clock fed
|
| D | samsung,exynos5260-clock.yaml | 26 are fed into the clock controller and then routed to the hardware blocks.
|
| /Documentation/devicetree/bindings/pci/ |
| D | snps,dw-pcie-common.yaml | 67 corresponding domains are fed up from a common clock source.
104 interfaces fed up with a common clock source it's advisable to
|
| D | baikal,bt1-pcie.yaml | 66 are fed up by the dedicated application clocks. A common reference
|
| /Documentation/fb/ |
| D | internals.rst | 66 The whole pixel value is fed through a programmable lookup table that has one
|
| /Documentation/crypto/ |
| D | devel-algos.rst | 131 hardware needs to be fed separate chunks of the scatterlist which
237 implementation needs to be fed separate chunks of the scatterlist which
|
| /Documentation/devicetree/bindings/thermal/ |
| D | qcom-spmi-adc-tm-hc.yaml | 85 signal is fed to VADC. The configuration for this node is to know the
|
| D | qcom-spmi-adc-tm5.yaml | 90 signal is fed to VADC. The configuration for this node is to know the
|
| /Documentation/driver-api/memory-devices/ |
| D | ti-gpmc.rst | 34 connected to gpmc. A few of the peripheral timings can be fed either
|
| /Documentation/gpu/ |
| D | komeda-kms.rst | 41 frame. its output frame can be fed into post image processor for showing it on
42 the monitor or fed into wb_layer and written to memory at the same time.
68 the result need to be fed to merger to merge two part images together, and then
|
| /Documentation/devicetree/bindings/media/ |
| D | microchip,csi2dc.yaml | 58 in which CSI2DC will perform clock crossing. This clock must be fed
|
| /Documentation/mm/ |
| D | balance.rst | 98 for a zone can be tracked and fed into the balancing scheme (jalvo@mbay.net)
|
| /Documentation/devicetree/bindings/net/dsa/ |
| D | microchip,ksz.yaml | 113 reference clock, the clock needs to be fed back to ksz88x3
|
| /Documentation/devicetree/bindings/soc/tegra/ |
| D | nvidia,tegra20-pmc.yaml | 55 Management Unit, whose interrupt output signal is fed into the PMC. This
56 signal is optionally inverted, and then fed into the ARM GIC. The PMC is
|
| /Documentation/devicetree/bindings/net/ |
| D | snps,dwc-qos-ethernet.txt | 37 In cases where the PHY clock is directly fed into the EQOS receive path
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | qcom,spmi-vadc.yaml | 93 fed to VADC. The configuration for this node is to know the
|
| /Documentation/networking/device_drivers/hamradio/ |
| D | baycom.rst | 65 and can therefore be fed from the parallel port and does not require
|
| /Documentation/arch/m68k/ |
| D | buddha-driver.rst | 112 The IDE ports are fed by the address lines A2 to A4, just as
|
12