Searched full:filters (Results 1 – 25 of 100) sorted by relevance
1234
| /Documentation/userspace-api/media/dvb/ |
| D | demux.rst | 9 The Digital TV demux device controls the MPEG-TS filters for the
10 digital TV. If the driver and hardware supports, those filters are
|
| D | dmx-fwrite.rst | 38 digitally recorded Transport Stream. Matching filters have to be defined
66 front- end. Make sure that these filters are stopped and that the
67 filters with input set to ``DMX_IN_DVR`` are started.
|
| D | dmx-start.rst | 60 There are active filters filtering data from another input source.
61 Make sure that these filters are stopped before starting this
|
| D | dmx-set-pes-filter.rst | 59 There are active filters filtering data from another input source.
60 Make sure that these filters are stopped before starting this
|
| D | dmx-fopen.rst | 59 all PES filters set in the corresponding demux device
85 - "Too many open files", i.e. no more filters available.
|
| D | intro.rst | 91 Demultiplexer which filters the incoming Digital TV MPEG-TS stream
127 and section filters of the hardware. If the hardware does not support
128 filtering these filters can be implemented in software. Finally, the CA
|
| /Documentation/networking/device_drivers/ethernet/aquantia/ |
| D | atlantic.rst | 256 RX flow rules (ntuple filters)
266 The driver utilizes the ethtool interface for configuring ntuple filters,
273 When disabling ntuple filters, all the user programmed filters are
274 flushed from the driver cache and hardware. All needed filters must
277 Because of the fixed order of the rules, the location of filters is also fixed:
279 - Locations 0 - 15 for VLAN ID filters
280 - Locations 16 - 31 for L2 EtherType filters
281 - Locations 32 - 39 for L3/L4 5-tuple filters (locations 32, 36 for IPv6)
284 destination TCP/UDP/SCTP port) is compared against 8 filters. For IPv4, up to
302 At the moment you can not use IPv4 and IPv6 filters at the same time.
[all …]
|
| /Documentation/userspace-api/ |
| D | seccomp_filter.rst | 2 Seccomp BPF (SECure COMPuting with filters)
18 Filter (BPF) program, as with socket filters, except that the data
27 pointers which constrains all filters to solely evaluating the system
38 choosing. Expressive, dynamic filters provide further options down this
48 ``CONFIG_HAVE_ARCH_SECCOMP_FILTER``, then filters may be added as below:
68 processes will be constrained to the same filters and system
78 additional filters may be layered on which will increase evaluation
88 filters exist, the return value for the evaluation of a given system
166 If multiple filters exist, the return value for the evaluation of a
170 multiple filters return values of the same precedence, only the
[all …]
|
| D | no_new_privs.rst | 47 - Filters installed for the seccomp mode 2 sandbox persist across
49 Unprivileged users are therefore only allowed to install such filters
|
| /Documentation/devicetree/bindings/sound/ |
| D | infineon,peb2466.yaml | 14 with filters capabilities.
56 Filters coefficients file to load. If this property is omitted, internal
57 filters are disabled.
|
| /Documentation/networking/device_drivers/ethernet/intel/ |
| D | i40e.rst | 142 flexible filters. For a given flow type, you must clear all Intel Ethernet Flow
143 Director filters before changing the input set (for that flow type).
149 When disabling ntuple filters, all the user programmed filters are flushed from
150 the driver cache and hardware. All needed filters must be re-added when ntuple
163 To see the list of filters currently present::
167 Application Targeted Routing (ATR) Perfect Filters
185 Sideband Perfect Filters
187 Sideband Perfect Filters are used to direct traffic that matches specified
201 Use the following command to display all of the active filters::
209 Where <N> is the filter id displayed when printing all the active filters, and
[all …]
|
| D | iavf.rst | 111 - 16 MAC address filters for each VF
132 Receive checksum offloads, cloud filters, and VLAN acceleration are not
146 - If another driver (for example, DPDK) has set cloud filters, you cannot
153 + Sideband Filters
198 - ADq is not compatible with cloud filters
204 Center Bridging (DCB), Multiple Functions per Port (MFP), or Sideband Filters
205 - If another driver (for example, DPDK) has set cloud filters, you cannot
207 - Tunnel filters are not supported in ADq. If encapsulated packets do arrive
216 - If traffic matches multiple TC filters that point to different TCs, that
218 switch mirrors the packet to a VSI list when multiple filters are matched.
|
| D | ice.rst | 216 L3 and L4 flow types are supported for user-defined flexible filters. For a
217 given flow type, you must clear all Intel Ethernet Flow Director filters before
221 Flow Director Filters
223 Flow Director filters are used to direct traffic that matches specified
225 or disable the Intel Ethernet Flow Director and these filters::
229 NOTE: When you disable ntuple filters, all the user programmed filters are
230 flushed from the driver cache and hardware. All needed filters must be re-added
233 To display all of the active filters::
248 NOTE: These filters use inverted masks.
251 NOTE: These filters use inverted masks.
[all …]
|
| /Documentation/admin-guide/perf/ |
| D | ampere_cspmu.rst | 15 The PMU driver supports setting filters for "rank", "bank", and "threshold".
16 Note, that the filters are per PMU instance rather than per event.
|
| /Documentation/devicetree/bindings/iio/filter/ |
| D | adi,admv8818.yaml | 16 filters (HPFs) and four independently controlled low-pass filters
|
| /Documentation/networking/devlink/ |
| D | octeontx2.rst | 26 The same is used for ntuple filters of the interface. Supported by
56 - Set the maximum number of unicast filters that can be programmed for
|
| /Documentation/networking/ |
| D | tc-queue-filters.rst | 22 Likewise, on the receive side, the two filters for selecting set of
32 is supported only in hardware. Multiple filters may compete in
|
| D | can.rst | 475 - The filters are set to exactly one filter receiving everything
491 by defining 0 .. n filters with the CAN_RAW_FILTER socket option.
511 contrast to CAN controller hardware filters the user may set 0 .. n
512 receive filters for each open socket separately:
531 To set the filters to zero filters is quite obsolete as to not read
539 The CAN filters are processed in per-device filter lists at CAN frame
549 To benefit from the optimized filters for single CAN identifiers the
563 filter has to be defined in this way to benefit from the optimized filters:
700 The CAN_RAW socket can set multiple CAN identifier specific filters that
701 lead to multiple filters in the af_can.c filter processing. These filters
[all …]
|
| /Documentation/ABI/testing/ |
| D | sysfs-bus-event_source-devices-hisi_ptt | 67 Description: This directory contains the files providing the PCIe Root Port filters
79 time as others filters, or must be used on it's own. 1 indicates
93 Description: This directory contains the files providing the PCIe Requester filters
105 time as others filters, or must be used on it's own. 1 indicates
|
| D | sysfs-kernel-mm-damon | 311 What: /sys/kernel/mm/damon/admin/kdamonds/<K>/contexts/<C>/schemes/<S>/filters/nr_filters
315 directories for setting filters of the scheme named '0' to
316 'N-1' under the filters/ directory.
318 What: /sys/kernel/mm/damon/admin/kdamonds/<K>/contexts/<C>/schemes/<S>/filters/<F>/type
327 What: /sys/kernel/mm/damon/admin/kdamonds/<K>/contexts/<C>/schemes/<S>/filters/<F>/memcg_path
334 What: /sys/kernel/mm/damon/admin/kdamonds/<K>/contexts/<C>/schemes/<S>/filters/<F>/addr_start
341 What: /sys/kernel/mm/damon/admin/kdamonds/<K>/contexts/<C>/schemes/<S>/filters/<F>/addr_end
348 What: /sys/kernel/mm/damon/admin/kdamonds/<K>/contexts/<C>/schemes/<S>/filters/<F>/target_idx
355 What: /sys/kernel/mm/damon/admin/kdamonds/<K>/contexts/<C>/schemes/<S>/filters/<F>/matching
|
| /Documentation/core-api/ |
| D | watch_queue.rst | 37 Filters may also be emplaced on a pipe so that certain source types and
244 Once a watch queue has been created, a set of filters can be applied to limit
257 struct watch_notification_type_filter filters[];
260 Where "nr_filters" is the number of filters in filters[] and "__reserved"
261 should be 0. The "filters" array has elements of the following type::
287 If the argument to the ioctl() is NULL, then the filters will be removed and
|
| /Documentation/trace/ |
| D | boottime-trace.rst | 50 Add fgraph tracing function filters.
53 Add fgraph non-tracing function filters.
87 ftrace.[instance.INSTANCE.]ftrace.filters
253 ftrace.filters = "user_*"
257 ftrace.filters = "kernel_*"
|
| /Documentation/bpf/ |
| D | classic_vs_extended.rst | 208 to seccomp_data, for converted BPF filters R1 points to a skb.
220 For example, socket filters are not using ``exclusive add`` instruction, but
221 tracing filters may do to maintain counters of events, for example. Register R9
222 is not used by socket filters either, but more complex filters may be running
226 optimizations, socket filters and seccomp are using it as assembler. Tracing
227 filters may use it as assembler to generate code from kernel. In kernel usage
|
| /Documentation/networking/device_drivers/can/ctu/ |
| D | fsm_txt_buffer_user.svg | 37 …="-4.19953e-6" y="-5.60084e-6" width="1.00001" height="1.00001" color-interpolation-filters="sRGB">
43 …="-4.19953e-6" y="-5.60084e-6" width="1.00001" height="1.00001" color-interpolation-filters="sRGB">
46 …="-4.19953e-6" y="-5.60084e-6" width="1.00001" height="1.00001" color-interpolation-filters="sRGB">
49 …="-4.19953e-6" y="-5.60084e-6" width="1.00001" height="1.00001" color-interpolation-filters="sRGB">
52 …="-4.19953e-6" y="-5.60084e-6" width="1.00001" height="1.00001" color-interpolation-filters="sRGB">
55 …="-4.19953e-6" y="-5.60084e-6" width="1.00001" height="1.00001" color-interpolation-filters="sRGB">
58 …="-4.19953e-6" y="-5.60084e-6" width="1.00001" height="1.00001" color-interpolation-filters="sRGB">
61 …="-4.19953e-6" y="-5.60084e-6" width="1.00001" height="1.00001" color-interpolation-filters="sRGB">
64 …="-4.19953e-6" y="-5.60084e-6" width="1.00001" height="1.00001" color-interpolation-filters="sRGB">
|
| /Documentation/mm/ |
| D | multigen_lru.rst | 195 Bloom filters
197 Bloom filters are a space and memory efficient data structure for set
206 Note that Bloom filters are probabilistic on set membership. If a test
261 * Bloom filters for rmap/PT walk feedback
267 inserting hot densely populated page tables to the Bloom filters.
|
1234
