Searched +full:generic +full:- +full:uhci (Results 1 – 4 of 4) sorted by relevance
1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)3 ---4 $id: http://devicetree.org/schemas/usb/usb-uhci.yaml#5 $schema: http://devicetree.org/meta-schemas/core.yaml#7 title: Generic Platform UHCI Controller10 - Greg Kroah-Hartman <gregkh@linuxfoundation.org>15 - const: generic-uhci16 - const: platform-uhci18 - items:19 - enum:[all …]
45 --------------------------------------58 -----------------------------------------------72 This goes against the current documentation for pilot-xfer and other77 (this is usually /dev/ttyUSB1 if you do not have any other usb-serial79 the port to use for the HotSync transfer. The "Generic" port can be used99 Kroah-Hartman at greg@kroah.com103 -------------------115 significant advantage of using USB is speed - I can get 73 to 113120 contains the necessary packages and a simple step-by-step howto.129 iPAQ - disable autosync by going to the Start/Settings/Connections menu[all …]
12 use Universal Host Controller Interface (UHCI) or Open Host Controller15 Instead, these embedded UDC rely on the USB On-the-Go (OTG)18 Dual-Role Controller (MUSB HDRC) found in the Mentor Graphics Inventra™21 As a self-taught exercise I have written an MUSB glue layer for the28 .. _musb-basics:33 To get started on the topic, please read USB On-the-Go Basics (see46 ------------------------47 | | <------- drivers/usb/gadget48 | Linux USB Core Stack | <------- drivers/usb/host49 | | <------- drivers/usb/core[all …]
16 force -- enable ACPI if default was off17 on -- enable ACPI but allow fallback to DT [arm64,riscv64]18 off -- disable ACPI if default was on19 noirq -- do not use ACPI for IRQ routing20 strict -- Be less tolerant of platforms that are not22 rsdt -- prefer RSDT over (default) XSDT23 copy_dsdt -- copy DSDT to memory24 nospcr -- disable console in ACPI SPCR table as41 If set to vendor, prefer vendor-specific driver73 Documentation/firmware-guide/acpi/debug.rst for more information about[all …]