Searched full:gives (Results 1 – 25 of 233) sorted by relevance
12345678910
| /Documentation/trace/ |
| D | events-power.rst | 58 The first parameter gives the clock name (e.g. "gpio1_iclk").
69 The first parameter gives the power domain name (e.g. "mpu_pwrdm").
81 The first parameter gives the QoS action name (e.g. "ADD_REQ").
92 The first parameter gives the device name which tries to add/update/remove
94 The second parameter gives the request type (e.g. "DEV_PM_QOS_RESUME_LATENCY").
|
| /Documentation/sound/hd-audio/ |
| D | controls.rst | 14 It gives the number of channels to be used, "2ch", "4ch", "6ch",
23 When there are only either headphones or line-out jacks, it gives
27 When both headphone and line-out jacks are present, it gives
95 This control is provided only for VT1708 codec which gives no proper
114 It gives the number of channels to be used, "2ch", "4ch" and "6ch".
|
| /Documentation/devicetree/bindings/dma/ |
| D | renesas,rzn1-dmamux.yaml | 27 cell gives the DMA mux bit index that must be set starting from 0. The
28 sixth cell gives the binary value that must be written there, ie. 0 or 1.
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-watchdog | 33 It is a read/write file. While reading, it gives '1'
35 it gives '0'. Writing a '1' to the file enables the
45 It is a read only file. It gives active/inactive status of
|
| D | sysfs-firmware-opal-psr | 17 with chip-id X. This file gives the ratio (0-100)
|
| D | sysfs-platform-hidma-mgmt | 64 Choosing a higher number gives better performance but
85 Choosing a higher number gives better performance but
|
| D | sysfs-platform_profile | 26 Description: Reading this file gives the current selected profile for this
|
| D | debugfs-scmi-raw | 41 Each read gives back one message at time (receiving an EOF at
52 Each read gives back one message at time (receiving an EOF at
|
| D | sysfs-bus-pci-drivers-ehci_hcd | 32 Reading the file gives the list of ports currently forced
|
| /Documentation/sound/cards/ |
| D | bt87x.rst | 59 The first device (hw:X,0) gives you 16 bit stereo sound. The sample
67 The second device (hw:X,1) gives you 8 or 16 bit mono sound. Supported
|
| /Documentation/hwmon/ |
| D | pcf8591.rst | 86 The in0_input, in1_input, in2_input and in3_input files are RO. Reading gives
92 The out0_enable file is RW. Reading gives "1" for analog output enabled and
|
| D | menf21bmc.rst | 20 This driver gives access to the voltage monitoring feature of the main
|
| /Documentation/devicetree/bindings/mfd/ |
| D | st,stm32-timers.yaml | 97 "level" gives the active level (0=low or 1=high) of the
101 "filter" gives the filtering value (up to 15) to be applied.
|
| /Documentation/devicetree/bindings/iio/ |
| D | common.yaml | 28 aperture. This value gives an indication to userspace for which
|
| /Documentation/devicetree/bindings/leds/ |
| D | leds-spi-byte.txt | 5 - the value of the byte gives the brightness between two values (lowest to
|
| /Documentation/userspace-api/media/v4l/ |
| D | vidioc-queryctrl.rst | 124 - Minimum value, inclusive. This field gives a lower bound for the
130 - Maximum value, inclusive. This field gives an upper bound for the
136 - This field gives a step size for the control. See enum
148 This field gives the smallest change of an integer control
205 - Minimum value, inclusive. This field gives a lower bound for the
211 - Maximum value, inclusive. This field gives an upper bound for the
217 - This field gives a step size for the control. See enum
229 This field gives the smallest change of an integer control
|
| /Documentation/w1/slaves/ |
| D | w1_ds2406.rst | 20 The driver provides two sysfs files. state is readable; it gives the
|
| /Documentation/filesystems/bcachefs/ |
| D | errorcodes.rst | 10 This gives us much better error messages and makes debugging much easier. Any
|
| /Documentation/tools/rtla/ |
| D | rtla.rst | 26 Gives information about the operating system noise (osnoise).
|
| /Documentation/devicetree/bindings/arm/amlogic/ |
| D | amlogic,meson-gx-ao-secure.yaml | 46 information on the Meson GX SoCs. If present, the interface gives
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | avia-hx711.yaml | 14 - sck-gpio gives a clock to the sensor with 24 cycles for data retrieval
|
| /Documentation/devicetree/bindings/iio/resolver/ |
| D | adi,ad2s90.yaml | 29 most 2 * 600ns, so the max frequency should be 1 / (2 * 6e-7), which gives
|
| /Documentation/cpu-freq/ |
| D | cpufreq-stats.rst | 65 This gives the amount of time spent in each of the frequencies supported by
83 This gives the total number of frequency transitions on this CPU. The cat
|
| /Documentation/sound/soc/ |
| D | clocking.rst | 43 audio clocks as it usually gives more accurate sample rates than the CPU.
|
| /Documentation/devicetree/bindings/thermal/ |
| D | generic-adc-thermal.yaml | 39 If not specified, driver assumes the ADC channel gives milliCelsius
|
12345678910