Searched full:ide (Results 1 – 25 of 53) sorted by relevance
123
| /Documentation/arch/m68k/ |
| D | buddha-driver.rst | 2 Amiga Buddha and Catweasel IDE Driver
5 The Amiga Buddha and Catweasel IDE Driver (part of ide.c) was written by
10 Register map of the Buddha IDE controller and the
48 $800-$8ff IDE-Select 0 (Port 0, Register set 0)
50 $900-$9ff IDE-Select 1 (Port 0, Register set 1)
52 $a00-$aff IDE-Select 2 (Port 1, Register set 0)
54 $b00-$bff IDE-Select 3 (Port 1, Register set 1)
56 $c00-$cff IDE-Select 4 (Port 2, Register set 0,
59 $d00-$dff IDE-Select 5 (Port 3, Register set 1,
67 level of the IRQ-line of IDE port 0.
[all …]
|
| /Documentation/devicetree/bindings/ata/ |
| D | pata-common.yaml | 14 ATA (PATA, also known as IDE) AT attachment storage devices.
18 The PATA (IDE) controller-specific device tree bindings are responsible for
23 pattern: "^ide(@.*)?$"
26 "ide".
35 "^ide-port@[0-1]$":
39 nodes will be named "ide-port".
|
| D | cortina,gemini-sata-bridge.yaml | 58 ata0 slave interface brought out on IDE pads
61 ata1 slave interface brought out on IDE pads
64 ata0 master and slave interfaces brought out on IDE pads
67 ata1 master and slave interfaces brought out on IDE pads
69 cortina,gemini-enable-ide-pins:
71 description: Enables the PATA to IDE connection.
105 cortina,gemini-enable-ide-pins;
|
| D | cavium-compact-flash.txt | 18 - cavium,true-ide: Optional, if present the CF connection is in True IDE mode.
28 cavium,true-ide;
|
| D | faraday,ftide010.yaml | 13 This controller is the first Faraday IDE interface block, used in the
74 ide@63000000 {
83 ide-port@0 {
86 ide-port@1 {
|
| D | intel,ixp4xx-compact-flash.yaml | 14 a CompactFlash card to the system as a true IDE (parallel ATA) device. The
54 ide@1,0 {
|
| D | cirrus,ep9312-pata.yaml | 35 ide@800a0000 {
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-scsi_host | 34 Contact: linux-ide@vger.kernel.org
68 Contact: linux-ide@vger.kernel.org
87 Contact: linux-ide@vger.kernel.org
94 Contact: linux-ide@vger.kernel.org
102 Contact: linux-ide@vger.kernel.org
117 Contact: linux-ide@vger.kernel.org
|
| D | sysfs-block-device | 4 Contact: linux-ide@vger.kernel.org
26 Contact: linux-ide@vger.kernel.org
56 Contact: linux-ide@vger.kernel.org
68 Contact: linux-ide@vger.kernel.org
81 Contact: linux-ide@vger.kernel.org
90 Contact: linux-ide@vger.kernel.org
|
| /Documentation/admin-guide/blockdev/ |
| D | paride.rst | 2 Linux and parallel port IDE devices
21 The adapter chip reproduces a small ISA or IDE bus in the external device
29 IDE type devices, which require no intermediate controller. If one
33 IDE cable. It is usually possible to exchange the CD-ROM device with
34 any other device using the IDE interface.
36 The document describes the support in Linux for parallel port IDE
39 parallel port IDE subsystem, including:
61 parallel port IDE adapter chips. Thanks to the interest and encouragement of
89 In either case, you will need to select "Parallel port IDE device support"
|
| /Documentation/admin-guide/ |
| D | devices.txt | 115 3 block First MFM, RLL and IDE hard disk/CD-ROM interface
207 Partitions are handled in the same way as for IDE
509 Partitions are handled the same way as for IDE disks
516 22 block Second IDE hard disk/CD-ROM interface
628 Partitions are handled in the same way as for IDE
712 33 block Third IDE hard disk/CD-ROM interface
730 34 block Fourth IDE hard disk/CD-ROM interface
764 37 char IDE tape
765 0 = /dev/ht0 First IDE tape
766 1 = /dev/ht1 Second IDE tape
[all …]
|
| /Documentation/arch/arm/ |
| D | ixp4xx.rst | 112 Finally, there is an IDE port hanging off the expansion bus.
118 replaced with mini-PCI slots and a CF IDE interface hanging off
154 - Add support for Coyote IDE
156 - Add support for CF IDE on expansion bus
|
| /Documentation/driver-api/ |
| D | libata.rst | 28 similar to PCI IDE hardware may utilize several generic helpers,
197 Control PCI IDE BMDMA engine
208 When setting up an IDE BMDMA transaction, these hooks arm
211 IDE DMA Status register.
216 Most legacy IDE drivers use :c:func:`ata_bmdma_setup` for the
218 to the PRD table to the IDE PRD Table Address register, enable DMA in the DMA
221 Most legacy IDE drivers use :c:func:`ata_bmdma_start` for the
225 Many legacy IDE drivers use :c:func:`ata_bmdma_stop` for the
229 Many legacy IDE drivers use :c:func:`ata_bmdma_status` as the
249 tables have been prepared. IDE BMDMA drivers use the helper function
[all …]
|
| /Documentation/arch/arm/sa1100/ |
| D | lart.rst | 10 daughterboards. A quad Ethernet / IDE / PS2 / sound daughterboard
|
| /Documentation/devicetree/bindings/dma/ |
| D | cirrus,ep9301-dma-m2m.yaml | 55 11: IDE controller
|
| /Documentation/admin-guide/laptops/ |
| D | disk-shock-protection.rst | 90 IDE) configurations are concerned, there can only be two devices
99 request to the HD. Actually, when you are using an ide driver rather
|
| /Documentation/userspace-api/ioctl/ |
| D | hdio.rst | 10 the HD/IDE layer. These are by-and-large implemented (as of Linux 5.11)
21 HDIO_GET_IDENTITY get IDE identification info
108 get IDE identification info
137 This information is also available from /proc/ide/hdX/identify
463 mode, IDE driver will try to tune the transfer mode of the
|
| /Documentation/scsi/ |
| D | scsi-changer.rst | 12 nor IDE drives.
29 The SCSI changer model is complex, compared to - for example - IDE-CD
|
| D | qlogicfas.rst | 10 (including the Control Concepts SCSI/IDE/SIO/PIO/FDC cards).
|
| /Documentation/sound/cards/ |
| D | multisound.sh | 79 # access the IDE controller and joystick devices on this card when
131 # devices on the card, such as the joystick and IDE controller. To
277 # ide_io0 First I/O port of IDE controller
278 # ide_io1 Second I/O port of IDE controller
279 # ide_irq IRQ IDE controller
795 X " ide <io0> <io1> <irq> On-board IDE controller\n"
835 X printf("ide 0x%x 0x%x %d\n", io0, io1, irq);
970 X else if (strcmp(device, "ide") == 0)
|
| /Documentation/i2c/busses/ |
| D | i2c-ali15x3.rst | 80 00:0f.0 IDE interface: Acer Laboratories Inc. M5229 (rev c1)
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | nvidia,tegra20-pinmux.yaml | 62 gmi_int, hdmi, i2cp, i2c1, i2c2, i2c3, ide, irda, kbc, mio,
|
| /Documentation/driver-api/mei/ |
| D | iamt.rst | 23 - IDE device redirection from remote management console
|
| /Documentation/power/ |
| D | swsusp.rst | 20 problems. If your disk driver does not support suspend... (IDE does),
162 * assume we had special "polling" ide driver that only uses memory
466 Firewire, CompactFlash, MMC, external SATA, or even IDE hotplug bays)
|
| D | swsusp-dmcrypt.rst | 85 if [ -f /proc/ide/hde/media ]
|
123