Home
last modified time | relevance | path

Searched +full:inactive +full:- +full:delay +full:- +full:ms (Results 1 – 13 of 13) sorted by relevance

/Documentation/devicetree/bindings/power/reset/
Dgpio-poweroff.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/power/reset/gpio-poweroff.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Sebastian Reichel <sre@kernel.org>
15 from inactive to active. After a delay (active-delay-ms) it
16 is expected to be switched back to inactive. After another
17 delay (inactive-delay-ms) it is configured as active again.
19 the system is still running after waiting some time (timeout-ms).
22 - $ref: restart-handler.yaml#
[all …]
Dgpio-restart.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/power/reset/gpio-restart.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Sebastian Reichel <sre@kernel.org>
17 'open-source' is not found, the GPIO line will be driven in the inactive state. Otherwise its
22 This will also cause an inactive->active edge condition, triggering positive edge triggered
23 reset. After a delay specified by active-delay, the GPIO is set to inactive, thus causing an
24 active->inactive edge, triggering negative edge triggered reset. After a delay specified by
25 inactive-delay, the GPIO is driven active again. After a delay specified by wait-delay, the
[all …]
/Documentation/devicetree/bindings/input/
Dgpio-matrix-keypad.txt6 keypad can sense a key-press and key-release by means of GPIO lines and
10 - compatible: Should be "gpio-matrix-keypad"
11 - row-gpios: List of gpios used as row lines. The gpio specifier
14 - col-gpios: List of gpios used as column lines. The gpio specifier
17 - linux,keymap: The definition can be found at
18 bindings/input/matrix-keymap.txt
21 - linux,no-autorepeat: do no enable autorepeat feature.
22 - wakeup-source: use any event on keypad as wakeup event.
24 - debounce-delay-ms: debounce interval in milliseconds
25 - col-scan-delay-us: delay, measured in microseconds, that is needed
[all …]
Dazoteq,iqs7222.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jeff LaBundy <jeff@labundy.com>
21 - azoteq,iqs7222a
22 - azoteq,iqs7222b
23 - azoteq,iqs7222c
24 - azoteq,iqs7222d
29 irq-gpios:
32 Specifies the GPIO connected to the device's active-low RDY output.
[all …]
/Documentation/scheduler/
Dsched-deadline.rst12 3. Scheduling Real-Time Tasks
18 4.1 System-wide settings
33 system behavior. As for -rt (group) scheduling, it is assumed that root users
50 ------------------
70 with the "traditional" real-time task model (see Section 3) can effectively
76 - Each SCHED_DEADLINE task is characterized by the "runtime",
79 - The state of the task is described by a "scheduling deadline", and
82 - When a SCHED_DEADLINE task wakes up (becomes ready for execution),
86 ---------------------------------- > ---------
87 scheduling deadline - current time period
[all …]
/Documentation/devicetree/bindings/leds/
Dcommon.yaml1 # SPDX-License-Identifier: GPL-2.0-only
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Jacek Anaszewski <jacek.anaszewski@gmail.com>
11 - Pavel Machek <pavel@ucw.cz>
25 led-sources:
30 $ref: /schemas/types.yaml#/definitions/uint32-array
35 from the header include/dt-bindings/leds/common.h. If there is no
42 the header include/dt-bindings/leds/common.h. If there is no matching
48 function-enumerator:
[all …]
/Documentation/networking/
Dbonding.rst1 .. SPDX-License-Identifier: GPL-2.0
11 Corrections, HA extensions: 2000/10/03-15:
13 - Willy Tarreau <willy at meta-x.org>
14 - Constantine Gavrilov <const-g at xpert.com>
15 - Chad N. Tindel <ctindel at ieee dot org>
16 - Janice Girouard <girouard at us dot ibm dot com>
17 - Jay Vosburgh <fubar at us dot ibm dot com>
22 - Mitch Williams <mitch.a.williams at intel.com>
35 the original tools from extreme-linux and beowulf sites will not work
119 -----------------------------------------------
[all …]
/Documentation/power/
Druntime_pm.rst5 (C) 2009-2011 Rafael J. Wysocki <rjw@sisk.pl>, Novell Inc.
18 put their PM-related work items. It is strongly recommended that pm_wq be
20 them to be synchronized with system-wide power transitions (suspend to RAM,
53 The ->runtime_suspend(), ->runtime_resume() and ->runtime_idle() callbacks
57 1. PM domain of the device, if the device's PM domain object, dev->pm_domain,
60 2. Device type of the device, if both dev->type and dev->type->pm are present.
62 3. Device class of the device, if both dev->class and dev->class->pm are
65 4. Bus type of the device, if both dev->bus and dev->bus->pm are present.
69 dev->driver->pm directly (if present).
73 and bus type. Moreover, the high-priority one will always take precedence over
[all …]
/Documentation/virt/kvm/x86/
Dtimekeeping.rst1 .. SPDX-License-Identifier: GPL-2.0
4 Timekeeping Virtualization for X86-Based Architectures
32 information relevant to KVM and hardware-based virtualization.
41 2.1. i8254 - PIT
42 ----------------
46 channels which can be programmed to deliver periodic or one-shot interrupts.
53 The PIT uses I/O ports 0x40 - 0x43. Access to the 16-bit counters is done
59 -------------- ----------------
61 | 1.1932 MHz|---------->| CLOCK OUT | ---------> IRQ 0
63 -------------- | +->| GATE TIMER 0 |
[all …]
/Documentation/netlink/specs/
Dtc.yaml1 # SPDX-License-Identifier: ((GPL-2.0 WITH Linux-syscall-note) OR BSD-3-Clause)
4 protocol: netlink-raw
12 -
16 -
19 -
23 -
26 -
29 -
32 -
35 -
[all …]
/Documentation/admin-guide/
Dkernel-parameters.txt16 force -- enable ACPI if default was off
17 on -- enable ACPI but allow fallback to DT [arm64,riscv64]
18 off -- disable ACPI if default was on
19 noirq -- do not use ACPI for IRQ routing
20 strict -- Be less tolerant of platforms that are not
22 rsdt -- prefer RSDT over (default) XSDT
23 copy_dsdt -- copy DSDT to memory
24 nospcr -- disable console in ACPI SPCR table as
41 If set to vendor, prefer vendor-specific driver
73 Documentation/firmware-guide/acpi/debug.rst for more information about
[all …]
Dcgroup-v2.rst1 .. _cgroup-v2:
11 conventions of cgroup v2. It describes all userland-visible aspects
14 v1 is available under :ref:`Documentation/admin-guide/cgroup-v1/index.rst <cgroup-v1>`.
19 1-1. Terminology
20 1-2. What is cgroup?
22 2-1. Mounting
23 2-2. Organizing Processes and Threads
24 2-2-1. Processes
25 2-2-2. Threads
26 2-3. [Un]populated Notification
[all …]
/Documentation/admin-guide/pm/
Dintel_pstate.rst1 .. SPDX-License-Identifier: GPL-2.0
22 Documentation/admin-guide/pm/cpufreq.rst if you have not done that yet.]
24 For the processors supported by ``intel_pstate``, the P-state concept is broader
27 information about that). For this reason, the representation of P-states used
32 ``intel_pstate`` maps its internal representation of P-states to frequencies too
38 Since the hardware P-state selection interface used by ``intel_pstate`` is
42 equivalent to CPUs. In particular, this means that they become "inactive" every
43 time the corresponding CPU is taken offline and need to be re-initialized when
47 only way to pass early-configuration-time parameters to it is via the kernel
66 -----------
[all …]