Searched full:incorrectly (Results 1 – 25 of 45) sorted by relevance
12
17 - The graphics board incorrectly forwards EDID data to the driver.
34 dealing with problems like no sound, no video and incorrectly tuned
620 4. The :ref:`VIDIOC_OVERLAY` ioctl was incorrectly627 5. :ref:`overlay` incorrectly stated that clipping rectangles define643 1. In :ref:`pixfmt-rgb` the following pixel formats were incorrectly681 1. The :ref:`VIDIOC_CROPCAP` ioctl was incorrectly699 1. The return value of the :ref:`func-open` function was incorrectly
29 different 5 GHz subbands. Using them incorrectly could not work or
55 incorrectly accept valid tagged pointers for the ``brk()``,65 incorrectly accept valid tagged pointers for this system call.
64 In case the BIOS is broken and the mode is set incorrectly, you can force
51 incorrectly holding /dev/console open. Be sure to complain to your
40 drivers, but it was incorrectly used to specify i2c controller input clock
171 incorrectly mapping the IRQ handler entry code.174 normal interrupts. Also caused by incorrectly mapping NMI
49 Datasheet incorrectly states to use 47 decimal. 188 is the length.
111 boot firmware is incorrectly passing the address in big-endian order
107 the property incorrectly permits to define data-bus width of 8 and 16
231 host is incorrectly set to full duplex on a half duplex network.238 error is mixed with 0x82 errors it is the result of a host incorrectly set
48 ** 64 bits sg entry would be incorrectly calculated
81 incorrectly.383 incorrectly (instead of _for_device). Changed to appropriate
25 the consumer will interpret the decoded data incorrectly.
40 -EINVAL Incorrectly aligned address
34 -EINVAL Incorrectly aligned address
73 -EINVAL Incorrectly aligned address, bad redistributor region
181 vtotal:n If the video BIOS of your card incorrectly determines the total
101 vtotal:n If the video BIOS of your card incorrectly determines the total
225 incorrectly specified the ps per step as 200ps/step instead of
222 These signals affect core DCN behavior. Programming them incorrectly will lead
12 those tools incorrectly, but avoiding problems is not actually all that
180 changed and may start to work incorrectly because of that.