Searched full:initialised (Results 1 – 25 of 37) sorted by relevance
12
| /Documentation/arch/arm64/ |
| D | booting.rst | 207 level where the kernel image will be entered must be initialised by
221 - SCR_EL3.HCE (bit 8) must be initialised to 0b1.
226 - ICC_SRE_EL3.Enable (bit 3) must be initialised to 0b1.
227 - ICC_SRE_EL3.SRE (bit 0) must be initialised to 0b1.
234 - ICC.SRE_EL2.Enable (bit 3) must be initialised to 0b1
235 - ICC_SRE_EL2.SRE (bit 0) must be initialised to 0b1.
244 ICC_SRE_EL3.SRE (bit 0) must be initialised to 0b0.
248 ICC_SRE_EL2.SRE (bit 0) must be initialised to 0b0.
256 - SCR_EL3.APK (bit 16) must be initialised to 0b1
257 - SCR_EL3.API (bit 17) must be initialised to 0b1
[all …]
|
| D | pointer-authentication.rst | 92 initialised by passing flags KVM_ARM_VCPU_PTRAUTH_[ADDRESS/GENERIC] and
|
| D | asymmetric-32bit.rst | 155 re-initialised by a subsequent ``KVM_ARM_VCPU_INIT`` operation.
|
| /Documentation/arch/arm/ |
| D | porting.rst | 29 Start address of zero-initialised work area for the decompressor.
121 It is expected that the debugging region will be re-initialised
130 initialised.
|
| D | vlocks.rst | 183 to be implicitly initialised to an unlocked state simply by putting
|
| /Documentation/core-api/ |
| D | folio_queue.rst | 62 A segment should be initialised by calling::
66 with a pointer to the segment to be initialised. Note that this will not
139 initialised, and it assumed that slots won't get reused, but rather the segment
176 initialised with::
|
| D | idr.rst | 37 object with the reserved ID and finally insert the initialised object
|
| D | maple_tree.rst | 52 freshly-initialised maple tree contains a ``NULL`` pointer for the range ``0``
|
| /Documentation/devicetree/bindings/memory-controllers/ |
| D | calxeda-ddr-ctrlr.yaml | 10 The Calxeda DDR memory controller is initialised and programmed by the
|
| D | canaan,k210-sram.yaml | 11 of SRAM. The controller is initialised by the bootloader, which configures
|
| /Documentation/devicetree/bindings/net/ |
| D | calxeda-xgmac.yaml | 11 internal machine "network fabric", which is set up, initialised and
|
| /Documentation/watchdog/ |
| D | mlx-wdt.rst | 51 Watchdog can be initialised in nowayout way, i.e. oncse started
|
| /Documentation/ABI/stable/ |
| D | sysfs-class-rfkill | 37 Description: Whether the soft blocked state is initialised from non-volatile
|
| D | sysfs-bus-xen-backend | 83 'Initialising', 'Initialised', 'Connected', 'Closing',
|
| /Documentation/virt/kvm/arm/ |
| D | pkvm.rst | 79 with the vCPU registers being initialised to their architecturally-defined
|
| /Documentation/driver-api/media/ |
| D | mc-core.rst | 49 :c:func:`media_device_unregister()`. An initialised media device must be
54 previously initialised.
|
| /Documentation/bpf/ |
| D | bpf_prog_run.rst | 102 pages of the same size as the batch size. Each memory page will be initialised
|
| /Documentation/devicetree/bindings/pci/ |
| D | host-generic-pci.yaml | 13 Firmware-initialised PCI host controllers and PCI emulations, such as the
|
| /Documentation/networking/ |
| D | dccp.rst | 72 initialised from /proc/sys/net/dccp/default/tx_qlen.
|
| /Documentation/devicetree/bindings/regulator/ |
| D | regulator.yaml | 60 disabling ramp rate, it should be explicitly initialised to zero (regulator-ramp-delay
|
| /Documentation/dev-tools/ |
| D | kmemleak.rst | 69 Memory may be allocated or freed before kmemleak is initialised and
|
| /Documentation/admin-guide/ |
| D | parport.rst | 209 Once the parport code is initialised, you can attach device drivers to
|
| /Documentation/admin-guide/blockdev/ |
| D | zram.rst | 46 the device has been initialised. Please reset device first.
95 or change the selected compression algorithm (once the device is initialised
|
| /Documentation/PCI/ |
| D | msi-howto.rst | 72 PCI devices are initialised to use pin-based interrupts. The device
|
| /Documentation/filesystems/ |
| D | gfs2-glocks.rst | 143 The per-glock counters are initialised to zero when the
|
12