| /Documentation/admin-guide/media/ |
| D | omap3isp.rst | 5 OMAP 3 Image Signal Processor (ISP) driver
19 This file documents the Texas Instruments OMAP 3 Image Signal Processor (ISP)
38 The OMAP 3 ISP is split into V4L2 subdevs, each of the blocks inside the ISP
42 - OMAP3 ISP CCP2
43 - OMAP3 ISP CSI2a
44 - OMAP3 ISP CCDC
45 - OMAP3 ISP preview
46 - OMAP3 ISP resizer
47 - OMAP3 ISP AEWB
48 - OMAP3 ISP AF
[all …]
|
| D | raspberrypi-pisp-be.rst | 4 Raspberry Pi PiSP Back End Memory-to-Memory ISP (pisp-be)
10 The PiSP Back End is a memory-to-memory Image Signal Processor (ISP) which reads
15 The ISP registers and programming model are documented in the `Raspberry Pi
18 The PiSP Back End ISP processes images in tiles. The handling of image
35 a subdevice for the ISP that connects the video devices in a single media graph
49 - pispbe-input: output device for images to be submitted to the ISP for
57 - pispbe-config: output device for ISP configuration parameters.
62 Images to be processed by the ISP are queued to the `pispbe-input` output device
63 node. For a list of image formats supported as input to the ISP refer to the
88 The two capture devices write to memory the pixel data as processed by the ISP.
[all …]
|
| D | starfive_camss.rst | 31 | MIPI |----->| |----->| ISP |----->| |
46 - ISP: The ISP, processing raw Bayer data from an image sensor and producing
65 ISP module
69 - stf_isp: is responsible for all the isp operations, outputs YUV frames.
|
| D | rkisp1.rst | 19 There exist multiple smaller revisions to this ISP that got introduced in
21 in the UAPI and the revision of the ISP inside the running SoC can be read
56 - rkisp1_isp: is connected to the sensor and is responsible for all the isp
86 This is the isp entity. It is connected to the sensor on sink pad 0 and
117 The ISP driver supports two different parameters configuration methods, the
174 isp source pad `rkisp1_isp:2`. Another cropping operation is configured on
175 the isp source pad: `(0,0)/1500x1100`.
197 isp (`rkisp1_isp:2`). The quantization configured on this pad is the
|
| /Documentation/devicetree/bindings/display/tegra/ |
| D | nvidia,tegra20-isp.yaml | 4 $id: http://devicetree.org/schemas/display/tegra/nvidia,tegra20-isp.yaml#
7 title: NVIDIA Tegra ISP processor
16 - nvidia,tegra20-isp
17 - nvidia,tegra30-isp
18 - nvidia,tegra210-isp
36 - const: isp
60 isp@54100000 {
61 compatible = "nvidia,tegra20-isp";
66 reset-names = "isp";
|
| /Documentation/translations/zh_CN/video4linux/ |
| D | omap3isp.txt | 29 OMAP 3 图像信号处理器 (ISP) 驱动
43 （TI）OMAP 3 图像信号处理器 (ISP) 驱动。原始驱动由德州仪器（TI）
59 OMAP 3 ISP 被拆分为 V4L2 子设备，ISP中的每个模块都由一个子设备
62 OMAP3 ISP CCP2
63 OMAP3 ISP CSI2a
64 OMAP3 ISP CCDC
65 OMAP3 ISP preview
66 OMAP3 ISP resizer
67 OMAP3 ISP AEWB
68 OMAP3 ISP AF
[all …]
|
| /Documentation/devicetree/bindings/media/ |
| D | ti,omap3isp.txt | 1 OMAP 3 ISP Device Tree bindings
4 The DT definitions can be found in include/dt-bindings/media/omap3-isp.h.
9 compatible : must contain "ti,omap3-isp"
12 ISP. The first set contains the core ISP registers up to
15 interrupts : the ISP interrupt specifier
16 iommus : phandle and IOMMU specifier for the IOMMU that serves the ISP
21 #clock-cells : Must be 1 --- the ISP provides two external clocks,
58 isp@480bc000 {
59 compatible = "ti,omap3-isp";
|
| D | rockchip-isp1.yaml | 19 - fsl,imx8mp-isp
20 - rockchip,px30-cif-isp
21 - rockchip,rk3399-cif-isp
32 - const: isp
40 - description: ISP clock (for imx8mp, clk)
41 - description: ISP AXI clock (for imx8mp, m_hclk)
42 - description: ISP AHB clock (for imx8mp, hclk)
44 - description: ISP Pixel clock
50 - const: isp
60 A phandle to the media block control for the ISP, followed by a cell
[all …]
|
| D | allwinner,sun6i-a31-isp.yaml | 4 $id: http://devicetree.org/schemas/media/allwinner,sun6i-a31-isp.yaml#
7 title: Allwinner A31 Image Signal Processor Driver (ISP)
15 - allwinner,sun6i-a31-isp
16 - allwinner,sun8i-v3s-isp
56 - allwinner,sun8i-v3s-isp
77 isp: isp@1cb8000 {
78 compatible = "allwinner,sun8i-v3s-isp";
|
| D | samsung,exynos4212-fimc-is.yaml | 16 processor, ISP, DRC and FD IP blocks and peripheral devices such as UART, I2C
44 - const: isp
70 - const: isp
82 power/start the ISP.
100 "^i2c-isp@[0-9a-f]+$":
105 ISP I2C bus controller
109 const: samsung,exynos4212-i2c-isp
179 "ppmuispmx", "isp",
188 iommu-names = "isp", "drc", "fd", "mcuctl";
196 i2c-isp@12140000 {
[all …]
|
| D | starfive,jh7110-camss.yaml | 7 title: Starfive SoC CAMSS ISP
14 The Starfive CAMSS ISP is a Camera interface for Starfive JH7110 SoC. It
16 and an ISP.
28 - const: isp
57 - description: JH7110 ISP Power Domain Switch Controller.
123 isp@19840000 {
127 reg-names = "syscon", "isp";
|
| D | raspberrypi,pispbe.yaml | 7 title: Raspberry Pi PiSP Image Signal Processor (ISP) Back End
14 The Raspberry Pi PiSP Image Signal Processor (ISP) Back End is an image
18 The full ISP documentation is available at
56 isp@880000 {
|
| D | renesas,isp.yaml | 5 $id: http://devicetree.org/schemas/media/renesas,isp.yaml#
8 title: Renesas R-Car ISP Channel Selector
14 The R-Car ISP Channel Selector provides MIPI CSI-2 VC and DT filtering
23 - renesas,r8a779a0-isp # V3U
24 - renesas,r8a779g0-isp # V4H
118 isp1: isp@fed20000 {
119 compatible = "renesas,r8a779a0-isp";
|
| D | samsung,exynos4210-fimc.yaml | 53 samsung,isp-wb:
56 The FIMC IP block has the ISP writeback input.
120 - samsung,isp-wb
145 samsung,isp-wb;
|
| D | allwinner,sun4i-a10-csi.yaml | 43 - description: The CSI ISP clock
54 - const: isp
114 clock-names = "bus", "isp", "ram";
|
| D | samsung,fimc.yaml | 17 CSIS, FIMC-LITE and FIMC-IS (ISP).
149 samsung,isp-wb;
229 "ppmuispmx", "isp",
238 iommu-names = "isp", "drc", "fd", "mcuctl";
246 i2c-isp@940000 {
247 compatible = "samsung,exynos4212-i2c-isp";
|
| /Documentation/devicetree/bindings/clock/ |
| D | samsung,exynos4412-isp-clock.yaml | 4 $id: http://devicetree.org/schemas/clock/samsung,exynos4412-isp-clock.yaml#
7 title: Samsung Exynos4412 SoC ISP clock controller
16 Clock controller for Samsung Exynos4412 SoC FIMC-ISP (Camera ISP)
22 const: samsung,exynos4412-isp-clock
57 compatible = "samsung,exynos4412-isp-clock";
|
| D | starfive,jh7110-ispcrg.yaml | 21 - description: ISP Top core
22 - description: ISP Top Axi
23 - description: NOC ISP Bus
35 - description: ISP Top core
36 - description: ISP Top Axi
37 - description: NOC ISP Bus
52 ISP domain power
|
| /Documentation/userspace-api/media/v4l/ |
| D | metafmt-pisp-be.rst | 23 provide detailed description of the ISP back end configuration and programming
34 Global configuration data are passed to the ISP by populating the member of
40 As the ISP processes images in tiles, each set of tiles parameters describe how
45 Tiles parameters are passed to the ISP by populating the member of
|
| D | metafmt-rkisp1.rst | 13 The configuration of the RkISP1 ISP is performed by userspace by providing
14 parameters for the ISP to the driver using the :c:type:`v4l2_meta_format`
17 There are two methods that allow to configure the ISP, the `fixed parameters`
38 This method supports a subset of the ISP features only, new applications should
53 populate the data buffer with only the configuration data for the ISP blocks it
|
| /Documentation/userspace-api/media/drivers/ |
| D | omap3isp-uapi.rst | 5 OMAP 3 Image Signal Processor (ISP) driver
19 The OMAP 3 ISP driver does support the V4L2 event interface on CCDC and
50 The OMAP 3 ISP driver supports standard V4L2 IOCTLs and controls where
51 possible and practical. Much of the functions provided by the ISP, however,
69 include/linux/omap3isp.h. The detailed functions of the ISP itself related to
70 a given ISP block is described in the Technical Reference Manuals (TRMs) ---
73 While it is possible to use the ISP driver without any use of these private
149 reflected by the register level interface offered by the ISP hardware. There
|
| /Documentation/devicetree/bindings/soc/imx/ |
| D | fsl,imx8mp-media-blk-ctrl.yaml | 47 - const: isp
59 - description: The core clock for the ISP (clk)
70 - const: isp
118 "mipi-csi2", "lcdif2", "isp", "dwe", "mipi-dsi2";
128 "isp", "phy";
|
| /Documentation/devicetree/bindings/soc/mediatek/ |
| D | scpsys.txt | 39 CG: "mm-0", "mm-1", "mm-2", "mm-3", "isp-0",
40 "isp-1", "cam-0", "cam-1", "cam-2",
50 - isp-supply: Power supply for the isp power domain
|
| /Documentation/devicetree/bindings/soc/bcm/ |
| D | brcm,bcm2835-pm.yaml | 53 - const: isp
84 clock-names = "v3d", "peri_image", "h264", "isp";
|
| /Documentation/devicetree/bindings/leds/ |
| D | skyworks,aat1290.yaml | 58 - const: isp
83 pinctrl-names = "default", "host", "isp";
|