Searched full:least (Results 1 – 25 of 602) sorted by relevance
12345678910>>...25
| /Documentation/ABI/stable/ |
| D | sysfs-bus-mhi | 6 using a BHI (Boot Host Interface) register read after at least
8 without having the device power on at least once, the file will
18 at least one attempt to power up the device has been done. If
19 read without having the device power on at least once, the file
|
| D | sysfs-bus-usb | 91 KernelVersion: since at least 2.6.18
98 KernelVersion: since at least 2.6.18
137 KernelVersion: since at least 2.6.18
|
| /Documentation/driver-api/media/drivers/ |
| D | rkisp1.rst | 12 - V10: used at least in rk3288 and rk3399
14 - V12: used at least in rk3326 and px30
15 - V13: used at least in rk1808
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | fsl,imx25-gcq.yaml | 29 Required when at least one subnode uses the this reference.
34 Required when at least one subnode uses this reference.
39 Required when at least one subnode uses this reference.
|
| /Documentation/userspace-api/media/mediactl/ |
| D | media-types.rst | 144 composing must have at least two sink pads and one source
152 must have at least one sink pad and one source pad. Read
161 encoding conversion must have at least one sink pad and one
179 at least one sink pad and one source pad, and scale the
197 compressing video frames. Must have one sink pad and at least
203 frames. Must have one sink pad and at least one source pad.
213 least two sink pads and one source pad, and must pass the video
218 least one sink pad and at least one source pad. It receives video
379 be connected by at least one enabled link. There could be temporary
|
| D | media-request-ioc-queue.rst | 51 A request must contain at least one buffer, otherwise this ioctl will
67 to have at least one buffer. This can also be returned if some required
|
| /Documentation/userspace-api/media/rc/ |
| D | lirc-set-transmitter-mask.rst | 29 Mask with channels to enable tx. Channel 0 is the least significant bit.
40 encoded by the least significant bit and so on.
|
| /Documentation/devicetree/bindings/sound/ |
| D | amlogic,axg-sound-card.yaml | 42 There should be at least one (and probably more) subnode of this type
80 interface must have at least one slot, so at least one these
87 dai-link representing backend links should have at least one subnode.
|
| D | amlogic,gx-sound-card.yaml | 44 There should be at least one (and probably more) subnode of this type
67 dai-link representing backend links should have at least one subnode.
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-net-cdc_ncm | 48 least one max sized datagram plus headers.
64 least one max sized datagram plus headers.
127 be a power of 2, and shall be at least 4.
159 pipe. Shall be a power of 2, and shall be at least 4.
|
| D | debugfs-wilco-ec | 26 request, starting at MBOX[0]. At least three bytes are required
27 for writing, two for the type and at least a single byte of
|
| /Documentation/hwmon/ |
| D | adc128d818.rst | 39 is read at least once. This means that the cause for the alarm may
41 caches the alarm status for each sensor until it is at least reported
|
| D | gl518sm.rst | 34 This driver supports the Genesys Logic GL518SM chip. There are at least
73 is read at least once (except for temperature alarms). This means that the
|
| /Documentation/admin-guide/device-mapper/ |
| D | striped.rst | 15 Size of each chunk of data. Must be at least as
43 die("Specify at least one device\n");
|
| /Documentation/admin-guide/ |
| D | syscall-user-dispatch.rst | 35 architectures, like x86, but at least for Wine, syscalls issued by
37 since they are quite rare, at least for modern gaming applications.
66 interface should make sure that at least the signal trampoline code is
|
| D | abi-stable.rst | 8 for at least 2 years.
|
| /Documentation/devicetree/bindings/mux/ |
| D | gpio-mux.yaml | 17 multiplexer GPIO pins, where the first pin is the least significant
26 List of gpios used to control the multiplexer, least significant bit first.
|
| /Documentation/devicetree/bindings/display/tilcdc/ |
| D | panel.txt | 13 - raster-order: Raster Data Order Select: 1=Most-to-least 0=Least-to-most
|
| /Documentation/userspace-api/media/cec/ |
| D | cec-pin-error-inj.rst | 162 a specific CEC opcode then the bit position must be at least 18,
176 was at least 2 bytes long. This is useful to test the high-level
237 Drop the last byte from the message, provided the message is at least
243 must be at least 18, otherwise the opcode hasn't been received yet.
258 must be at least 18, otherwise the opcode hasn't been received yet.
294 opcode then the bit position must be at least 18, otherwise the opcode
301 specific CEC opcode then the bit position must be at least 18, otherwise
323 position must be at least 18, otherwise the opcode hasn't been received yet.
|
| /Documentation/devicetree/bindings/input/ |
| D | gpio-decoder.txt | 5 - gpios: a spec of gpios (at least two) to be decoded to a number with
|
| /Documentation/driver-api/nvdimm/ |
| D | firmware-activate.rst | 11 transactions. However, reboots are disruptive and at least the Intel
28 At least one device is armed
|
| /Documentation/devicetree/bindings/hwmon/ |
| D | npcm750-pwm-fan.txt | 30 Each fan subnode must have one PWM channel and at least one Fan tach channel.
44 At least one Fan tach input channel is required
|
| /Documentation/arch/x86/ |
| D | booting-dt.rst | 12 which requires at least boot protocol 2.09.
|
| /Documentation/devicetree/bindings/powerpc/fsl/ |
| D | diu.txt | 8 - reg : should contain at least address and length of the DIU register
|
| /Documentation/devicetree/bindings/display/armada/ |
| D | marvell,dove-lcd.txt | 18 Note: all clocks are optional but at least one must be specified.
|
12345678910>>...25