Searched +full:local +full:- +full:bd +full:- +full:address (Results 1 – 7 of 7) sorted by relevance
| /Documentation/devicetree/bindings/net/bluetooth/ |
| D | brcm,bcm4377-bluetooth.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/net/bluetooth/brcm,bcm4377-bluetooth.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Sven Peter <sven@svenpeter.dev> 13 This binding describes Broadcom BCM4377 family PCIe-attached bluetooth chips 14 usually found in Apple machines. The Wi-Fi part of the chip is described in 15 bindings/net/wireless/brcm,bcm4329-fmac.yaml. 18 - $ref: bluetooth-controller.yaml# 23 - pci14e4,5fa0 # BCM4377 [all …]
|
| D | bluetooth-controller.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/net/bluetooth/bluetooth-controller.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Marcel Holtmann <marcel@holtmann.org> 11 - Johan Hedberg <johan.hedberg@gmail.com> 12 - Luiz Augusto von Dentz <luiz.dentz@gmail.com> 18 local-bd-address: 19 $ref: /schemas/types.yaml#/definitions/uint8-array 22 Specifies the BD address that was uniquely assigned to the Bluetooth [all …]
|
| D | qualcomm-bluetooth.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/net/bluetooth/qualcomm-bluetooth.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Balakrishna Godavarthi <quic_bgodavar@quicinc.com> 11 - Rocky Liao <quic_rjliao@quicinc.com> 14 This binding describes Qualcomm UART-attached bluetooth chips. 19 - qcom,qca2066-bt 20 - qcom,qca6174-bt 21 - qcom,qca9377-bt [all …]
|
| /Documentation/devicetree/bindings/net/ |
| D | davinci_emac.txt | 7 - compatible: "ti,davinci-dm6467-emac", "ti,am3517-emac" or 8 "ti,dm816-emac" 9 - reg: Offset and length of the register set for the device 10 - ti,davinci-ctrl-reg-offset: offset to control register 11 - ti,davinci-ctrl-mod-reg-offset: offset to control module register 12 - ti,davinci-ctrl-ram-offset: offset to control module ram 13 - ti,davinci-ctrl-ram-size: size of control module ram 14 - interrupts: interrupt mapping for the davinci emac interrupts sources: 21 - phy-handle: See ethernet.txt file in the same directory. 23 - ti,davinci-rmii-en: 1 byte, 1 means use RMII [all …]
|
| D | fsl-tsec-phy.txt | 5 the definition of the PHY node in booting-without-of.txt for an example 9 - reg : Offset and length of the register set for the device, and optionally 10 the offset and length of the TBIPA register (TBI PHY address 14 - compatible : Should define the compatible device type for the 16 - "fsl,gianfar-tbi" 17 - "fsl,gianfar-mdio" 18 - "fsl,etsec2-tbi" 19 - "fsl,etsec2-mdio" 20 - "fsl,ucc-mdio" 21 - "fsl,fman-mdio" [all …]
|
| /Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,wcnss.yaml | 1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause 3 --- 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 10 - Andy Gross <agross@kernel.org> 11 - Bjorn Andersson <bjorn.andersson@linaro.org> 21 firmware-name: 32 - qcom,riva" 33 - qcom,pronto" 35 qcom,smd-channels: 46 - $ref: /schemas/net/bluetooth/bluetooth-controller.yaml# [all …]
|
| /Documentation/admin-guide/ |
| D | kernel-parameters.txt | 16 force -- enable ACPI if default was off 17 on -- enable ACPI but allow fallback to DT [arm64,riscv64] 18 off -- disable ACPI if default was on 19 noirq -- do not use ACPI for IRQ routing 20 strict -- Be less tolerant of platforms that are not 22 rsdt -- prefer RSDT over (default) XSDT 23 copy_dsdt -- copy DSDT to memory 24 nospcr -- disable console in ACPI SPCR table as 41 If set to vendor, prefer vendor-specific driver 73 Documentation/firmware-guide/acpi/debug.rst for more information about [all …]
|