Searched full:lost (Results 1 – 25 of 135) sorted by relevance
123456
| /Documentation/scsi/scsi_transport_srp/ |
| D | rport_state_diagram.dot | 2 node [shape = doublecircle]; running lost;
12 lost;
19 blocked -> lost [ label = "dev_loss_tmo\nexpired or\nsrp_stop_rport_timers()" ];
20 failfast -> lost [ label = "dev_loss_tmo\nexpired or\nsrp_stop_rport_timers()" ];
24 running -> lost [ label = "srp_stop_rport_timers()" ];
25 running_rta -> lost [ label = "srp_stop_rport_timers()" ];
|
| /Documentation/admin-guide/blockdev/drbd/ |
| D | peer-states-8.dot | 4 Primary -> Unknown [ label = "connection lost" ]
5 Secondary -> Unknown [ label = "connection lost" ]
|
| /Documentation/userspace-api/media/cec/ |
| D | cec-ioc-dqevent.rst | 44 the same state). In that case the intermediate state changes were lost but
86 - Set to the number of lost messages since the filehandle was opened
88 filehandle. The messages lost are the oldest messages. So when a
126 - The number of lost messages as sent by the :ref:`CEC_EVENT_LOST_MSGS <CEC-EVENT-LOST-MSGS>`
147 * .. _`CEC-EVENT-LOST-MSGS`:
151 - Generated if one or more CEC messages were lost because the
|
| D | cec-pin-error-inj.rst | 49 # any[,<mode>] rx-arb-lost [<poll>] generate a POLL message to trigger an arbitration lost
75 # <poll> CEC poll message used to test arbitration lost (0x00-0xff, default 0x0f)
166 be interpreted as an Arbitration Lost condition by the transmitter.
179 ``<op>[,<mode>] rx-arb-lost <poll>``
180 Generate a POLL message to trigger an Arbitration Lost condition.
186 This command can be used to test the Arbitration Lost condition in
190 stop transmitting ('Arbitration Lost'). This is very hard to test,
251 because the receiver also looks for an Arbitration Lost condition in
269 because the receiver also looks for an Arbitration Lost condition in
304 positions 0-3 the receiver can interpret this as an Arbitration Lost
|
| D | cec-ioc-receive.rst | 180 Arbitration Lost error. This is only set if the hardware supports
182 :ref:`CEC_TX_STATUS_ARB_LOST <CEC-TX-STATUS-ARB-LOST>` status bit is set.
192 Arbitration Lost error. This is only set if the hardware supports
198 Lost or Not Acknowledged. This is only set if the hardware
267 * .. _`CEC-TX-STATUS-ARB-LOST`:
271 - CEC line arbitration was lost, i.e. another transmit started at the
|
| /Documentation/filesystems/ext4/ |
| D | special_inodes.rst | 37 …- Traditional first non-reserved inode. Usually this is the lost+found directory. See s_first_ino …
51 - Inode number of lost+found directory.
|
| /Documentation/trace/ |
| D | mmiotrace.rst | 44 Check for lost events.
85 $ grep -i lost mydump.txt
87 which tells you exactly how many events were lost, or use::
91 to view your kernel log and look for "mmiotrace has lost events" warning. If
92 events were lost, the trace is incomplete. You should enlarge the buffers and
|
| /Documentation/driver-api/md/ |
| D | raid5-ppl.rst | 36 silent data corruption. If a dirty disk of a stripe is lost, no PPL recovery is
38 arbitrary data in the written part of a stripe if that disk is lost. In such
|
| /Documentation/gpu/rfc/ |
| D | index.rst | 6 design issues before getting lost in the code details. This section is meant to
|
| /Documentation/arch/arm/omap/ |
| D | omap_pm.rst | 50 5. Return the number of times the device has lost context::
109 device has lost its internal context. If context has been lost, the
|
| /Documentation/i2c/ |
| D | gpio-fault-injection.rst | 86 Lost arbitration
99 Arbitration lost is achieved by waiting for SCL going down by the master under
103 There doesn't need to be a device at this address because arbitration lost
|
| /Documentation/userspace-api/media/dvb/ |
| D | fe-get-event.rst | 64 - Overflow in event queue - one or more events were lost.
|
| D | dmx-fread.rst | 66 resulting in non-read data being lost. The buffer is flushed.
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | lltc,ltc294x.yaml | 45 The setting is lost when the battery is disconnected.
|
| /Documentation/userspace-api/media/v4l/ |
| D | dev-event.rst | 45 is lost, but only an intermediate step leading up to that
|
| D | vidioc-dqevent.rst | 83 not contiguous it means that events have been lost.
144 This event type will ensure that no information is lost when more
356 any, the signal may also have been lost).
|
| D | vidioc-streamon.rst | 57 means all images captured but not dequeued yet will be lost, likewise
|
| /Documentation/networking/ |
| D | tcp-thin.rst | 25 In order to reduce application-layer latency when packets are lost,
|
| /Documentation/networking/devlink/ |
| D | devlink-reload.rst | 64 configuration is lost.
|
| /Documentation/netlink/specs/ |
| D | ovs_datapath.yaml | 49 name: n-lost
|
| /Documentation/devicetree/bindings/i2c/ |
| D | renesas,riic.yaml | 45 - description: Arbitration-Lost Interrupt
|
| /Documentation/admin-guide/ |
| D | filesystem-monitoring.rst | 28 important pieces of information are never lost.
|
| /Documentation/networking/device_drivers/atm/ |
| D | cxacru.rst | 90 - "lost"
|
| /Documentation/ABI/stable/ |
| D | sysfs-transport-srp | 56 "dev_loss_tmo" timer has fired; "lost" after the
|
| /Documentation/PCI/endpoint/ |
| D | pci-endpoint.rst | 173 * unbind: ops to perform when a binding has been lost between a EPC
231 and EPF device is lost.
|
123456