Searched +full:lpc3220 +full:- +full:gpio (Results 1 – 4 of 4) sorted by relevance
| /Documentation/devicetree/bindings/gpio/ |
| D | nxp,lpc3220-gpio.yaml | 1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/gpio/nxp,lpc3220-gpio.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: NXP LPC3220 SoC GPIO controller
10 - Animesh Agarwal <animeshagarwal28@gmail.com>
14 const: nxp,lpc3220-gpio
19 gpio-controller: true
21 '#gpio-cells':
25 0: GPIO P0
[all …]
|
| /Documentation/devicetree/bindings/mtd/ |
| D | lpc32xx-mlc.txt | 4 - compatible: "nxp,lpc3220-mlc"
5 - reg: Address and size of the controller
6 - interrupts: The NAND interrupt specification
7 - gpios: GPIO specification for NAND write protect
13 - nxp,tcea_delay: TCEA_DELAY
14 - nxp,busy_delay: BUSY_DELAY
15 - nxp,nand_ta: NAND_TA
16 - nxp,rd_high: RD_HIGH
17 - nxp,rd_low: RD_LOW
18 - nxp,wr_high: WR_HIGH
[all …]
|
| D | lpc32xx-slc.txt | 4 - compatible: "nxp,lpc3220-slc"
5 - reg: Address and size of the controller
6 - nand-on-flash-bbt: Use bad block table on flash
7 - gpios: GPIO specification for NAND write protect
11 - nxp,wdr-clks: Delay before Ready signal is tested on write (W_RDY)
12 - nxp,rdr-clks: Delay before Ready signal is tested on read (R_RDY)
15 - nxp,wwidth: Write pulse width (W_WIDTH)
16 - nxp,whold: Write hold time (W_HOLD)
17 - nxp,wsetup: Write setup time (W_SETUP)
18 - nxp,rwidth: Read pulse width (R_WIDTH)
[all …]
|
| /Documentation/devicetree/bindings/serial/ |
| D | 8250.yaml | 3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - devicetree@vger.kernel.org
13 - $ref: serial.yaml#
14 - $ref: /schemas/memory-controllers/mc-peripheral-props.yaml#
15 - if:
17 - required:
18 - aspeed,lpc-io-reg
19 - required:
20 - aspeed,lpc-interrupts
[all …]
|