Home
last modified time | relevance | path

Searched full:mainly (Results 1 – 25 of 114) sorted by relevance

12345

/Documentation/devicetree/bindings/sound/
Dwidgets.txt3 This mainly specifies audio off-codec DAPM widgets.
/Documentation/devicetree/bindings/pwm/
Dti,twl-pwmled.txt5 On TWL6030 series: LED PWM (mainly used as charging indicator LED)
/Documentation/ABI/testing/
Dsysfs-bus-hsi7 serial interface mainly used for connecting application
Dsysfs-bus-surface_aggregator-tabletsw47 back and the device operates mainly based on touch input.
/Documentation/virt/geniezone/
Dintroduction.rst46 Communication among guest VMs is provided mainly on RPC. More communication
70 management for the protected VMs. The capability is mainly about the lifecycle
/Documentation/devicetree/bindings/media/
Dcnm,wave521c.yaml43 storing it on DMA memory. It is mainly used for the purpose of reducing
/Documentation/admin-guide/nfs/
Dnfsd-admin-interfaces.rst8 nfsd is controlled mainly by pseudofiles under the "nfsd" filesystem,
/Documentation/filesystems/ext4/
Dbigalloc.rst17 file system is mainly going to be storing large files in the 4-32
/Documentation/devicetree/bindings/arm/
Darm,integrator.yaml33 a compact form factor and mainly consists of the bare minimum
Darm,coresight-cpu-debug.yaml18 external debug module is mainly used for two modes: self-hosted debug and
/Documentation/leds/
Dleds-lp3944.rst43 The chip is used mainly in embedded contexts, so this driver expects it is
/Documentation/devicetree/bindings/reset/
Drenesas,rzg2l-usbphy-ctrl.yaml13 The RZ/G2L USBPHY Control mainly controls reset and power down of the
/Documentation/devicetree/bindings/memory-controllers/
Dqca,ath79-ddr-controller.yaml14 flush the FIFO between various devices and the DDR. This is mainly used by
/Documentation/devicetree/bindings/i2c/
Dti,omap4-i2c.yaml45 This property is applicable only on legacy platforms mainly omap2/3
/Documentation/devicetree/bindings/interrupt-controller/
Dintel,ce4100-lapic.yaml44 modes. With respect to boot/init time, mainly two interrupt
/Documentation/arch/arm/
Dinterrupts.rst13 There is more assembly code inside each of these functions, mainly to
48 We also bring the idea of an IRQ "chip" (mainly to reduce the size of
/Documentation/arch/x86/
Dzero-page.rst8 real-mode setup code of the kernel. References/settings to it mainly
/Documentation/userspace-api/media/v4l/
Dpixfmt-intro.rst26 The V4L2 standard formats are mainly uncompressed formats. The pixels
/Documentation/devicetree/bindings/serial/
D8250_omap.yaml36 This property is applicable only on legacy platforms mainly omap2/3
/Documentation/devicetree/bindings/powerpc/nintendo/
Dgamecube.txt58 Represents the non cpu-addressable ram designed mainly to store audio
/Documentation/admin-guide/media/
Dipu6-isys.rst29 The Input System mainly works as MIPI CSI-2 receiver which receives and
45 The Input System driver mainly configures CSI-2 D-PHY, constructs the firmware
/Documentation/devicetree/bindings/pci/
Dsnps,dw-pcie-ep.yaml56 mainly relevant for the end-point controller configuration,
87 region, but mainly these registers are indirectly accessible
Dsnps,dw-pcie.yaml65 mainly relevant for the end-point controller configuration,
96 region, but mainly these registers are indirectly accessible
/Documentation/devicetree/bindings/spi/
Domap-spi.yaml50 This property is applicable only on legacy platforms mainly omap2/3
/Documentation/i2c/busses/
Di2c-viapro.rst74 are mainly useful to read from and write to EEPROMs.

12345