Home
last modified time | relevance | path

Searched +full:micbias +full:- +full:lvl (Results 1 – 5 of 5) sorted by relevance

/Documentation/devicetree/bindings/sound/
Dcs42l52.txt5 - compatible : "cirrus,cs42l52"
7 - reg : the I2C address of the device for I2C
11 - cirrus,reset-gpio : GPIO controller's phandle and the number
14 - cirrus,chgfreq-divisor : Values used to set the Charge Pump Frequency.
21 - cirrus,mica-differential-cfg : boolean, If present, then the MICA input is configured
23 Single-ended input. Single-ended mode allows for MIC1 or MIC2 muxing for input.
25 - cirrus,micb-differential-cfg : boolean, If present, then the MICB input is configured
27 Single-ended input. Single-ended mode allows for MIC1 or MIC2 muxing for input.
29 - cirrus,micbias-lvl: Set the output voltage level on the MICBIAS Pin
42 reset-gpio = <&gpio 10 0>;
[all …]
Dcs42l56.txt5 - compatible : "cirrus,cs42l56"
7 - reg : the I2C address of the device for I2C
9 - VA-supply, VCP-supply, VLDO-supply : power supplies for the device,
14 - cirrus,gpio-nreset : GPIO controller's phandle and the number
17 - cirrus,chgfreq-divisor : Values used to set the Charge Pump Frequency.
24 - cirrus,ain1a-ref-cfg, ain1b-ref-cfg : boolean, If present, AIN1A or AIN1B are configured
25 as a pseudo-differential input referenced to AIN1REF/AIN3A.
27 - cirrus,ain2a-ref-cfg, ain2b-ref-cfg : boolean, If present, AIN2A or AIN2B are configured
28 as a pseudo-differential input referenced to AIN2REF/AIN3B.
30 - cirrus,micbias-lvl: Set the output voltage level on the MICBIAS Pin.
[all …]
Dcs53l30.txt5 - compatible : "cirrus,cs53l30"
7 - reg : the I2C address of the device
9 - VA-supply, VP-supply : power supplies for the device,
14 - reset-gpios : a GPIO spec for the reset pin.
16 - mute-gpios : a GPIO spec for the MUTE pin. The active state can be either
20 - cirrus,micbias-lvl : Set the output voltage level on the MICBIAS Pin.
21 0 = Hi-Z
25 - cirrus,use-sdout2 : This is a boolean property. If present, it indicates
29 * CS53l30 supports 4-channel data output in the same
31 * 1) Normal I2S mode on two data pins -- each SDOUT
[all …]
Ddialog,da7219.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - David Rau <David.Rau.opensource@dm.renesas.com>
13 The DA7219 is an ultra low-power audio codec with
14 in-built advanced accessory detection (AAD) for mobile
16 sample rates up to 96 kHz at 24-bit resolution.
28 VDD-supply:
32 VDDMIC-supply:
36 VDDIO-supply:
[all …]
Dqcom,pm8916-wcd-analog-codec.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/sound/qcom,pm8916-wcd-analog-codec.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Konrad Dybcio <konradybcio@kernel.org>
17 const: qcom,pm8916-wcd-analog-codec
25 interrupt-names:
27 - const: cdc_spk_cnp_int
28 - const: cdc_spk_clip_int
29 - const: cdc_spk_ocp_int
[all …]