Home
last modified time | relevance | path

Searched +full:micro +full:- +full:volts (Results 1 – 8 of 8) sorted by relevance

/Documentation/devicetree/bindings/power/supply/
Dbq25980.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Andrew Davis <afd@ti.com>
15 for use in high-power density portable electronics. These inductorless
20 - $ref: power-supply.yaml#
25 - ti,bq25980
26 - ti,bq25975
27 - ti,bq25960
32 ti,watchdog-timeout-ms:
[all …]
/Documentation/devicetree/bindings/hwmon/
Dlltc,ltc4286.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Delphine CC Chiu <Delphine_CC_Chiu@Wiwynn.com>
15 - lltc,ltc4286
16 - lltc,ltc4287
21 adi,vrange-low-enable:
24 voltage range is 25.6 volts or 102.4 volts for this chip.
25 The default is 102.4 volts.
29 - compatible
[all …]
Dntc-thermistor.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
2 ---
3 $id: http://devicetree.org/schemas/hwmon/ntc-thermistor.yaml#
4 $schema: http://devicetree.org/meta-schemas/core.yaml#
9 - Linus Walleij <linus.walleij@linaro.org>
13 vary in resistance in an often non-linear way in relation to temperature.
16 temperature is non-linear, software drivers most often need to use a look
20 pull-up resistor or/and a pull-down resistor and a fixed voltage like this:
22 + e.g. 5V = pull-up voltage (puv)
24 +-+
[all …]
/Documentation/devicetree/bindings/opp/
Dti,omap-opp-supply.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/opp/ti,omap-opp-supply.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 registers, which contain OPP-specific voltage information tailored
16 Also, some supplies may have an associated vbb-supply, an Adaptive
18 w.r.t the vdd-supply and clk when making an OPP transition. By
20 transitions, we can use the multi-regulator support implemented by
22 OPP core binding Documentation/devicetree/bindings/opp/opp-v2.yaml
27 - Nishanth Menon <nm@ti.com>
[all …]
/Documentation/devicetree/bindings/clock/
Dnvidia,tegra124-dfll.txt4 Documentation/devicetree/bindings/clock/clock-bindings.txt
7 the fast CPU cluster. It consists of a free-running voltage controlled
10 communicating with an off-chip PMIC either via an I2C bus or via PWM signals.
13 - compatible : should be one of:
14 - "nvidia,tegra124-dfll": for Tegra124
15 - "nvidia,tegra210-dfll": for Tegra210
16 - reg : Defines the following set of registers, in the order listed:
17 - registers for the DFLL control logic.
18 - registers for the I2C output logic.
19 - registers for the integrated I2C master controller.
[all …]
/Documentation/devicetree/bindings/media/i2c/
Dmaxim,max9286.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Jacopo Mondi <jacopo+renesas@jmondi.org>
12 - Kieran Bingham <kieran.bingham+renesas@ideasonboard.com>
13 - Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
14 - Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se>
18 Serial Links (GMSL) and outputs them on a CSI-2 D-PHY port using up to 4 data
28 '#address-cells':
31 '#size-cells':
[all …]
/Documentation/devicetree/bindings/iio/afe/
Dtemperature-transducer.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/iio/afe/temperature-transducer.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Liam Beguin <liambeguin@gmail.com>
19 When an io-channel measures the output voltage of a temperature analog front
35 -----
37 +---+---+
39 +---+---+ -----
41 V proportional to T +----+----+
[all …]
/Documentation/hwmon/
Daquacomputer_d5next.rst1 .. SPDX-License-Identifier: GPL-2.0-or-later
3 Kernel driver aquacomputer-d5next
25 -----------
37 available through debugfs are the serial number, firmware version and power-on
39 temperature curves directly from the pump. If it's not connected, the fan-related
65 filled with coolant. Pump RPM and flow can be set to enhance on-device calculations,
87 -----------
93 -------------
96 temp[1-20]_input Physical/virtual temperature sensors (in millidegrees Celsius)
97 temp[1-8]_offset Temperature sensor correction offset (in millidegrees Celsius)
[all …]