Searched full:mid (Results 1 – 25 of 43) sorted by relevance
12
| /Documentation/devicetree/bindings/sound/ |
| D | renesas,rz-ssi.yaml | 62 The second cell specifies the encoded MID/RID values of the SSI port
65 bits[0:9] - Specifies MID/RID value of a SSI channel as below
66 MID/RID value of SSI rx0 = 0x256
67 MID/RID value of SSI tx0 = 0x255
68 MID/RID value of SSI rx1 = 0x25a
69 MID/RID value of SSI tx1 = 0x259
70 MID/RID value of SSI rt2 = 0x25f
71 MID/RID value of SSI rx3 = 0x262
72 MID/RID value of SSI tx3 = 0x261
|
| D | ti,tas5086.txt | 23 - ti,mid-z-channel-X: Boolean properties, X being a number from 1 to 6.
24 If given, channel X will start with the Mid-Z start
29 power stages are compatible to Mid-Z - please refer
|
| /Documentation/scsi/ |
| D | scsi_mid_low_api.rst | 9 This document outlines the interface between the Linux SCSI mid level and
37 The SCSI mid level isolates an LLD from other layers such as the SCSI
49 documented in Documentation/scsi (e.g. aic7xxx.rst). The SCSI mid-level is
90 a) directly invoking functions supplied by the mid level
92 supplied by the mid level. The mid level will then invoke these
96 by the mid level
98 Those functions in group a) are listed in a section entitled "Mid level
112 that are shared with the mid level and other layers.
131 with the SCSI mid level.
137 registered with sysfs at this point. The SCSI mid level first becomes
[all …]
|
| D | scsi.rst | 18 The scsi-core (also known as the "mid level") contains the core of SCSI
|
| D | lpfc.rst | 39 errored by the driver, the mid-layer would exhaust its retries, and the
|
| D | smartpqi.rst | 39 devices and notify the SCSI mid-layer of any changes detected.
|
| D | ChangeLog.arcmsr | 63 ** the arcmsr driver w/o passing through scsi mid layer
|
| /Documentation/devicetree/bindings/dma/ |
| D | renesas,rz-dmac.yaml | 66 The cell specifies the encoded MID/RID values of the DMAC port
69 bits[0:9] - Specifies MID/RID value
|
| D | renesas,rcar-dmac.yaml | 89 The cell specifies the MID/RID of the DMAC port connected to
|
| /Documentation/driver-api/ |
| D | scsi.rst | 37 The SCSI subsystem uses a three layer design, with upper, mid, and low
46 In between is the SCSI mid-layer, analogous to a network routing layer
47 such as the IPv4 stack. The SCSI mid-layer routes a packet based data
84 SCSI mid layer
215 mid to lowlevel SCSI driver interface
|
| /Documentation/usb/ |
| D | gadget-testing.rst | 383 There are two cases: playing a mid from the gadget to
384 the host and playing a mid from the host to the gadget.
386 1) Playing a mid from the gadget to the host:
394 $ arecordmidi -p 24:0 from_gadget.mid
402 $ aplaymidi -p 20:0 to_host.mid
404 2) Playing a mid from the host to the gadget
412 $ arecordmidi -p 20:0 from_host.mid
421 $ aplaymidi -p24:0 to_gadget.mid
423 The from_gadget.mid should sound identical to the to_host.mid.
425 The from_host.id should sound identical to the to_gadget.mid.
[all …]
|
| /Documentation/RCU/Design/Expedited-Grace-Periods/ |
| D | Expedited-Grace-Periods.rst | 459 Mid-boot operation
467 really do want to execute grace periods during this mid-boot “dead
473 drive the grace period during the mid-boot dead zone. Before mid-boot, a
474 synchronous grace period is a no-op. Some time after mid-boot,
478 normally during mid-boot. This is handled by causing non-expedited grace
479 periods to take the expedited code path during mid-boot.
482 mid-boot dead zone. However, if an overwhelming need for POSIX signals
485 pre-workqueue stall-warning checks, but only during the mid-boot dead
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-scsi_tape | 7 module and the SCSI mid-layer.
|
| /Documentation/devicetree/bindings/virtio/ |
| D | pci-iommu.yaml | 39 phys.mid phys.lo size.hi size.lo). phys.hi should contain the device's
|
| /Documentation/translations/zh_TW/admin-guide/mm/damon/ |
| D | usage.rst | 83 │ │ │ │ │ │ │ watermarks/metric,interval_us,high,mid,low
263 在水位目錄下，存在五個文件(``metric``, ``interval_us``,``high``, ``mid``, and ``low``)
332 # echo 500 > watermarks/mid
|
| /Documentation/translations/zh_CN/admin-guide/mm/damon/ |
| D | usage.rst | 83 │ │ │ │ │ │ │ watermarks/metric,interval_us,high,mid,low
263 在水位目录下，存在五个文件(``metric``, ``interval_us``,``high``, ``mid``, and ``low``)
332 # echo 500 > watermarks/mid
|
| /Documentation/devicetree/bindings/pci/ |
| D | pci.txt | 48 document, it is a five-cell address encoded as (phys.hi phys.mid
|
| /Documentation/devicetree/bindings/dma/stm32/ |
| D | st,stm32-dma3.yaml | 63 0x1: low priority, mid weight
|
| /Documentation/devicetree/bindings/net/dsa/ |
| D | vitesse,vsc73xx.yaml | 13 The Vitesse DSA Switches were produced in the early-to-mid 2000s.
|
| /Documentation/devicetree/bindings/iio/dac/ |
| D | adi,ltc2664.yaml | 58 hardware-configured with different mid-scale or zero-scale reset options.
|
| /Documentation/sound/soc/ |
| D | codec.rst | 157 /* vref/mid, clk and osc on, active */
|
| /Documentation/admin-guide/mm/damon/ |
| D | usage.rst | 90 │ │ │ │ │ │ │ :ref:`watermarks <sysfs_watermarks>`/metric,interval_us,high,mid,low
390 ``high``, ``mid``, and ``low``) for setting the metric, the time interval
542 # echo 500 > watermarks/mid
803 scheme is deactivated. If the value is lower than ``<mid mark>``, the scheme
|
| /Documentation/firmware-guide/acpi/ |
| D | osi.rst | 163 from mid-2015 onward. The ACPI specification will also be updated
|
| /Documentation/driver-api/soundwire/ |
| D | summary.rst | 208 MIPI Alliance Manufacturer ID Page: mid.mipi.org
|
| /Documentation/sound/cards/ |
| D | hdspm.rst | 76 ALSA-mid-level functions (here the buffer-ID gives a better
|
12